- 更多网络例句与轮闸相关的网络例句 [注：此内容来源于网络，仅供参考]
-
When power is transmitted to the elevator shaft, it drives the splined center wheel and the planetary mechanism which consists of three planetary wheels forming 120 degrees with each other and the inner gears drives the drum to rotate, the hoisting band brake is combined with the hoisting disc, and the drum's left ring is combined with the braking band brake, then the elevator has three status: hoisting, braking, and lowering down.
当动力传至升降机轴后，轴带动与花键联接的中心轮，三个互成120度的行心轮及内齿圈组成的行星机构，使卷筒回转，提升抱闸与提升盘结合，卷筒左端外圈与制动抱闸结合，这样升降机具有提升、制动、下降三种工作状态。
-
Small moment: As the damper plate weight is light, the damper plate and the guide rail and the rubber packing friction drag is small, therefore causes the hand wheel operation moment of force will be small
力矩小：由于闸板重量轻，闸板与导轨及橡胶密封条的摩擦阻力小，故使得手轮操作力矩小
-
Moments of force are small: Because the damper plate weight is light, the damper plate and the guide rail and the rubber packing friction drag is small, therefore causes the handwheel operation moment of force to be small
力矩小：由于闸板重量轻，闸板与导轨及橡胶密封条的摩擦阻力小，故使得手轮操作力矩小
-
Valve:(dark-parallel) 1 - wedge-shaped gate valve; 2 - sleeve nut; 3 - Valve; 4 - stem; 5 - valve cover; 6 - Thrust Convex shoulder; 7 - Packing letter flange; 8 - packing; 9 - Packing Gland, 10 - hand wheel; 11 - valve cover pad.
闸阀：1--楔形闸瓣；2--套筒螺母；3--阀体；4--阀杆；5--阀盖；6--止推凸肩；7--填料函法兰；8--填料；9—填料压盖；10--手轮；11--阀盖垫。
-
If individually controlled wheel b rakes are provided to assist in steering, the brake control shall meet one of the following requirements
如果用个人控制的轮闸在操作中进行协助时，那末刹车控制器应满足以下条件之一。
-
HVAC piping design with valve selection 1, chiller plant, cooling water between inlet valve design; 2, before the butterfly pumps, filters, pumps after the check valve, butterfly valve; 3, sets, water separator pressure differential between the bypass valve; 4, set, divider into the returning pipe valve 5, the level of dry pipe valve; 6, valve air handling units, filters, electric two-pass or three-way valve 7, fan coil valve (or plus electric two-way valve) Note: The valve is typically used when the diameter is less than 150mm used Handle Butterfly Valve (D71X, D41X); diameter greater than 150mm used worm drive butterfly (D371X, D341X).
暖通空调管道用阀门的选型设计 1、冷冻水机组、冷却水进出口设计蝶阀； 2、水泵前蝶阀、过滤器，闸门水泵后止回阀、蝶阀； 3、集、分水器之间压差旁通阀； 4、集、分水器进、回水管蝶阀 5、水平干管蝶阀； 6、空气处理机组闸阀、过滤器、电动二通或三通阀 7、风机盘管闸阀注：一般采用蝶阀时，口径小于150mm时采用手柄式蝶阀（D71X、D41X）；口径大于150mm时采用蜗轮传动式蝶阀（D371X、D341X）。
-
It is mainly made up of frame, gate board, screw pole, nut etc. rotate the handwheel by hand, then the screw pole drives the nut and gate board move in horizontal to and fro to open or close the valve.
螺旋闸门工作原理 working principle 主要由框架、闸板、丝杆、螺母等零件构成，用手转动手轮使丝杆带着丝杆螺母和闸板沿水平方向往复运动，达到闸门的启闭目的。
-
It is mainly made up of frame, gate board, screw pole, nut etc. Rotate the hwheel by h, then the screw pole drives the nut gate board move in horizontal to fro to open or close the valve.
主要由框架、闸板、丝杆、螺母等零件构成，用手转动手轮使丝杆带着丝杆螺母和闸板沿水平方向往复运动，达到闸门的启闭目的。
-
It is mainly made up of frame, gate board, screw pole, nut etc. Rotate the handwheel by hand, then the screw pole drives the nutgate board move in horizontal tofro to open or close the valve.
主要由框架、闸板、丝杆、螺母等零件构成，用手转动手轮使丝杆带着丝杆螺母和闸板沿水平方向往复运动，达到闸门的启闭目的。
-
Ordos block ; Seismicity trend ; Qinghai Tibet Plateau ; Wheel and Gate Model
鄂尔多斯地块；地震活动趋势；青藏块体；轮闸模型
- 更多网络解释与轮闸相关的网络解释 [注：此内容来源于网络，仅供参考]
-
Brake drum lathe：闸鼓车床
brake drum inspection hole cover | 闸轮检查孔盖 | brake drum lathe | 闸鼓车床 | brake dynamometer | 轮韧测力计, 轮韧功率计, 制动测力计
-
driving wheel：织轮
driving torque驱动转矩 | driving wheel织轮 | driving wheel brake织轮闸
-
driving wheel brake：织轮闸
driving wheel织轮 | driving wheel brake织轮闸 | drone无人驾驶飞机
-
driving wheel brake：主动轮闸
driving stem 驱动杆 | driving wheel brake 主动轮闸 | driving wheel 主动轮
-
driving wheel brake：织轮闸, 驱动轮制动器
driving wheel 织轮 | driving wheel brake 织轮闸, 驱动轮制动器 | drone 无人驾驶飞机
-
ratchet wheel：棘轮,闸轮,爪轮
ratchet washer 棘齿垫圈 | ratchet wheel 棘轮,闸轮,爪轮 | ratchet wheel pawl bracket 棘轮爪托
-
hub brake：轮闸
STEM 把立 | HUB BRAKE 轮闸 | MUDGUARD 挡泥板
-
NUT,DOUBLE WHEEL STOP,RH：双轮闸
NUT,RR AXE BEARING LOCK 轴承 | NUT,DOUBLE WHEEL STOP,RH 双轮闸 | PIN,SLOTTED SPRING 插销
-
NUT,DOUBLE WHEEL STOP,LH：双轮闸
SEAL,TYPE S OIL 密封圈 | NUT,DOUBLE WHEEL STOP,LH 双轮闸 | SPRING,TORSION 弹簧
-
tail wheel：尾轮
"键)飞机尾轮(Tail Wheel),放开轮闸. 要想安全迅速的飞上天空,必须找到合适的跑道,当找到合适的跑到时,再次锁定尾轮,然后平稳的使用油门增加动力(再次推荐使用使用最高转速(RPM)值). 准备好使用方向舵或轮闸来控制方向和平衡发动机和螺旋桨的扭力.