薄层电阻

词组短语

sheet resistance

与薄层电阻相关的网络例句 [注：此内容来源于网络，仅供参考]

So supported by well core experimentation, the *** analyzed the logging response feature and mechanism of thin bed, and point out that many factors can affect the logging response of the reservoir, the main factor which mostly influence the logging response is the thickness of thin layer, and the content of carbonite have a great influence on the response of 3-porosity logging.we make use of core experimentation, combined with logging material, firstly the *** do the lithology correction and thinckness correction for resistivity curves, and based on the content of mud that derived from the core experimentation, the *** present the thickness correction model of gamma-ray logging and self-potential logging, and choose the appropriate ways to compute the carbonate content and using the value of mixed frame in order to correct the influence from the carbonite, based on this, the *** gives a effective methods to correct the thickness influence for 3-porosity logging.

本文首先以岩心实验结果为依据，对研究区薄层的测井响应特征和机理进行了分析，指出多种地质因素影响着储层的测井响应特征，而层厚是影响测井响应最主要的因素，且碳酸岩含量对三孔隙度测井的影响很大。利用岩心实验分析资料，结合测井资料，首先对电阻率测井曲线进行了岩性的校正和层厚校正；利用岩心分析泥质含量，研究了自然伽马和自然电位的层厚校正方法，并建立了层厚校正模型；在有效计算储层碳酸岩含量和混合骨架参数值的基础上，研究了针对碳酸岩含量对测井曲线的影响进行校正的方法，进而提出了一套对三孔隙度测井曲线的薄层层厚影响的校正模型。

The transformation temperature from low resistance phase to high resistance phase is above 800℃, which is 100℃ higher than that of NiSi.

NiSi的薄层电阻由低阻转变为高阻的温度在800℃以上，比没有掺Zr的镍硅化物的转变温度上限提高了100℃。

The VO x(x.5) film has a negative temperature coefficient of resistance of (-1~-4)%K -1 ,and an activation energy of 0.078eV~0.110eV.

对不同温度退火后氧化钒薄膜在10～100℃范围内测定了薄层电阻随温度的变化，得到的电阻温度系数值为(-1～-4)%K-1。

In this thesis, the heterojunction with intrinsic hydrogenated amorphous silicon thin layer ( heterojunction with intrinsic thin layer: HIT) solar cells are investigated. The solar cell structure of p/i/n are fabricated. The substrate is a typical 4-inch n-type wafer with (100) crystal orientation, 1~10 ohm-cm and about 525 μm thickness. The p and i a-Si:H layers are deposited by a 13.56 MHz plasma enhanced chemical vapor deposition. The i a-Si:H layers are especially deposited by pulse-wave modulation plasma technique with fixed plasma turn-off time toff = 10 ms and changed plasma turn-on time ton= 10 to 40 ms to selectively control the different silicon to hydrogen bonding configurations. The effect of various Si:H bonds on the performance of HIT solar cells are explored.

中文摘要本论文针对异质接面薄本质层(heterojunction with intrinsic thin layer： HIT)太阳电池进行研究，采用一般典型四英吋晶向为(100，厚度约为525 μm，电阻率约为 1~10 ohm-cmn型矽晶圆为基板，制作p/i/n太阳电池，p及i层薄膜以13.56 MHz电浆加强化学气相沈积，i层并采用脉波调变电浆技术，在固定电浆关闭时间toff = 10 ms及改变电浆开启时间由ton = 10 ms 至40 ms条件下制作具有不同矽氢键结微结构的氢化非晶矽薄膜以探讨不同矽氢键结对太阳电池性能的影响。

Focused on the above two problems, the authors applied 2D finite cell numerical modeling to simulating the influence of the static effect on the TE, TM polarized apparent resistivity curves and the vertical resolution of conductive folia.

研究表明：TM模式视电阻率受静态影响严重，TE模式视电阻率对深部地质体的反映优于TM模式；TM极化模式放大了横向上不同电性体的电性差别，在山区找水中对断层反映敏感；AMT对导电薄层的垂向分辨力与围岩的电阻率比值有关，加密点距，并不能提高垂向分辨率。

Since development of volcanic layers and volcanic mounds in basement in Tazhong area, using seismic exploration is usually difficult to acquire better seismic data in the interior of vocatine and below(mainly caused by shield of volcanic layer), but using MT exploration may not produce such problem, because the electromagnetic wave does not suffered from the shield of higher resistance layer; especially the volcanite has the feature of higher magnetic susceptibility and impedance, which provides excellent c...

由于塔中地区的火山岩层及基底火山岩丘发育，采用地震勘探方法通常难以在火山岩内部及其以下获得比较好的地震资料(主要是火山岩层的屏蔽作用)，而利用MT勘探则无此问题，因为电磁波不受高阻地层屏蔽，尤其是火山岩具有高磁化率和高电阻率的特征，从而为在该区应用大地电磁和磁力方法识别火山岩薄层及基底火山岩丘提供了得天独厚的条件。

The reservoir rock types in the region of interest are grain limestone, algal limestone, cryptite, siltstone, muddy limestone and mudstone. The thesis identified as a result of changes in the deposition causing the heterogeneity in plane, and then the geological oil reserves have been calculated in accordance with the areal heterogeneity.3、Based on the data of core analysis, bore logging, array induction imaging log and FMI, porosity and permeability model were built using regression analysis. Through testing 45 rock samples, a, b, m, n value were obtained and used to calculate single-layer oil saturation value using the Archie formula. According to the theory of laterolog and inductolog, resistivity ratio and cross plot were used to identification effective thickness. Effective thickness was identified delicately in 103 wells. Based on the over work, active porosity and oil saturation was calculated accurately.4、According to observation of 100 pieces of the thin slices, cast thin slices and 383m core in three wells, the chief diagenesis in this area were compaction, cementation, denudation and cataclasis. Cementation and denudation were universally influenced active porosity this area. The intergranular pores, residual pores and secondary pores were formed in thin carbonated reservoir of lacustrine facies.5、The influence of reservoir heterogeneity to reservoir calculation was analyzed systematically using actual data. And the conclusions were as follows:①The principal reason leading to oil distribution unequal is interior structural feature of reservoir in structural hydrocarbon reservoir.

确定了由于沉积微相的变化而导致的平面非均质性，进而在平面上按照平面非均质单元计算了石油地质储量。3、利用岩心分析、常规测井曲线与阵列感应、成像测井资料相结合，分岩性利用回归分析方法建立了储层孔隙度、渗透率模型；通过对45块岩样进行岩电试验，获取了a、b、m、n值，利用阿尔奇公式计算了各单层含油饱和度值；根据侧向电阻率和感应电阻率串并联特性，利用电阻率比值法与常规交会图法相结合重建了有效厚度图版，对全区103口井目的层段进行了有效厚度精细划分，通过以上工作，准确求取了储量计算单元内有效厚度参数、有效孔隙度参数以及含油饱和度参数。4、通过对研究区3口井383m岩心观察，100余块薄片、铸体薄片镜下鉴定得出：油泉子油田上、下油砂山组储层主要成岩作用是压实作用、胶结作用、溶蚀作用和破裂作用，其中溶蚀作用、胶结作用最普遍，这两种作用对有效孔隙度影响最大，以上成岩作用形成了原生粒间孔、粒间残余孔和次生孔隙(如粒间溶孔、粒内溶孔、铸模孔、晶间孔等)为主的薄层湖相碳酸盐岩储层。5、利用实际资料，系统分析了油藏非均质对储量计算的影响，认为：①对于构造油气藏而言，油气藏构造及断裂特征是造成油气分布不均的首要原因，储集条件相同的条件下，构造高部位有利于储存油气，油气在垂向的重力分异体现了油气藏内部构造的不均一特征。

Thin bed resistivity log oil and gas distribution integrate interpretation application

薄层；电阻率测井；油气分布；综合解释；应用

Screen print and sintering contact are popular in PV industry.Measurement of Ohm contact is one of key evaluation for the process.

串连电阻由金属电极的电阻、金属半导体接触电阻、发射区薄层电阻和基区电阻等组成。

与薄层电阻相关的网络解释 [注：此内容来源于网络，仅供参考]

resistance, on-state：导通状态电阻

resistance, negative 负电阻 | resistance, on-state 导通状态电阻 | resistance, sheet 表面电阻;薄层电阻

best charcoal tin plate：最优厚锡层镀锡薄钢板

best best wire 中等电阻的钢丝 | best charcoal tin plate 最优厚锡层镀锡薄钢板 | best coke grade tin plate 高级镀锡钢板