- 更多网络例句与薄涂相关的网络例句 [注：此内容来源于网络，仅供参考]
-
To smear with birdlime.
给灌浆；给涂薄胶泥用薄灰浆或薄泥浆充填或粉饰
-
Brayer:a small hand roller used to spread ink thinly and evenly.
涂墨滚：手动小滚筒，用于薄而匀地涂墨水
-
Firebrick coated with alumina is used as column substrate for the separation of gaseous hydrocarbon mixtures.
氧化铝以薄层形式涂渍于耐火砖上，可以用作快速分析气体烃混合物的色谱柱填充物。
-
Floppy disk — thin flexible disk coated with magnetic material, enclosed in a protective plastic case.
软盘——在又薄又软的盘面上涂上磁介质，装在一个用于保护的塑料套中。
-
Pet film, Business card printing and membership card making ink, aluminum, gelatinize and subsealing PE (as a thermal composite materials), the result of color print ink business card printing and membership card at the end of China and India making up full white ink all on bond in adhesives, resulting in aucilisty and membrane separation from Fox: there is another situation is when the business card printing and membership card making ink ink film the thin membrane with a composite of PE attachthemselves fastness and ink adhesion of film thickness.
例如PET不薄膜、制卡和会员卡制息油不朱、真空镀铝、涂胶与PE不简单，甘休不黑白油不朱制卡和会员卡制息后，末了印上来的满版白不朱全部粘结在胶粘剂上，导致PET与底膜的别离：还有一栽境况是：制卡和会员卡制息油不朱不朱膜层不薄的，在与底膜的PE不简单后附着牢度好，而不朱膜层薄的附着不对。
-
In the early days copper was normally followed by a relatively thin bright nickel layer with conventional chromium topcoat.
早期，涂覆铜层之后，再涂一薄层光亮镍，然后传统的铬层位于最外层。
-
For the veneering with 0.3mm thick veneer over a graduated particleboard, the optimum processing conditions were a UF adhesive level at 78g/m~2 over the board, a PVAC adhesive level at 42g/m~2 over the veneers and 4.6 percent 36％ HCL ...
用0.3mm厚的水曲柳薄木对渐变结构刨花板饰面时，其最佳工艺条件为：脲醛树脂胶在刨花板上的涂胶量为78g/m~2，聚醋酸乙烯酯乳液在薄木上的涂胶量为42g/m~2，38％盐酸用量为聚醋酸乙烯酯乳液重量的4.6％。
-
The surface and cross section of uncoated and coated Polyvinyl acetals were analyzed by microscope and SEM, results showed that, the contact angle of the coated fiber decreased in most of the areas of the fibers, the chitosan film on the fibers was thin and uniform. At the same time, there was no residual material in the coating process and the whole process was environmentally friendly.
结果表明，该方法切实可行，通过显微镜和SEM照片对涂覆壳聚糖前后的维纶纤维进行微观分析，发现在化学纤维表面形成的壳聚糖膜薄而均匀，同时增加了化学纤维的表面粗糙度，涂覆效果较好；通过接触角的变化说明纤维的亲水性得到改善；该方法还具有无残留物和对环境友好的优点。
-
Precise pressure control from 22.8 MPa (400 psi to 3300 psi), for spraying light-bodied coatings all the way up to low-VOC striping paints.
精确的压力控制区间（400psi 到3300psi ），最高压力22.8MPa （3300psi ，可喷涂薄涂型涂料，以及低 VOC 划线涂料。
-
Optimum column pressure, plate height, resolution, tailing factor and resistance coefficient of mass trunsfer were determined.
由于薄涂色谱柱柱子短，较复杂组分的分离效果欠佳，因而限制了它的应用。
- 更多网络解释与薄涂相关的网络解释 [注：此内容来源于网络，仅供参考]
-
bread and scrape：黄油涂得很薄的面包
bread and cheese 普通食品 | bread and scrape 黄油涂得很薄的面包 | bread and wine 圣餐
-
bread and scrape：奶油涂得很薄的面包片
bread and milk 浸于沸滚牛奶中的面包 | bread and scrape 奶油涂得很薄的面包片 | bread and water 粗劣的饮食, 粗茶淡饭
-
bread and scrape：涂薄黄油的面包
bread 裹以面包屑 (动) | bread and scrape 涂薄黄油的面包 | breadbasket 面包篮; 胃; 产粮地区 (名)
-
thin film：旋涂膜
薄管板:thin tubesheet | 旋涂膜:thin film | 动脉壁:arterial wall
-
Impasto Palette Knife：(厚涂调色刀)
Impasto Oil(厚涂油画笔) | Impasto Palette Knife(厚涂调色刀) | Mixer Thin Flat(混合薄平笔)
-
tin-plate roller coating：适用于金屑软管滚涂底色的塞孔油墨. 印铁滚涂塞孔油墨
适用于金属软管印刷工艺的塞孔油墨. 软管滚涂塞孔油墨 collapsible tu... | 适用于金屑软管滚涂底色的塞孔油墨. 印铁滚涂塞孔油墨 tin-plate roller coating | 适用于涂锡薄铁皮滚涂底色的塞孔油墨. 复写纸塞孔油墨 c...
-
grouting：给...灌灰浆,给...涂薄胶泥
grout. 薄泥浆, 水泥浆 | grouting 给...灌灰浆,给...涂薄胶泥 | grub screw 自攻螺丝
-
Lacquered Plate：涂漆镀锡薄钢板
lacquer漆、油漆、涂漆(镀锡)薄钢板 | lacquered plate涂漆镀锡薄钢板 | lacquer finish涂漆、漆面
-
Lacquered Plate：涂漆钢板
lacquer-coated steel sheet || 涂漆薄钢板 | lacquered plate || 涂漆钢板 | lacquered sheet iron || 镀漆铁皮
-
lead-coated：涂铅的 镀铅的
lead-coat 铅镀层 | lead-coated 涂铅的 镀铅的 | lead-coatedsheet 镀铅薄钢板