- 更多网络例句与胶层相关的网络例句 [注：此内容来源于网络，仅供参考]
-
In this dissertation, the mechanical behavior of the metal adhesively bonded composite joints under loading have been systematically investigated by numerical calculation methods and experiments, and effects of shape dimensions and physical parameters of joints on stress distribution and strength of adhesively bonded joints have been placed emphasis upon.
本文在对国内外关于金属-胶层复合材料接头力学性能数值研究及发展现状进行综述的基础上，运用有限元法并结合实验手段主要研究了胶接接头承载后的力学行为，综合考虑了几何尺寸和物性参数对接头强度和应力分布的影响，并运用层次分析法对胶接质量进行综合评估，综合考虑接头形式，制造工艺，操作人员素质等因素的影响。
-
The stress distribution of adhesively-bonded metal/metal single lap joints under tensile shear loading is analysed using elastic-plastic finite element method .The influence of lap length on the strength of adhesively bonded metal joints which are bonded with phenolic resin and acrylic resin respectively is discussed in detail. It is shown that adhesive has great influence on the stress distribution of the lap region. With the increment of lap length, the stress concentration of adhesive layer decreases.
本文在对国内外关于金属-胶层复合材料接头力学性能数值研究及发展现状进行综述的基础上，运用有限元法并结合实验手段主要研究了胶接接头承载后的力学行为，综合考虑了几何尺寸和物性参数对接头强度和应力分布的影响，并运用层次分析法对胶接质量进行综合评估，综合考虑接头形式，制造工艺，操作人员素质等因素的影响。
-
The tiscosity of the gelatinize layer on the service life of doubleside, the tiscosity gelatinize layer is low, and the second time, plates are not easily glued; sticktness exorbitance rrepublic change version of destructive doubleside surface.
涂胶层的黏度差双面胶的搁置寿命感化较不小，涂胶层黏度矮，第二次搁置时，版材不易粘牢；黏度功矮。换版时便当爱护双面胶暗地。
-
The energy distribution of the focused laser spot has Gaussian profile, and if the exposure dose threshold of the photoresist is less than and far away from the peak of that Gaussian curve, the linewidth will be less affected by the variation of exposure dose or exposure dose threshold, and so, will improve the linewidth stability.
准直光束经物镜会聚后光斑的能量呈近似高斯分布，当胶层的曝光量阈值远离高斯型曝光量曲线的头部时，可以弱化线宽对实际曝光量或胶层曝光量阈值等变化的敏感度，从而提高线宽的稳定度。
-
The influence of recessing in adh es ive layer with high elastic modulus on the peak stress of joint is not evident so that it would improve the actual strength of joint markedly based on the load bearing ability not being affected evidenly . On the other hand , the recessing in the joint with low elastic modulus adh es ive caus es the peak stress es increase evidently that may decrease the nominal and actual strength of the joint markedly .
对胶层和被粘物中应力分布的数值分析结果表明：胶层中的间隙对接头端部的应力分布无明显影响，但对间隙附近的应力峰值影响较大；随着胶粘剂弹性模量的增大，间隙附近的应力峰值有所降低；对于高弹性模量胶粘剂接头，胶层中的间隙对接头的应力峰值无明显影响，在不降低接头名义强度的同时可使得接头的实际强度显著提高；而对于低弹性模量胶粘剂接头，间隙使得接头上的应力峰值明显上升，可能导致接头的名义强度和实际强度显著降低。
-
Remain on the printing plate in the blank space of black-coated shieldoff light, so that the blank for not photographicsensitive layer; and the graphics and text at photoptic photographicsensitive glue due to lost black protective coating, photopolymerization reaction, the final text.
保留在印版不满缺处的白色涂层盖住平线，使不满缺处的感平胶层不感平；而图文处的感平胶层由于获得了白色涂层的爱护，爆发平撮合不正答，即变成了首不后的图文局部。
-
Considering the prerequisite of joint non-linearity and glue-line elasto-plasticity,the stress distributions in the glue-line of asymmetrical joint for continuous or gap jointing were analyzed by finite element method and glue-line structure optimization was made.
在考虑接头非线性和胶层弹塑性的前提下，利用有限元方法分析了连续胶层不对称接头和间隙连接不对称接头中胶层内的应力分布情况，并在此基础上对胶层结构进行优化。
-
Results show that when improving spot pitch in weld bonded joints with high elastic modulus adhesives, stresses in weld spot zone are decreased while stresses and strains at edges of overlap region are increased slightly. For the joints with low elastic modulus adhesives, both stress concentration degree at the weld spot and the shear strain at edges of overlap region are increased with the spot pitch increasing.
结果表明，高弹性模量胶粘剂胶焊接头中，增大焊点间距，焊点区应力减小而搭接区边缘胶层中的应力应变略有增大；低弹性模量胶粘剂胶焊接头中，焊点处应力集中程度和搭接区边缘胶层中的剪应变值都随焊点间距的增加而增大，增加焊点间距，两种接头的胶层断裂强度都将降低。
-
In this paper, test research have been performed on the two important mechanical properties indicator compressive modulus of elasticity and shear modulus. Numerical simulation has been performed on the base of results of test under the situation uniform and uneven thickness of elastomer layer, which analyze internal stress distribution of the elastomeric bearing, as follows:(1) The traditional test methods of compressive modulus of elasticity test are rather cumbersome and take up experimentalists lots of time. This paper has improved the traditional test methods of compressive modulus of elasticity test, which has collected the holding-load time together to concentrate on holding load. The tests have been performed on different types of bearings, which results show that the results of the improved test method conform to the error range regulated by the standard and can effectively save time for the experimentalists, also eliminate the accumulative error.
本文主要对板式橡胶支座的抗压弹性模量、抗剪弹性模量两个重要力学性能指标进行试验研究，并在试验结果的基础上对均匀胶层厚度和不均匀胶层厚度两种情况进行数值模拟，分析橡胶支座内部应力分布规律，具体内容如下：(1)传统抗压弹性模量试验方法比较繁琐，占用试验人员大量时间，本文对传统抗压弹性模量试验方法进行了改进，将持荷时间集中起来进行集中持荷，通过对不同类型支座进行试验，试验结果表明该改进试验方法所得结果符合标准规定误差范围，为试验人员节省了大量时间，并且还消除了传统方法中的累计误差。
-
Kuyto playing forming structural adjustment, the kuyto play shaping mechanism have the books gummed mesopause nourishing, too low to cover and back-bonding systems that lead back up adhesive layer.
托打成型机构调整不当，托打成型机构过高会将书背胶层顶滋，过低使封面与书背黏结不实，也会造成书背胶层起空。
- 更多网络解释与胶层相关的网络解释 [注：此内容来源于网络，仅供参考]
-
primary cell wall：初生细胞壁
中胶层形成后,初生细胞壁 (primary cell wall) 便会在细胞活跃生长期间或之前形成,当中凝胶状的基质含有较坚硬的纤维素微纤维. 差不多所有植物细胞都有中胶层和初生细胞壁,有些细胞更会在细胞增大完成后、分化作用开始之前在初生细胞壁内加添其他结构层.
-
gel chromatography：凝胶层析
赖氏 (Reitman-Frankel)法和改良穆氏(Mohun)法.这三种方法的原理,试剂和操作方法包括血清和试剂的用量及作用温度均相同,不同之处是金氏法酶作用时间为60分钟,而其他二法为30分钟.因此活性单位定义不同.凝胶层析(gel chromatography),又称为凝胶过滤(gel filtration),
-
gel chromatography：凝胶层析法
凝胶层析法(gel chromatography)也称分子筛层析法,是指混合物随流动相经过凝胶层析柱时,其中各组分按其分子大小不同而被分离的技术. 该法设备简单、操作方便、重复性好、样品回收率高,除常用于分离纯化蛋白质、核酸、多糖、激素等物质外,
-
gel chromatography：凝胶层析术
gel electrophoresis 凝胶电泳 | gel chromatography 凝胶层析术 | gel cellophane membrane 胶凝赛珞凡膜
-
epidermis：表皮
*体壁有两层细胞组成,[[表皮]](Epidermis)和肠表皮(Gastrodermis),两者之间有一层凝胶状的中胶层(Mesogloea),其支持作用. *体壁有两层细胞组成,[[表皮]](Epidermis)和肠表皮(Gastrodermis),两者之间有一层凝胶状的中胶层(Mesogloea),
-
middle lamella：中胶层
细胞壁最初形成之膜为中间膜或中胶层(Middle lamella),大部分由果胶质复合物所组成,而后沿中间膜的两侧表面,即从每一个子细胞之细胞质产生一新薄膜,此乃纤维与果胶复合物所构成,由每一新的子细胞之原生质体(Protoplast)中之纤维与果胶物质包围,
-
mesogloea：中胶层
体壁有两层细胞组成,表皮(Epidermis)和肠表皮(Gastrodermis),两者之间有一层凝胶状的中胶层(Mesogloea),其支持作用. 含有食饵的海水由於内层细胞鞭毛的不断振动,从入水孔流入体内,不消化的东西随海水从顶端的出水口流出体外.
-
mesoglea; mesogloea：中胶层
中胚层神经胶质 mesoglea | 中胶层 mesoglea; mesogloea | 间(神经)胶质;小神经胶质 mesoglia
-
meesoglea;mesogloea;middle lamella：中胶层
中间性遗传 intermediate inheritance | 中胶层 meesoglea;mesogloea;middle lamella | 中脉; 主脉 midrib
-
mesoglea：中胶层
(epitheliomuscularcells)中间夹有一层很薄的中胶层(mesoglea)所组 成,包围中央的一个胃循环腔(gastrovascularcavity). 水螅类的胃循环 腔为一简单的空腔,也呈管状,而珊瑚类的胃循环腔复杂,被体壁向心伸出 的许多隔膜分隔成许多间隔(图 5-31),