- 更多网络例句与输入电阻相关的网络例句 [注：此内容来源于网络，仅供参考]
-
Main technical specification and inspection condition: Main sound track output≥10W, Input resistance≥47KΩ, Frequency20Hz～20KHz, Load resistance8Ω, Total wave distortion≤1%, Ultra bass channel output≥20W, Frequency≤100Hz,uses the transistor and giving up field effect tube and electron tube and reduction transistor and so on carries on the discussion.
其主要技术指标及考核条件为：主声道的输出功率≥10W，输入电阻≥47KΩ，频率响应20Hz～20KHz，负载电阻8Ω，总波失真≤1%，超低音通道输出功率≥20W，频率响应≤100Hz，，同时采用全晶体管的设计。
-
If the feedback resistance, RF, equals 2RIN, where RIN is the input resistance, the closed-loop gain of each channel is –2V/V.
如果反馈电阻RF等于2RIN，其中RIN为输入电阻，各通道的闭环增益为–2V/V。
-
Parameter RESOLUTION Offset Error Gain Error Differential Nonlinearity Integral Nonlinearity TEMPERATURE DRIFT Offset Error Gain Error POWER SUPPLY REJECTION RATIO ANALOG INPUTS1 Differential Input Voltage Range Differential Input Resistance Differential Input Capacitance Input Bandwidth VSWR 2 POWER SUPPLY 3 Supply Current IAVCC (AVCC = 5.0 V) IEVCC (EVCC = 3.3 V) IVDD (VDD = 3.3 V) Total Power Dissipation 4
参数解决方案偏移误差增益误差微分非线性积分非线性温度漂移偏移误差增益误差电源抑制比1模拟输入；差分输入电压范围差分输入电阻电容输入带宽差分输入电压驻波比2电源3电源电流IAVCC（AVCC = 5.0五）IEVCC（EVCC = 3.3伏） IVDD（VDD的= 3.3伏）总功率耗散4
-
Measurements from voltage sources with high internal resistance are subject to a number of errors, such as loading errors from the voltmeter's input resistance and input bias current, as well as from external shunt resistance and capacitance.
对高源内阻电压源的测量容易产生几种误差，诸如：电压表输入电阻和输入偏置电流以及外部分流电阻和电容引起的负载误差。
-
The input offset voltage is fixed for a particular amplifier, however the contribution due to input bias current is dependent on the circuit configuration used. For minimum offset voltage at the amplifier input without circuit adjustment the source resistance for both inputs should be equal.
对于一个给定的OP，输入失调电压就已经给定了，但是由输入失调电流所带来的失调电压与所采用的电路结构有关系为了减小输入偏置电流所带来的失调电压，应该使得使得同、反相输入端对地的直流电阻相等，使得由于偏置电流在输入电阻上压降所带来的失调电压相互抵消。
-
Given that V2 is applied to the amplifier input lead, the high input resistance of the operational amplifier is the only load on V2, and the only current drawn from the source is the very low input offset current of the operational amplifier.
若V2加到放大器的输入端，运算放大器的高输入电阻成为V2的唯一负载，而且唯一从源吸取的电流是运算放大器非常低的输入偏置电流。
-
As the operational amplifier gain and high input resistance, low output resistance, they are able to provide some cushioning effect and the signal gain.
由于运算放大器的增益高和输入电阻高、输出电阻低的特性，所以能起到一定的信号增益和缓冲作用。
-
If we assume that the meter has infinite input resistance, the measured resistance is then computed from Ohm's Law
如果我们假定电压表的输入电阻为无限大，则可以由欧姆定律计算出被测电阻
-
As in the case of input resistance voltage loading, the shunt resistance and the source resistance form a voltage divider that reduces the measured voltage as follows
和输入电阻的电压负载作用一样，分流电阻和源电阻也形成了一个分压器，并将测量的电压衰减如下
-
The signal amplifier should have features like low noise signal, zero drift, high precision, wide frequency band, high input resistance, and low output resistance.
信号放大器应该有特点，例如低噪声信号，零点漂移小，精度高，宽的频带，高输入电阻，低输出电阻。
- 更多网络解释与输入电阻相关的网络解释 [注：此内容来源于网络，仅供参考]
-
input power control：输入电源控制
input power 输入功率 | input power control 输入电源控制 | input resistance 输入电阻
-
input resistance：输入电阻
力值、硬度计量名词术语及定义八3.46 输入电阻(input resistance) 在标准试验条件下,在无负荷和输出端开路时,由输入端测出的传感器电路的电阻. 3.47 输出电阻(output resistance) 在标准试验条件下,在无负荷和输入端开路时,
-
input resistance：输入电阻输入阻抗
input resistance 输入电阻 | input resistance 输入电阻输入阻抗 | input resistance 输入阻抗
-
negative input resistance：负输入电阻
负阻抗变换器 negative impedance converter; NIC | 负输入电阻 negative input resistance | 负离子;阴离子 negative ion
-
antenna input resistance：天线输入电阻
"antenna impedance","天线阻抗" | "antenna input resistance","天线输入电阻" | "antenna insulator","天线绝缘器"
-
effective input resistance：有效输入电阻
effective input capacitance 有效输入电容 | effective input resistance 有效输入电阻 | effective instruction 有効命令
-
input resistance impedance：输入电阻阻抗
输入请求 input request | 输入电阻阻抗 input resistance impedance | 输入电阻器 input resistor
-
input routine：输入程序
input resistance 输入电阻 | input routine 输入程序 | input selector 输入选择器
-
input routine：输入例程
输入电阻 input resistance | 输入例程 input routine | 输入片段空间 input segment space
-
RES：电阻
由于在高频的情况下,滤波电容等效由纯电容(C)、等效串联电阻(RES) 和等效串联电感(LES)构成的串联电路. 在工作频率f超过电容器的自谐振频率fr时,电容器就起到电感的作用. 内建电压补偿电路可在一个较大的AC输入范围内实现功率限制控制,