- 更多网络例句与脱粘的相关的网络例句 [注:此内容来源于网络,仅供参考]
-
Inclusion-matrix interfacial debonding is one of the principal damage mechanisms in brittle matrix composites.
夹杂-基体界面脱粘是脆性基体复合材料在拉伸载荷下的主要损伤机制之一。
-
In the long-CF/PSF composite system these strengths increase more pronouncedly than in short-CF/PSF composites.
CF/PSF复合材料的破坏均呈现出纤维—树脂界面脱粘现象。
-
Debonding and pullout of the fibers play an important role in the toughening of these composites.
碳纤维的脱粘和拔出对Cf/SiC复合材料的增韧起到了重要的作用。
-
This method has a number of weaknesses such as random deviation, no quantitative analysis, and a longer testing cycle. The latter is most used to check the crack and slag inclusion inside the solid rocket engine.
该方法存在误检率高、无法定量分析、检测周期长等缺点;另一种是X射线投影技术,主要用于检测发动机第二、三界面的脱粘及药柱内的裂纹、夹渣等缺陷。
-
Furthermore the deterring layer didn′t spall from bulk of propellant after aged at 65℃ for 90 d.
当吸收硝化甘油14.1%时,表征能量的爆热提高约5.4%,在65℃加速老化90d后,仍无脱粘现象发生。
-
The experimental results showed that both nylon 611 and nylon 611/montmorilonite were pseudoplastic and exhibited shear-thinning behaviors.
在恒定剪切速率下,蒙脱土的质量含量对体系剪切应力和表观粘度的影响相似。
-
The results showed that using polymer film forming agent together with silicane coupling agent could not only enhance the chemical bond between GF and resin matrix,increasing crystallinity of the resin,forming stable boundary layer,but also make GF orientating easier along the flow direction in resin.
但是,人们发现即使采用优化的偶联剂处理工艺处理GF,其增强效果也时常不佳,这与GF增强热塑性树脂复合材料熔体在熔融流动成型过程中,因强烈的剪切作用导致复合材料界面发生脱粘现象,使
-
Aim\ To study the auto classification and identification method for testing the adhesive state of liner cladded on the inner surface of the rocket motors.
目的研究火箭发动机绝热包覆层脱粘检测的自动分类识别方法。
-
Sample 1 had no phenomenon of pulling-out and debonding of fibres under vertical compression load and the interface bonding intensity is strong between the fibres and the matrix. The material shows brittle fracture: if σ(subscript ⊥)=60.7MPa. However, sample 1 has the phenomenon of fibres debonding because of the shearing stress between the fibres and the matrix under parallel compression load. The material shows tough fracture:σ(subscript ∥)=52.6 MPa.
试样l在垂直纤维层方向压缩载荷作用下,没有出现纤维的拔出、脱粘等现象,界面结合较强,材料呈现脆性断裂:σ=60.7MPa;而在平行纤维层的压缩载荷作用下,纤维与基体存在剪切作用,存在纤维的脱粘,试样呈现韧性断裂:σ=52.6MPa。
-
The methods how to judge the character of anti-peel-back of phenolic resin according to viscosity curve was also anaoyzed.
分析了覆膜砂脱壳的原理以及根据粘度变化曲线判断树脂抗脱壳性的原理。
- 更多网络解释与脱粘的相关的网络解释 [注:此内容来源于网络,仅供参考]
-
stripling n.1:苗木修剪 2.年轻人
strip v.1.剥去,脱衣 2.剥夺;抢劫 n.带,长条 | stripling n.1.苗木修剪 2.年轻人 | tacky a.1.(油漆或胶水)粘的 2.俗气的,缺乏教养的
-
conjugated protein:缀合蛋白质
in)和缀合蛋白质(conjugated protein)根据分子的形状:球状(globular protein)、纤维状(fibrous protein)糖蛋白(glucoprotein)和粘蛋白(mucprotein):辅基成分为半乳糖、甘露糖、已糖胺氨基酸经脱羧酶(decarboxylase)作用后可以放出二氧化碳生成相应的一级胺(amine)⒈ 与茚三酮(ninhydrin)反应:氨基酸分析化学中最常用反应之一
-
glucoprotein:糖蛋白
ous protein)糖蛋白(glucoprotein)和粘蛋白(mucprotein):辅基成分为半乳糖、甘露糖、已糖胺氨基酸经脱羧酶(decarboxylase)作用后可以放出二氧化碳生成相应的一级胺(amine)⒈ 与茚三酮(ninhydrin)反应:氨基酸分析化学中最常用反应之一,