- 更多网络例句与误差平均值相关的网络例句 [注：此内容来源于网络，仅供参考]
-
Moreover,thc rationality about calculating tolerance unit by using the grometrical average is discusscd in comparison with relative reeor by using the midline value which is in a basis diameter step.
本文给出了几何平均值与算术平均值最大相对误差关系的证明，并通过对尺寸分段内按中线值的相对误差的比较，进一步论述了按几何平均值计算公差单位的合理性。
-
Error reduction can be achieved by improving the precision of flow meter, thermometer, water cut meter and densimeter,by reducing sample oil's deviation,and by correcting flow met...
要减少油量计量误差，就必须提高流量计、温度计、含水仪、密度计等仪表的准确度，减少所取油样的密度与含水率在某段计量时间内的非代表性平均值所引起的误差，用流量计系数来修正流量计的示值。
-
With the evaluation, each group measuring value is considered as a single subsystem, and the minmax-difference, mean difference and the mean square value of each group are calculated. Then, the ratio of the mean difference to the measurement mean value is defined as the system-relatively error of subsystem and the ratio of the minmax difference to the measurement mean value is defined as the accidence-relatively error of the subsystem.
以每组为一个子系统，分别计算出每组的极差、平均差和标准差，然后定义平均差和测量平均值的比值为子系统的系统相对误差，定义极差和测量平均值的比值为子系统的偶然相对误差。
-
The error is described by weighted average variance-covariance of root mean square error in curve normal direction, and error in the direction with maximum error respectively.
曲线上任意点的误差由端点及距离误差传播导出的误差之加权平均值的协方差表示。
-
The distribution taw of K_ values as random variables is examined separately fortwo materials of 43 specimens of aluminum alloy Lc 4 and 30 specimens of alloy steel 30CrMnSiNi2A.
利用统计理论估计出取得在90%的置信度下与真值误差小于5%的K_平均值所需试样数约为4—6。指出在每组K_试验中用最少试样取得满足上述要求的K_平均值的具体方法。
-
The distance of coded points or uncoded points was calculated with several groups of photographs taken by a camera with software XJTUDP, and then their average value was acquired.
通过相机拍摄多组照片，在XJTUDP软件下计算相同条件的编码点或非编码点之间的距离，得出其平均值，将测得的每组单个数值减去平均值，可获得每次测量的个体误差。
-
The relationship between the tracking error and those auxiliary errors is clearly established when plant relative degree is greater than one and therefore, it can be proved that the influence of averaging filters on a VS-MRAC system can be considered as, in a sense, an unmodelled dynamics. As a result of this, it is shown that the stability analysis of a signal synthesis based VS-MRAC system must be modified to include the 'unmodelled dynamics'.
当对象建模部分相对阶大于1时，得到了系统跟踪误差和辅助误差间明确的关系表达式，进而证明平均值滤波器对系统的影响相当于未建模动态对系统的影响，这表明以往相关文献关于系统稳定性的分析是有缺陷的，没有将平均值滤波器对系统稳定性的影响完全考虑在内； 3。
-
Through field measurement for the contact pressure of box foundation with Ⅰ shaped plane of a high rise building on cobble subsoil, the distribution law of the contact pressure has been diagrammed. At the same time, the contact pressure has been calculated with finite compression layer model, which is well accordant with the measured result. The relative error of average value for the measured to the calculated contact pressure is 6.9%. This shows that the numerical calculation is right.
通过对西南交通大学某教学楼箱形基础基底反力的实测结果，得出了&Ⅰ&形平面箱基置于密实卵石层上的基底反力分布规律，又用有限压缩层地基模型对该箱基反力进行了计算，结果表明：实测反力与计算反力分布规律一致，实测反力平均值与计算反力平均值相对误差为6.9％，也说明此法计算箱基反力是可行的。
-
The experiments were carried out to calibrate FDR in the lab and field, and calibration equations were verified by oven-dried method for soil samples obtained by augers. The result showed that good calibrating equations with average RMSE 0.023 m^3/m^3 were fitted in the lab, but they had poor RMSE 0.066 m^3/m^3 when used in the field. Other calibrating equations with average RMSE 0.026 m^3/m^3 were also fitted by indirect field calibration method, and they had good RMSE 0.026 m^3/m^3 when used in the field.
结果表明，室内试验获得了较好的模型参数，均方根误差平均达到了0.023 立方公尺/立方公尺，但是应用到田间条件下误差很大，均方根误差平均为0.066立方公尺/立方公尺；田间条件下也间接获得了较好的模型参数，均方根误差的平均值为0.026立方公尺/立方公尺，应用于田间时测定含水量的精确度较高，均方根误差的平均值为0.026立方公尺/立方公尺。
-
Finally, in additional to the comparison of results derived by PPP and DGPS, they were all compared to Anping tide gauge records as well. The aim of this study is the analysis of height variations provided by different methodologies. Comparing to Anping tide gauge records, the differences in height variations can achieve 4.5 cm with DGPS; 6 cm with final product; 10 cm with rapid product; 25 cm with ultra-rapid product; 1~2 m with ultra-rapid product.
实验中也搜集了安平潮位站的潮位资料，故也将此资料与GPS浮标高程方向定位成果进行比较，而研究中将著重於高程变化量之分析，假设潮位仪观测海水面高程变化量为参考解，由实验结果可发现差分相对定位椭球高变化量均方根误差之平均值约4.5公分；使用最终产品时椭球高变化量均方根误差之平均值可以达到6公分以内；使用快速产品时椭球高变化量均方根误差之平均值可以达到10公分以内；使用超快速产品观测部分於观测环境理想时椭球高变化量均方根误差之平均值可以达到25公分左右；使用超快速产品预估部分时椭球高变化量均方根误差之平均值约1~2公尺。
- 更多网络解释与误差平均值相关的网络解释 [注：此内容来源于网络，仅供参考]
-
mean absolute error：平均绝对误差
平均;平均值 mean | 平均绝对偏差 mean absolute deviation | 平均绝对误差 mean absolute error
-
computational error：极差 range 计算误差
几何平均值 geometrics mean | 极差 range 计算误差. computational error | 极值extremum value
-
error curve：误差曲线=>誤差曲線
error criterion 误差准则,误差判据=>誤差評価関数 | error curve 误差曲线=>誤差曲線 | error curve of mean 平均值的误差曲线
-
error curve of mean：平均值的误差曲线
error curve 误差曲线=>誤差曲線 | error curve of mean 平均值的误差曲线 | error deletion by interactive transmission 用交互传输法消除误差
-
mean square error：均方误差
一种语音音调参数的分类方法,以递归式计算平均值及均方误差(Mean Square Error)方式,分析所有音素的音调参数,以将音调参数分类,找出及建立具代表性的音调样本模型,藉由本发明所揭示的方法,运用于TTS(Text To Speech)或语音数据压缩,
-
mean：平均值
m(10um以下为0.1um) 探头连接方式 一体化 示值误差 一点校准(um) ±[3%H+1] 两点校准(um) ±[(1~3)%H+1] 测量条件 最小曲率半径(mm) 凸 1.5 凹9 基体最小面积的直径(mm) ф7 最小临界厚度(mm) 0.5 温湿度 0~40℃ 20%RH~90%RH 统计功能 平均值(MEAN)、最大值(MAX)
-
personal error：人员误差
人员误差(Personal error) 人员误差又称个人误差,是由于测定人员的分辨力, 误差 误差 因而可以采取让不同人员进行分析, 以平均值报告分析结果的方法予以限制.
-
population mean：族群平均值
若与将该调查的信赖水准(Confidence level)设定为95 %,依据P[(–2σ)μ(+2σ)] = 0.9544,必须使用两个标准误差的范围,则估算族群平均值(Population故,该消费金额调查推估族群平均值(Population mean)位於568.2~588.6元之间,达到95 %的信赖水准.
-
arithmetic weighted mean：算术加权平均值
arithmetic mean,算术平均值 | arithmetic weighted mean,算术加权平均值 | arm error,不等臂误差
-
arithmetic weighted mean：数学加权平均值
arithmetic mean 数学平均值 | arithmetic weighted mean 数学加权平均值 | arm error 不等于臂误差