- 更多网络例句与表面电阻率相关的网络例句 [注：此内容来源于网络，仅供参考]
-
This section details how to make surface and volume resistivity measurements with these test fixtures, as well as the Alternating Polarity and Alternating Voltage techniques for measuring resistivity.
本节详细介绍如何使用这些测试夹具来进行表面电阻率和体电阻率的测量，以及测量电阻率时使用的变换极性和变换电压的技术。
-
Volume and surface resistivity measurements are dependent on several factors.
体电阻率和表面电阻率的测量决定于几个因素。
-
5 Material type 材料类型 4.5.1 Antistatic Material: the material that used to prevent / inhibit the generation of the Triboelectric Charge; or the material that only generate less than 200V Triboelectric voltage; it has no requirement about surface resistivity and volume resistivity .
抗静电材料–能抑制摩擦生电的材料；摩擦电压在 200V 以下的材料；防静电材料没有表面电阻率或体积电阻率的要求。
-
TDE-85/DDS system is the suitable matrix for vapor as sisted resin transfer molding and the properties of GFRP equilibrium tube have e xceeded the technical-demands.
TDE-85/DDS体系完全符合VARTM工艺要求，其玻纤增强制品性能良好，马丁耐热为220℃，体积电阻率为2.4×108MΩm，表面电阻率为1.9×107MΩ。
-
In this bath, maleic acid was an inhibitor, when its concentration was kept at 20 mg/L, the deposition rate could reduce to 6.17μm/h, the content of nickel decreased to 1.74% and the resistivity was 7.51μΩ·cm; Potassium ferrocyanide inhibited deposition of copper, when its content was 0.5 ppm, the deposition rate decrease to 3.38μm/h, the content of nickel was 2.03%, the resistivity can reduced to 5.41μΩ·cm, the copper deposits also had higher (111) plane orientation. Thiourea was also an inhibitor in this system, when its concentration was kept at 0.8 ppm, the deposition rate was 4.72μm/h, the content of nickel in the film was 1.20%, the resistivity can reduced to 5.46μΩ·cm, at the same time, the deposition at (111) plane orientation become more favorable.
结果表明，马来酸在该体系中是抑制剂，当其浓度为20 mg/L时，镀速降为6.17μm/h，镀层镍含量降为1.74%，表面电阻率降为7.51μΩ·cm，铜层颗粒细小均匀，更有利于在(111)面上的结晶；亚铁氰化钾的加进可以明显降低镀，当其浓度为0.5 ppm时，镀速为3.38μm/h，镀层镍含量降为2.03%，表面电阻率降为5.41μΩ·cm，铜层颗粒细小均匀，(111)晶面衍射峰增强；硫脲在体系中也显示为抑制剂，当其浓度为0.8 ppm时，镀速降到4.72μm/h，镀层镍含量为1.20%，表面电阻率降为5.46μΩ·cm，形成的铜颗粒很小，同时(111)晶面衍射峰增强，有利于铜在(111)面上结晶。
-
Some of the applications that use this method include testing two terminal high resistance devices, measuring insulation resistance, and determining the volume and surface resistivity of insulating materials.
采用这种方法的应用工作包括测试两端高阻器件、测量绝缘电阻、确定绝缘材料的体电阻率和表面电阻率等。
-
Polyethylene has excellent volume resistivity and surface characteristics similar to polystyrene.
聚乙烯具有与聚苯乙烯类似的、极好的体电阻率和表面电阻率。
-
Humidity greatly affects the results of surface resistivity measurements and, to a lesser degree, volume resistivity measurements, as well.
湿度对表面电阻率测量有重大的影响，对体电阻率的测量也有影响，只是其程度要小一些。
-
However, because of ultra-high bulk resistivity and surface resistivity of PE and PP materials, the articles made of PP or PE have notorious static problem.
由于PE和PP具有极高的体积电阻率和表面电阻率而导致静电荷的积累，因此在使用中经常发生静电危害。
-
The results show that with the content of the synthetic compound increasing, the surface resistivity of PVC materials was decreased. When the content of the synthetic compound reached 4.5%, the surface resistivity of PVC materials was reduced below 3.0×108 ?.
结果表明：随合成长链季铵盐的添加量增大，PVC材料的表面电阻率降低，较小的添加量(4.5%)即可使材料的表面电阻率降低至3.0×108 Ω以下，达到了煤矿行业对高分子材料抗静电性能的要求。
- 更多网络解释与表面电阻率相关的网络解释 [注：此内容来源于网络，仅供参考]
-
surface resistivity：表面电阻
表面电阻(Surface Resistivity)又称表面电阻系数、表面比电阻或表面电阻率. 它是表征电介质或绝缘材料电性能的一个重要数据. 它代表了绝缘材料抵抗表面漏泄电流的能力. 其意义为每平方厘米电介质表面对正方形的相对二边间表面泄漏电流所产生的电阻.
-
surface resistivity：表面电阻率
Surface Mount Device 表面粘装组件. | Surface Resistivity表面电阻率. | Surface Speed钻针表面速度.
-
surface resistivity：表面电阻率[系数]
表面电阻试验 surface resistance test | 表面电阻率[系数] surface resistivity | 表面粗糙度 surface roughness
-
Surface resistively：表面电阻
Water absorption 吸水率, % weight 0.08 | Surface resistively 表面电阻, ohms 3.3E14 | Volume resistivity 体积电阻率, ohms-cm 1.0E15
-
volume resistance：体积电阻
在图中"高/低"两待测点处施加直流电压500 V、共实施 60+5-6秒,可分别测到"表面电阻"(Surface Resistance) 与"体积电阻"(Volume Resistance) ,再代入下列公式即可分别求得两种"电阻率":1.表面电阻率 r =R P/D4;R 为测之表面电阻值;
-
electrical surface resistivity：表面电阻率
electrical supply equipment ==> 供电设备 | electrical surface resistivity ==> 表面电阻率 | electrical suspended gyroscope ==> 电悬式陀螺仪,静电支承陀螺仪,静电支承陀螺仪
-
measuring methods of surface resistivity for glass substrates：玻璃衬底表面电阻率试验方法
l2108 玻璃衬底薄膜粘合性试验方法 testing methods for ... | l2109 玻璃衬底表面电阻率试验方法 measuring methods of surface resistivity for glass substrates | l2110 玻璃衬底表面润湿性测定方法 testing meth...
-
surface resistance：表面电阻
在图中"高/低"两待测点处施加直流电压500 V、共实施 60+5-6秒,可分别测到"表面电阻"(Surface Resistance) 与"体积电阻"(Volume Resistance) ,再代入下列公式即可分别求得两种"电阻率":1.表面电阻率 r =R P/D4;R 为测之表面电阻值;
-
surface resistance：表面阻力表面电阻
surface rescue party 海面救助队 | surface resistance 表面阻力表面电阻 | surface resistivity 表面电阻率
-
surface resistance test：表面电阻试验
表面电阻 surface resistance | 表面电阻试验 surface resistance test | 表面电阻率[系数] surface resistivity