- 更多网络例句与脱碳作用相关的网络例句 [注：此内容来源于网络，仅供参考]
-
In addition, there is delamination removal at weak interface due to decarburization.
普通涂层的磨损机制为微切削；纳米涂层在轻载(10 N)下，以塑性变形为主要磨损机制，随载荷增加至30 N，纳米WC粒子不能起到阻抗陶瓷球对磨副的磨削作用，而是随粘结相一起被去除，同时由于纳米涂层脱碳导致的层间结合薄弱，在滑动磨损中易发生成片剥落，耐磨性大幅下降。
-
The results show that the main reason is many little cracks exist,and heavy reticulation structure,inclusion, coarse grain and side decarburized stucture.
结果表明，其发生断裂的主要原因是存在较多的小发纹，加之较严重网状组织、夹杂物、晶粒粗大和边部脱碳组织，在机械加工力的共同作用下，导致轻轨发生断裂。
-
Compared to the other carbon and nitrogen sources studied, sucrose and malt extract were found to be the suitable carbon/nitrogen sources. The decolorization efficiency of Cerrena unicolor Y5002 to orange G was similar at different orange G concentration below 500mg/L; however, alizarin red inhibited the decolorization reaction at the concentration of 400mg/L or above 400mg/L.
对一色齿毛菌Cerrena unicolor Y5002的液体培养脱色条件进行了研究，其最适碳源和氮源分别为蔗糖和麦芽浸粉；在不同橙黄G浓度下均获得较高的脱色率，因此浓度为500mg/L的橙黄G未对该菌的脱色能力产生抑制作用，而浓度为400mg/L茜素红则对其脱色作用产生明显抑制。
-
The effect of zeolites ion-exchanged by transition metals on thermal catalytic cracking reaction is studied. The product distributions of the cracking reactions catalyzed by theβor ZSM-5 zeolites exchanged with transition metals are different from that catalyzed by corresponding Hzeolites, which means the mechanism of cracking reactions has varied. Group Ⅷ metals Fe, Co, Ni and Cu, Zn are shown to be of strong catalytic activity of oxidative dehydrogenation, while Ti and Cr are not of oxidative activity. Catalyzed by zeolites or catalyst containing Ag, conversion of thermal catalytic cracking reactions and the yield of ethylene increase while the yield of propylene does not decrease. Silver can not only promote the formation of carbonium ion, but also convert carbonium ion into free-radical via redox reaction. The weak adsorption of olefins on silver reduces the occurrence of hydrogen transfer and dehydrogenation. As a result, the yield of light olefins is favored by silver in the catalyst.
采用过渡金属交换的分子筛作为催化剂，进行催化热裂解制取乙烯的反应，研究发现，在β沸石分子筛和ZSM-5分子筛中引入过渡金属后，催化热裂解反应的产物分布与相应的氢型分子筛相比有了较大的变化，说明过渡金属的加入对于催化热裂解反应的机理具有影响，Ⅷ族金属如Fe、Co、Ni和第Ⅰ、Ⅱ副族Cu、Zn表现出较强的氧化脱氢活性，产物中氢气、焦炭的产率很高，Ti、Cr则未表现出氧化作用：分子筛及催化剂中引入银后，催化热裂解反应的转化率和乙烯的产率有了提高，丙烯产率没有很大的变化，说明银在催化热裂解反应中能够促进正碳离子的生成，又有可能通过氧化-还原作用部分改变反应机理，促进了自由基的生成，并且由于银对烯烃的吸附很弱，其氢转移反应和脱氢、加氢活性比较低，有利于烯烃产率的提高。
-
Introduced the process about identifying the principle of heating system to improve decarbonization of 60Si2Mn spring flat steel ,In the measurement and analysis process of the decarbonized improvements of spring slab and finished flat steel,bottlenecks of the decarbonized reasons are found by applying statistical techniques.
介绍了60Si2Mn 弹簧扁钢脱碳改进中加热制度原则的确定过程，在弹簧方坯和成品扁钢脱碳改进的测量和分析过程中应用了统计技术，直观、定量找出了脱碳产生原因的瓶颈，提出了进一步的改进措施，探讨了统计技术在品质改进中的重要作用。
-
A modified homogeneous flow model was introduced to calculate the flow field in RH degasser,thus getting rid of some earlier methods that are unavailable to be generalized,such as reducing the computation region or presetting the distribution of gas volume fraction.
分别对有、无旋转磁场作用时的RH系统进行了模拟计算。模拟结果表明：流场和脱碳过程与现有文献中实验结果相符合；当旋转磁场作用后，磁感应强度为0.04 T时，初期脱碳速度比无旋流作用时增加了约15%，这是由于旋流增加了系统的搅拌能，提高了脱碳反应速率。
-
All in all, under the factors above, the depleted zone in pearlite steel would crack fragilely for formation of creep-flaw in low stress during operating at high temperature before designed expiration date.
异种钢的焊接接头在高温运行中，在高温和应力的作用下，珠光体的脱碳层会产生蠕变裂纹，发生低应力脆性断裂，从而导致接头的早期失效。
-
Its subject coverage includes: ladle and tundish technologies to remove inclusions and prevent oxidation; and argon oxygen decarburizing, ladle degassing, filtering, secondary refining, and chemical analysis of slags.
它的主题涉及的范围包括：包和漏斗技术去除夹杂物和防止氧化作用；氩氧气钢的脱碳，包内去氧，过滤，二次精炼法，炉渣的化学分析。
-
As the concentration of FeO increasing, the rate of decarburizing and reaction-dissolving of refractory rises sharply. Meanwhile gas production rate of reduction reaction is increased and motion and foaming of molten slag are also speeded up. The corrosion feature of refractory containing graphite carbon is that the most severity area is slag level (interface of slag-gas phas -refractory) and slag-metal interface comes second, and the lowest corrosion rate is the area of iron-bath.
熔体的组成、温度及熔体与耐火材料间的相对运动对耐火材料的侵蚀产生着很大影响，而熔渣中FeO浓度是最主要的因素，FeO浓度提高，使耐火材料脱碳和反应熔蚀速度呈直线上升，熔体中还原产生气体量增加，熔体涨泡及运动速度提高，这些作用都加快了熔体对耐火材料的侵蚀。
-
By injecting commercially pure argon to make pressure in furnace up to 66.66 kPa and controlling refining temperature between 1 450 ℃ to 1 500 ℃, adding Mg-Ca alloy 50 kg/t and fluxed additions CaF\-2 11 kg/t, after refining the phosphorus content in steel 00Cr18Ni10 further decreased to (50～60)×10 -6, and oxygen and sulphur content in steel decreased to (4～6)×10 -6 and 15×10 -6 respectively.
采用CaC2 CaF2 法脱磷容易增碳，使后期冶炼工艺复杂，因此最好在吹氧前使用；CaC2 CaF2 也可用作喷吹SiCa粉脱磷时的覆盖渣，可起到保持还原气氛的作用。SiCa CaF2 法是唯一在工业规模上有少量应用的还原脱磷法，而且氧化脱除增加的硅比较容易。
- 更多网络解释与脱碳作用相关的网络解释 [注：此内容来源于网络，仅供参考]
-
decarbonization,decarburation：脱碳作用,除碳
\\"红瓜\\",\\"Decapterus russelli\\" | \\"脱碳作用,除碳\\",\\"decarbonization,decarburation\\" | \\"脱羧\\",\\"decarboxylase\\"
-
decarbonize：脱碳,清除积炭
decarbonization | 脱碳(法),脱碳(作用),除碳法 | decarbonize | 脱碳,清除积炭 | decarbonizer | 除碳剂
-
decarbonize：除碳 脱焦炭
decarbonization 脱碳 脱碳作用 除碳法 | decarbonize 除碳 脱焦炭 | decarbonizer 除碳剂
-
surface decarburization：表面脱碳<作用>
surface contact 表面接触 | surface decarburization 表面脱碳 | surface diffusion 表面扩散
-
decarburize：脱碳
decarburization | 脱碳(作用),脱碳法,脱碳处理 | decarburize | 脱碳 | decarburized case | 脱碳层
-
decarburation：脱碳
decarboxylation 脱羧作用 | decarburation 脱碳 | decarburization 脱碳
-
decarburation：脱碳 脱碳作用
decarbonizing 脱碳 | decarburation 脱碳 脱碳作用 | decarburization 脱碳 除碳法
-
decarbonization,decarburation：脱碳作用,除碳
\\"红瓜<>\\",\\"Decapterus russelli\\" | \\"脱碳作用,除碳\\",\\"decarbonization,decarburation\\" | \\"脱羧<>\\",\\"decarboxylase\\"
-
decarbonizing：除碳作用
decarbonizer || 除碳剂 | decarbonizing || 除碳作用 | decarbonylation || 脱羰作用
-
decarbonizing：去碳作用
"decantation","倾析 ; 倾泻法" | "decarbonizing","去碳作用" | "decarburization","脱碳"