胶合

基本解释 (translations)

agglutination  ·  cement  ·  glue  ·  veneer  ·  glued  ·  bunching  ·  cements  ·  glues  ·  veneered  ·  veneers  ·  glueing

词组短语

glue together

与胶合相关的网络例句 [注：此内容来源于网络，仅供参考]

With technics of prepare glue, the oxidant and crosslink agent have remarkable influence to the water endurance bonding strength. With craft of the pressing plate, hot pressing temperature and pressure have conspicuity effects on veneer performance.

在制胶工艺中，氧化剂和交联剂对耐水胶合性能有显著影响；在压板工艺中，热压温度、压力对胶合性能有显著影响。

When the distance kept increasing beyond 15 mm, the bond strength continued to decrease, and reached the lowest point of 1.11 MPa at the distance of 40 mm.

相距15 mm时板的胶合强度最大（1.71 MPa），距离为40 mm时胶合强度最小（1.11 MPa）。

Most of optic a l systems consist of a number of singlet a nd doublets, of which the singlet c a n be considered a s a speci a l doublet.

摘要大多数光学系统都是由若干单透镜和双胶合透镜组成的，单透镜可以看成是双胶合透镜的特殊情况。

This article will help with the production, design and construction of glued laminated timber structure.

本论文的研究结果对我国自行生产胶合木以及设计、建造胶合木结构具有一定的现实意义。

Applying MDI ,thc bond strength of plywood achieve national standard when the moisture content of Populus simoniicarr and Liquidambar formosana Hancemoisture are 12% and 20%.With same material and technics ,bond strength of parallel lay-up is higher than upright lay-up.

而当采用异氰酸酯做胶粘剂时，杨木胶合板的含水率在12%，枫木胶合板在含水率20%时达到国家标准要求；⑤材料和工艺相同时，顺纹组坯时的胶合强度高于垂直纹理组坯时的胶合强度。

Then the light intensity transmission of polarizing prisms with the incidence of random spatial light beam is studied. Both experimental and theoretical results indicate that the light intensity transmission of air-spaced polarizing prisms are affected more by the change of random spatial incident angle than dielectric-spaced polarizing prisms.

结果表明：胶合层间的多光束干涉对棱镜光强透射比的影响不可忽略，对于空气隙型偏光棱镜，由于空气隙间多光束干涉的影响，光强透射比随任意角度变化较大，而用胶合介质胶合的棱镜，其透射比对空间入射角不是很敏感。

The main reason why quarter-sawn board of Birch had smaller dry compressing shear strength than flat-sawn board of Birch in normal conditions was that Birch had different shear strength to the grain between quarter-sawn board and flat-sawn board. Meanwhile xylary rays in flat-sawn board were transversely cut and left a lot of pores in the flat-sawn board, so adhesive can enter these pores and turn into adhesive nail. While these pores provided a kind of tunnel for water, so cause this phenomenon that wet compressing shear strength of flat-sawn board of Birch was smaller than that of quarter-sawn board of Birch. The possible reason why quarter-sawn board of Oak had greater dry compressing shear strength than flat-sawn board of Oak in normal conditions was that ratio of springwood on quarter-sawn board and flat-sawn board was different.

造成柞木径切板的常态压缩剪切强度比弦切板的常态压缩剪切强度大的主要原因是，在径切板和弦切板上早材胶接的比例不同，径切板的胶合强度试件上早材胶接的比例相对少，而弦切板的胶合强度试件上早材胶接的比例比径切板的胶合强度试件上早材胶接的比例相对大，由于早晚材胶接过程中强度决定于早材，这部分胶接强度比较低，这就使得柞木径切板的常态压缩剪切强度比弦切板的大；同时在柞木弦径面胶接过程中由于实际胶接面积的不同也能造成弦径面上API胶粘剂与之形成的化学键的数量不同，这也是造成柞木径切板的常态压缩剪切强度比弦切板的大的原因之一。

The critical scuffing temperature of friction pairs is not constant and changes with the friction pair operational conditions.

本文研究的成果可用于摩擦副临界胶合的计算，指导摩擦副胶合设计，指导添加剂和润滑油的设计，并为工程选用添加剂提供理论及试验依据。

Using the experimental data obtained in this paper,the validity of severalscuffing medels in literature have been analyzed,the results indicate that none of the models canexplain various scuffing behaviors observed in the tests of this paper.

根据所获试验结果对文献报道的几种表面胶合失效理论模型的适用性作了详细分析，发现这些都不能解释本试验中所发生的各种胶合失效现象。

The abrupt change in temperature is one of the main characteristics in scuffing. Studies have showed that friction pair temperature plays an important role in scuffing.

温度突变是胶合发生的主要特征之一，有关研究表明摩擦副温度对胶合发生起着重要作用，因此，从摩擦副的温度来着手研究胶合现象是胶合研究领域的一个重要方向。

与胶合相关的网络解释 [注：此内容来源于网络，仅供参考]

adhesively bonded construction：胶合结构

"adhesive tape","胶带" | "adhesively bonded construction","胶合结构" | "adhesively-bonded honeycomb sandwich construction","蜂巢胶合结构"

anchylose：胶合起来

防水油毛毡 tar felt | 胶合起来 anchylose | 树胶胶合 resinoid bond

bread and butter model：水平板层胶合的船体模型

bread and butter model 多木片胶合而成的航模 | bread and butter model 水平板层胶合的船体模型 | bread and butter model 由许多水平层木片胶合而成的航模

bread and butter model：多木片胶合而成的航模

breaching 烟道总管 | bread and butter model 多木片胶合而成的航模 | bread and butter model 水平板层胶合的船体模型

bread and butter model：由许多水平层木片胶合而成的航模

bread and butter model 水平板层胶合的船体模型 | bread and butter model 由许多水平层木片胶合而成的航模 | bread 面包

gummer：胶合机;胶合工

gummedreneertape 胶合板用胶粘带 | gummer 胶合机;胶合工 | gummingmachine 涂胶机

veneering hammer：胶合锤

veneering 贴面,薄片胶合,木板胶合 | veneering hammer 胶合锤 | venereal granuloma 性病肉芽肿,性病性肉芽肿

glued joint：胶合接头

glue used for structural timberg 木结构用胶 | glued joint 胶合接头 | glued laminated timber 层板胶合木(¨)

veneered wood：胶合镶板

胶合磨耗 adhesion wear | 胶合镶板 veneered wood | 曲型胶合木 curved laminated wood

primary glueing：一次胶合,初步胶合

primary function 原函数,主函数,主功能 | primary glueing 一次胶合,初步胶合 | primary graphite 初生石墨