线性元件

词组短语

linear element

与线性元件相关的网络例句 [注：此内容来源于网络，仅供参考]

As the track space increasing, the holding power which flexible holding parts act on sugarcane is dropping off. As the canvas layers and length of flexible holding part increasing, the track space is also increased when flexible holding parts act on sugarcane same holding power. As the length of flexible holding part increasing, the rate of slope of holding power following the track space to change would be decreased, so holding power would vary slowly. The holding power has a better linear relationship with the track space. Holding sugarcane stalk on knot or not on knot, sugarcane stalk having leaves or without leaves, the holding power would have not significant difference. Considering the structure of device and stress of sugarcane, 4-layers canvas conveyer belt was used as flexible holding part, while its length is 120mm, 160mm, or 200mm, the corresponding maximum track space is 135mm, 183mm, or 235mm. Experimental investigation of sugarcane windrowing was done on the arc-track-type flexible holding and conveying test mechanism.

随着轨道间距的增大，柔性夹持元件施加给甘蔗的夹持力逐渐减少；施加给甘蔗相同的夹持力，随着柔性夹持元件帆布帘层数和长度的增加，对应的轨道间距增加；随着柔性夹持元件长度的增大，柔性夹持元件施加给甘蔗的夹持力随轨道间距变化的斜率减小，夹持力大小的变化越缓慢；柔性夹持元件提供的夹持力与轨道间距均呈线性关系；柔性夹持元件夹在甘蔗节上还是不夹在节上，甘蔗有叶还是无叶，其施加给甘蔗的夹持力无显著差异；从夹持输送装置结构以及甘蔗的受力情况来考虑，选择4层帆布帘输送带作为柔性夹持元件更能平稳、柔和地夹持输送甘蔗，4层帆布帘120mm、160mm、200mm长的柔性夹持元件夹持甘蔗所需最大轨道间距为135mm 、183mm、235mm。

Thermal hydraulics: feat systems, noesis agitate sending systems, anti-lock braking systems, cerebration gear, render shot systems, astir support systems, lubrication systems* Gas dynamics: pneumatics, propulsion, sterilization, expose and clean cycles, high-pressure gas, pedal transmission, adsorption, pedal form reactions, HVAC, ECS, multi-species aerosolized systems* Multiphase fluids: refrigeration, air-conditioning, status control, cryogenic piping networks, steam/water systems, or render systems with exotic, vaporific fluids.* Systems curb element and code assessment data acquisition distribution rates, anachronic communication, similarity and digital electronic filters, curb wrap enforcement rates, meshwork (CAN charabanc communication, etc.* Fuel cells: stationary or mobile.* Electrical systems: AC/DC machines, noesis electronics, batteries, etc. Flight dynamics, and curb systems of every kinds including digital filters

MSC Easy5的独到之处在于：其一，强大的控制系统仿真分析能力，可以建立各种复杂的控制系统模型，包含稳态分析、线性系统分析、频域响应、根轨迹分析等完整的控制系统分析类型；其二，多学科专业应用库，借助专业应用库中的预定义模型元件，向用户提供独一无二的建立系统级模型和研究多学科系统耦合问题的能力；其三，卓越的代码生成和求解器，可以由图形化系统模型自动生成相应的FORTRAN或C源代码，这些代码可以通过编译生成可执行程序，并可被用户调用；其四，高效的高级建模和二次开发功能，方便用户创建用户化模型元件，并可调用外部FORTRAN或C子程序；其五，与其它CAE软件良好的集成能力，可以将不同CAE软件所建立的模型集成到MSC Easy5中建立完整的虚拟样机，是真正的协同仿真平台。

In addition, the voltage-current characteristic of linear resistive components is the general solution of Clairaut equation, and the voltage-current characteristic of non- linear components is the singular solution of Clairaut equation.

论文摘要：本文讨论了任意伏安特性电阻元件满足的基本微分方程以及非线性电路的功率匹配问题的几个定理，指出任意伏安特性电阻元件均满足非线性一阶的clairaut方程，并且，线性电阻元件的伏安特性是clairaut 方程通解，而非线性电阻元件的伏安特性是clairaut 方程的奇解。

AlN MSM devices were fabricated on AlN epitaxial thin film deposited on GaN/Sapphire substrates using helicon sputtering system at the low temperature of 300°C. The device characteristic was found to be improved by in situ metallization of Al electrodes. The extremely low dark current (1.39pA at 20V), the ideal factor (1.0125) and the Schottky barrier height (0.916eV) are superior compared to those of AlN MSM in the literature. When the device was illuminated by the 150W D2 lamp, the ratio of the induced photocurrent to dark current is more than 2 orders of magnitude. The illumination effect also shows the linear relationship between the radiation power and the photo current for the MSM devices, indicating the potential applicability for deep UV sensors.

氮化铝金属-半导体-金属光侦测器则是用In situ metallization制程，利用低温回旋溅镀法在氮化镓/蓝宝石基板上沉积之氮化铝，再直接溅镀金属铝作为指叉电极，比较目前文献制作出来的氮化铝MSM元件，可得到很好的元件金半接面之理想因子1.0125，算出萧特基能障高度为0.916eV，并有很低的暗电流为1.39 pA，提升了元件的特性，使用150 W氘灯入射，光暗电流差距可到两个order，且元件之光电流与入射光功率呈线性，显示所制作之氮化铝MSM元件，很适合针对深紫外光波段侦测。

Establishing the one dimension model of steady heat transfer about semiconductor elements, the result show that the temperature distribution of both n-type and p-type semiconductor are similar and approximately have the linear shape due to small temperature difference and current intensity.

建立了稳态情况下半导体元件的一维传热模型，结果表明n型元件和p型元件内部温度场的分布是相似的，在温度梯度和输入电流较小的情况下，其内部温度场都近似呈线性分布。

An efficent piecewise linear function model is presented, it can be used to analyze chaotic circuits with piecewise linear elements by the general circuit program PSPICE.

本文提出了一种用通用电路分析程序PSPICE对含分段线性元件的混沌电路的模拟方法，采用有效的分段线性函数模型对动态混沌电路进行分析。

According to More Effect,when the Hore component is placed in a gradient field,at the same time the direction of the current is perpendicular to the direction of the voltage,then between the two parallel side face come out the Hore voltage. When Hore component is set in this kind of uni-gradient magnetic field and the electric current is unchanged,the voltage output of Hore component will be proportional to the position of the Hore component in the magnetic field.

根据霍尔效应可知，置于磁场中的霍尔元件若电流方向与磁场方向垂直，则在霍尔元件垂直于磁场和电流方向的两个侧面将产生电势，将霍尔元件置于强度随空间位置线性变化的磁场中，且控制电流恒定，输出就正比于霍尔元件处于磁场中的位置，因此可以用霍尔元件来测量磁场与霍尔元件间的相对位移量。

The anisotropical characteristics of metal rubber elements performed under loadings in different directions were researched, and physical hypothesis were provided for the analysis of inner structure of metal rubber material The main parameters for the analysis of anisotropical performance were confirmed according to the previous hypothesis and tested experimentallyThe results show that variety of the relative heights and the radius of MR elements affect the radial stiffness of MR isolator When isola...

研究了金属橡胶构件在不同方向的载荷作用下表现出来的各向异性，提出了用于分析金属橡胶材料内部结构的物理假设，并根据假设确定了各向异性研究的主要参数，然后通过实验研究进行了验证。实验结果表明，如果改变金属橡胶元件的相对高度，增加径向尺寸可以在很大范围内改变金属橡胶隔振器的径向刚度；要使金属橡胶隔振器的力学特性更近于线性，应让隔振器在径向范围内工作；如果隔振系统中含有多个承受压载荷的金属橡胶隔振器，则可以使其工作在与成型压力方向相垂直的方向。当相同结构和尺寸的钢元件和金属橡胶元件在承受剪切载荷作用时，这两种材料表现出了相同的刚度变化趋势。

At the same time, it can enhance utilization rate of phosphorus for monogastric animals and solve environmental problems as well.Three linearized DNA fragments without selectable marker gene and vector backbone were constructed containing phyA gene with regulation sequences or T-DNA borders or the plasmid borders.

我们构建了仅含有启动子序列、植酸酶基因和终止子序列的线性基因转化元件及其两端分别带有T-DNA边界序列或一段载体序列的不同线性转化元件，不含选择性标记基因和载体骨架序列，采用花粉管通道法对选定的玉米品种进行转化，共计收获的可以检测的种子为20400粒。

Object-Oriented Programming is the most useful mothed to develop software.

叙述了软件设计方法中较为先进的面向对象的程序设计技术，讨论了线性元件库、非线性元件库、有源器件模型库的建立、电路描述语言及程序的结构。

与线性元件相关的网络解释 [注：此内容来源于网络，仅供参考]

accelerometer：加速度计

惯性感测元件采MEMS技术制造已逐渐成为主流,用於估算线性(Linear)速率变化的MEMS加速度计(Accelerometer),以及角度(Angle)速率变化的MEMS陀螺仪(Gyroscope),则为MEMS惯性感测元件的2大主要产品类别.

bilinear transformation：双线性变换

比如,可以采用双线性变换(bilinear transformation)方法将s域(模拟,使用电感、电容元件与/或有源器件)设计的原型滤波器变换为z域(数字,使用增益元件与延迟元件)的数字滤波器.

linear computing element：线性计算元件

线性衰减系数 linear attenuation coefficient | 线性计算元件 linear computing element | 线电流密度 linear current density

signal conditioning：信号调节

不同於类比式的元件,数位式温感元件不需要另外加装其他的信号调节(signal conditioning)或线性化(linearization)电路. 其可直接连到微控制器上,并因此而大幅缩减设计的时间、印刷电路板的面积、以及各种相关的开销及成本. 因此,这种使用IC的温度感测方式,

conductance：电导

电阻元件也可以用另一个参数-电导(conductance)来表征,电导用符号G表示,其定义为线性(linear)定常电阻的伏安特性是一条不随时间而变化且经过原点的直线,如图1-15(a)所示.

linear dichroism：线振二向色性

Linear device 线性元件 | linear dichroism 线振二向色性 | linear dimension 线性尺寸

linear energy transfer：线能量传递

linear element 线性元件 | linear energy transfer 线能量传递 | linear expansion 线膨胀

linear energy transfer：线性能转移

Linear element 线性元件 | Linear energy transfer 线性能转移 | linear expansion 线性膨胀

Lee：abbr. linar expression element; 线性表达元件

linear density recording：线性密度记录

linear circuitry 线性电路 | linear density recording 线性密度记录 | linear device 线性元件