英语人>词典>汉英 : 触器 的英文翻译,例句
触器 的英文翻译、例句

触器

基本解释 (translations)
tactor  ·  tentacule

更多网络例句与触器相关的网络例句 [注:此内容来源于网络,仅供参考]

A set of bits constituting the smallest unit of addressable memory.

与存储单元的触点相啮合的选择器滑动触点。

When medical instrument draft condition becomes poor and the internal temperature rises reaching the controlled temperature of bimetallic strip temperature control unit, the normally closed stationary contact and normally closed moving contact disconnect to make main circuit power interruption and instrument stopping work, at the same time normally closed moving contact and normal open stationary contact switching-on, indicating light working, prompting the medical instrument being stopped because of superheating.

当医用仪器通风条件变差,内部温度上升,达到双金属片温控器的控制温度时,常闭静触点和常闭动触点断开,主电路供电中断,仪器停止工作,同时常闭动触点与常开静触点接通,指示灯工作,提示医用仪器因过热而停机。

A Switch contacts that are an integral part of an equipment heater thermostatic contactor or similar device.

开关的触点是一个设备加热器温度调节器触点或类似设备的一个整体部分。

CJX2-d The operating mechanism is direct operation type ,the comtact has double comtas;Combinatiom function,exce pt the imstallation side,the rest of the sides can be added with auxiliary comtact group(F4-d) or interlocking mech anism; The head can be equipped with auxiliary contact group (F4-d)or (F4-d2) or air delaying comtact (sk2-2/3d);The coil wiring terminal can be connected with time delayer and so on function modules.

CJX2-d动作机构为直动式、触头为双断点;组合功能、除安装面外,其余各面均能加装附件;两侧可加装辅助触头组(F4-d)或联锁机构;上方可加装辅助触头组(F4-d)或(F4-d2)或空气延时头(SK2-2/3d);线圈接线端可加装时间延时器等各种功能模块

The main principle of the DCcontactor:The electromagnetism coil switches on electricity thetitle iron to match with the iron heart on,the suction of theelectromagnetism system overcomes the counterforce of the springarouses the action of the contact, the main electric circuitconnected;The electromagnetism coil cuts the power the counterforceof the spring arouses the title iron from move to open, the headcontact breaks to open the output electricity arc give or get anelectric shock in drive to arc-extinct-chamber and made longer,thestrong cooling dissociates and put out,the main electric circuitcuts off.

触器的主要原理:电磁线圈通电,衔铁和铁心吸合,电磁系统的吸力克服弹簧的反作用力带动动触头与静触头接触,主电路接通;电磁线圈断电,弹簧的反作用力带动衔铁和动触头弹开,触头断开产生的电弧在灭弧室中受到磁吹灭弧和电动力驱动被拉长,并强烈冷却去游离而熄灭,主电路切断。

The fEPSP response evoked in one pathway was small, usually 20–30% of the maximu, whereas a large response, usually 80–90% of the maximum, was evoked in the strong pathway. After recording of the baseline fEPSP evoked at 0.033 Hz, LTP of the weak pathway could be associatively induced by paired stimulation of the weak and strong pathways 100 times at 6 sec intervals, with stimulation of the weak pathway preceded 3–10 msec.

在记录以0.033Hz所引发基础的兴奋性突触后电位之后,在弱的路径上可以因配合弱与强的刺激路径而引发出相关性长期增益(每六秒一次共100次,弱的刺激路径在强的刺激路径之前 3-10 ms),然而当在两个路径之间的配合时间差大於10 ms时即无法形成相关性长期增益,此类型长期增益的引发是需要依赖活化NMDA接受器的,因为给予50 mM的D,L-AP5可以阻断相关性长期增益的引发(兴奋性突触后电位为原来的105±6﹪;n=6)。

Which explained "" overcurrent trip behavior: as the relay for other contacts are fine speed controller and current regulator of input and output signal both the normal value of zero growth of the original does not work contact for some reason (such as vibration, etc.) to work, all of a sudden phase-limiter had lifted the blockade and the output signal, so that the larger main motor Haar "" transflux arising from the trip.

由此也可注释呈现&功不源&跳闸本体的来因:由于该继电器的其他触不面均处事精良,速率调度器和电不源调度器的不不不不不不不输入、不不不不不不不输入暗记均呈变态的由不整到必不退值的落低,而本来不处事的触不面由于某种来因猝然又处事了,移相限制器便因撤废敞开而不不不不不不不输入较大暗记,使宾电机不不矮速启不静而呈现&功不源&跳闸本体。

In this work based on existing furrow opener, point data of furrow opener's surface were obtained with reverse engineering technique and 3D reconstruction was conducted with a software in order to attain computational model of furrowing opener surfaces.

在本工作中,第一步,在已有芯铧式开沟器的基础上,采用逆向工程技术,获得其触土面点云数据,应用点云处理软件对点云进行三维重构,得到开沟器触土面的计算机模型。

Low pressure area has brand: Shihlin low:÷system, hot shihlin overload relays, small circuit breakers, contact, Molded Case broken in, and motor starter, button switch, AC contactor.

士林低压:士林索制、士林热过载继电器、小型断路器、触头、塑壳断中器、电动机起动器、按钮开关、交流接触器

CJX2-d Series AC contactor is mainly used in the ciruit AC 50HZ (or-60HZ),rated insulating voltage is 380V unde AC-3 usage it can be combined with suitable thermal overload equipment into a electromagnetic starter to protect the circuit that may appear overload The comactor can be equipped with builbing block style auxiliary con tact group、air delaying contact、Interlonking mechanism and so on ac cessories to combined into time relay、reversible comtactor and star-delta starter.

CJX2-d系列交流接触器主要用于交流50HZ(或60Hz,额定绝缘电压为660V,在AC-3使用类别下额定工作电压为380V时额定工作电流至95A的电器中,供远距离接通和分断电器,并可与适当的热过载电器组成电磁起动器以保护可能发生过载负荷的电路。接触器可组装积木式辅助触头组、空气延时头、联锁机构等附件;组成延时继电器、可逆接触器、星三角起动器。

更多网络解释与触器相关的网络解释 [注:此内容来源于网络,仅供参考]

contactor:接触器

[size=5][size=3][/size][size=2]接触器触器(Contactor) 指工业电中利用线圈流过电流产生磁场,使触头闭合,以达到控制负载的电器. 接触器由电磁系统(铁心,静铁心,电磁线圈)触头系统(常开触头和常闭触头)和灭弧装置组成.

multifinger contactor:多触点接触器,多接点接触器

multifinger 多触点的 | multifinger contactor 多触点接触器,多接点接触器 | multifired power plant 多燃料电厂

tOuch-sensitive digitizer:触敏数字转换器

一触即离的 touch and go | 触敏数字转换器 touch sensitive digitizer | 接触式焊条 touch type electrode

faceplate starter:平触点起动器

faceplate controller 平触点控制器 | faceplate starter 平触点起动器 | faceplate 面板n.面板花盘

relay contact arrangement:继电器触点组合方式

relay contact 继电器触点=>継電器接点 | relay contact arrangement 继电器触点组合方式 | relay contact chatter 继电器触点震颤

sliding contact starter:滑触起动器

sliding clamp 滑动压板 | sliding contact starter 滑触起动器 | sliding contact 滑动接触滑动触点

tactor:触器

tactometer 触觉测量器,触觉计 | tactor 触器 | tagged 标记的

tentaculum:触器

tentacle触毛 | tentaculum触器 | tentativeconclusion暂时结论

TOF:(断电延时定时器)

12.断电延时定时器(TOF)在输入端(IN)______时开始定时,定时器当前值达到设定值时停止计时,定时器状态位______. 17.加计数器(CTU)的复位输入电路接通时,加计数器被复位,复位后其常开触点闭合,常闭触点断开.

contact making voltmeter:触点式伏特计

触点式温度计 contact-making thermometer | 触点式伏特计 contact-making voltmeter | 接触器,触头 contactor