- 更多网络例句与过载电流相关的网络例句 [注：此内容来源于网络，仅供参考]
-
In the power supply circuit, series power supply and the adjustment of the series load, the load current flows through all of the adjustments, and transistors Guozainaili worse, once output overload or short circuit, the input voltage increases in the full set of adjustment an emitter, the current surge to adjust the fierce heat, if not over-current protection measures at this time, the adjustment will be burned, power Zhengliuguan also will be greatly threatened or damaged.
中文摘要：在稳压电源电路中，串联型稳压电源的调整管与负载串联，负载电流全部流经调整管，而晶体管的过载能力较差，一旦输出端过载或短路，输入电压全部加在调整管集---射极间，其电流剧增，使调整管猛烈发热，如果此时没有过流保护措施，调整管就要被烧坏，电源整流管也将受到巨大威胁或损坏。
-
It is the minimum overdrive current required to switch the input from one state to another.
它是最小过载电流必须从一个状态转换到另一个的输入。
-
Built on breakthrough technology from Holland(refer to the manual for details)and featuring a computerized control system as well as triple protective device,our product is next to none in quality.
"精致三面翻"以荷兰高新技术为依托，其特有的技术特点，微电脑智能控制系统和三重安全保护装置（三棱柱弹性保护、传动轴扭力过载保护、电机电流过载保护）在产品质量上独占鳌头。
-
Unfortunately, there is inevitably difference in characteristics of the induction motors and converters in a parallel AC drive system, therefore each induction motor as well as converter can not operate at the same working point, some may be overload, some underload.
并联着的各个交流调速系统的负载是不均衡的，这是因为逆变器所带的负载—异步电动机参数及特性不可避免地存在差异，两或多台逆变器作为电源，其等效参数也很难一致，各驱动轮径总存在偏差，因此各台逆变器的输出电流和各台异步电动机的定子电流是不相一致的，有的逆变器、异步电动机可能过载，有的还可能欠载。
-
It offers a 48 VDC redundant power input design and is secured with a double protection mechanism; Power Polarity Reverse and an Overload Current Resettable Fuse.
它提供了一个48伏直流冗余电源输入设计，配备了双重保护机制：电源极性反转和过载电流自恢复保险丝。
-
Characteristics: Electrode antiseize function Computer automatically delay the unaspirated HF / touch igniting function W-automatic function Xiaoqiu From the Arc / pit filled arc current adjustable Overheating instructions, overload protection, a thermostatically controlled fan, the self-inspection failure Welder software upgrade Technical parameters: Equipped with closed-loop water-cooling system Welding current: 3 - 400 amperes Voltage: 10.1 - 22.0 V
特性： 电极防粘功能电脑自动延缓送气高频/接触引弧功能钨针自动削球功能起弧/填弧坑电流可调过热指示，过载保护，温控风扇，故障自检焊机软件升级技术参数：配备闭环式水冷却系统焊接电流： 3 -- 400安培工作电压： 10.1 -- 22.0 V
-
The following functions can be realized: Measuerment:the effective values of three phase current and voltage, power frequency, active power, reactive power, power factor etc. Motor control: direct starting, converse starting, star and triangle starting, self-starting. Protection:thermal overload protection, current leakage protection, open-phase protection, three-phase unbalance protection, over voltage protection, loss voltage protection, low load protection and fault warning and fault dates memory. Communication: communication of the computer in control room and the microcomputer monitor in the spots is realized by the interface of RS-485. The motor is not only controlled in the spots but also in control room. The dates, information and some functions are shared by the spots and control room too.
该电动机监控器以80C196KC单片机为核心，通过采样三相电流﹑电压信号来实现以下功能：三相电流﹑电压有效值，电网频率，有功功率，无功功率及功率因数等的测量；对电动机实现直接、正反转、星三角及自起动控制；对电动机实现热过载、漏电、断相、三相不平衡、过压、欠压及轻载保护，对故障进行报警及数据记忆；通过RS-485串行接口与中央控制室计算机实现通信功能，对电动机既可本地，也可远程控制；实现控制现场与控制室之间数据、信息、功能共享。
-
This series of residual current circuit breaker is the residual current—operated electronic circuit breaker,composed of zero—sequence current transformer,electronic control leakage release and DZ20 type circuit breaker with overload and shod—circuit protection.
本系列断路器电流动作型电子式漏电断路器，主要由零序电流互感器、电子控制漏电脱扣器及带有过载和短路保护的DZ20型断路器组成。
-
STR _ FLT Starter Overload Trip : Check amps calibration / reset overload.
STR _ FLT 启动柜过载动作：检查电流标定/复位过载。
-
CJX2－d Series AC contactor is mainly used in the ciruit AC 50HZ (or-60HZ),rated insulating voltage is 380V unde AC-3 usage it can be combined with suitable thermal overload equipment into a electromagnetic starter to protect the circuit that may appear overload The comactor can be equipped with builbing block style auxiliary con tact group、air delaying contact、Interlonking mechanism and so on ac cessories to combined into time relay、reversible comtactor and star-delta starter.
CJX2-d系列交流接触器主要用于交流50HZ（或60Hz，额定绝缘电压为660V，在AC-3使用类别下额定工作电压为380V时额定工作电流至95A的电器中，供远距离接通和分断电器，并可与适当的热过载电器组成电磁起动器以保护可能发生过载负荷的电路。接触器可组装积木式辅助触头组、空气延时头、联锁机构等附件；组成延时继电器、可逆接触器、星三角起动器。
- 更多网络解释与过载电流相关的网络解释 [注：此内容来源于网络，仅供参考]
-
overcurrent：过电流
37.过电流(overcurrent)大于额定电流的电流,例如过载电流、短路电流. 41.装置的隔离(isolation of an installation)为保证电气装置维修时的安全,将电气装置或部分电气装置与电源隔离,即将电源回路的所有带电导体(包括中性线,
-
overcurrent：过量电流,过载电流
overcome 克服,制胜 | overcurrent 过量电流,过载电流 | overdose 过(剂)量
-
overcurrent：过载电流
overcomplexity 超集成度 | overcurrent 过载电流 | overdeveloping 显影过度
-
overcurrent release：过电流脱扣器,过流释放
"overcurrent relay ","过电流继电器,过载继电器" | "overcurrent release ","过电流脱扣器,过流释放" | "overcurrent trip ","过电流跳脱"
-
overload relay：过载继电器
利用电磁接触器加装过载继电器(Overload Relay)或积热继电器(Thermal Relay)此为限制电流大小方向著手,当马达过载时所产生的热量使得保护继电器作动,而使接触器跳脱,而达到保护之功用,一般选用110%~125%压缩机马达过载电流跳脱
-
source current：源电流
高边场效应管的逐周期电流限制,能在过载情况下保护器件不受损害;而用以防止电流失控的低边源电流(source current)限制,又增强了高边场效应管的逐周期电流限制.
-
overcorrect：过载电流
10.deterioration 恶化;磨损,损耗 | 11.overcorrect 过载电流 | 12.fuse 熔丝
-
fault current：故障电流
36.故障电流(fault current)因绝缘损坏而流经故障点的电流. 例如电气设备相线绝缘损坏,自相线经故障点通过PE线返回电源的电流. 37.过电流(overcurrent)大于额定电流的电流,例如过载电流、短路电流.
-
reverse overcurrent relay：逆过电流继电器,反向过载继电器
reverse osmosis treatment ==> 反渗透处理 | reverse overcurrent relay ==> 逆过电流继电器,反向过载继电器 | reverse-phase ==> 反相
-
current overload relay：电流过载继电器
current multiplication type transistor 电流倍增型晶体管 | current overload relay 电流过载继电器 | current probe amplifier 电流探头放大器