- 更多网络例句与边缘接头相关的网络例句 [注：此内容来源于网络，仅供参考]
-
Reducing bond temperature and diminishing bond time are in favor of the mollification of interface stresses.
分析表明，对接头有害的较大的残余应力区域分布在膨胀系数较小母材靠近焊缝附近的地带，而残余应力的最大值出现在其界面脆性相及焊缝附近靠近接头边缘的微小区域，降低连接温度、减少连接时间有利于减小接头残余应力，优化接头的界面应力状态。
-
For beams employed in any span between supports there shall be no splice in the middle one-fourth of the span nor in the one-eighth of the span nearest any support, nor closer than 1200 mm to the edge of any support/joint, as applicable.
在任何支撑点的跨距内使用的梁，在跨距中间的四分之一位置上，不得有拼接口，在靠近支撑的八分之一跨距位置上，不得有拼接口。在应用上，接口与支撑/接头边缘的距离不得小于
-
When the elastic modulus is high, stress and strain are mainly concentrated at edge of the overlap region, while those in weld spot zone are relatively even; when the elastic modulus is low, stresses in the adhesive layer are small while stresses are concentrated to a certain extent at edge of the weld spot.
分析发现，胶粘剂弹性模量对接头中应力应变分布的趋势有明显影响，胶粘剂弹性模量高时，搭接区边缘附近区域应力应变高，焊点区应力应变值相对较小；弹性模量低时，焊点边缘处存在一定的应力集中，胶层中应力较小。
-
Results show that when improving spot pitch in weld bonded joints with high elastic modulus adhesives, stresses in weld spot zone are decreased while stresses and strains at edges of overlap region are increased slightly. For the joints with low elastic modulus adhesives, both stress concentration degree at the weld spot and the shear strain at edges of overlap region are increased with the spot pitch increasing.
结果表明，高弹性模量胶粘剂胶焊接头中，增大焊点间距，焊点区应力减小而搭接区边缘胶层中的应力应变略有增大；低弹性模量胶粘剂胶焊接头中，焊点处应力集中程度和搭接区边缘胶层中的剪应变值都随焊点间距的增加而增大，增加焊点间距，两种接头的胶层断裂强度都将降低。
- 更多网络解释与边缘接头相关的网络解释 [注：此内容来源于网络，仅供参考]
-
edge connectable：带插接边的
edge conditions 边界条件 | edge connectable 带插接边的 | edge connector 印刷板插头,印制板插头,边缘插接件,边缘接头,边缘连接器
-
dose：(輻射)吸收劑量
格雷符号Gy,推导而来的电离辐射吸收剂量(dose)的标准国际单位(参见 radiation units). 这是以英国放射生物学家L.H.格雷(1905-1965年)的名字命名的. 装在双万向接头(gimbal)上边缘很重的圆盘,因此它的轴可在空间中任意定向.
-
gimbal：万向接头
这是以英国放射生物学家 L.H.格雷(1905-装在双万向接头(gimbal)上边缘很重的圆盘,因此它的轴可在空间中 任意定向. 当圆盘自旋时,整个装置有两种有用的特性:(1)陀螺仪惯性,即轴的自旋方向会对抗改变,以致若转动万向接头,
-
edge imperfections：板边缺陷,边缘缺陷
edge effect 边缘效应 | edge imperfections 板边缺陷,边缘缺陷 | edge joint 端接接头
-
joggle joint：啮合榫接头
腻子wood putty | 啮合榫接头joggle joint | 拼花边缘parquet border
-
duplex spot weld：双点点焊接头
downhand weld平焊缝 | duplex spot weld双点点焊接头 | edge joint weld边缘焊
-
edge joint：边缘连接;卷边接头;边缘焊接头
edge gradient 边缘梯度 | edge joint 边缘连接;卷边接头;边缘焊接头 | edge lease 油气田边缘租地
-
edge joint weld：边缘焊
duplex spot weld双点点焊接头 | edge joint weld边缘焊 | edge weld端接焊; 端接焊缝; 端面焊缝; 对边焊