- 更多网络例句与纤维结晶状相关的网络例句 [注：此内容来源于网络，仅供参考]
-
Those sillimanites can not indicate high temperature (corresponding to the temperature of high amphibolite facies) condition.
区内只有少数粗大的针柱状夕线石可能代表高温条件下由纤维状矽线石重结晶所成，具有指示意义。
-
The most perfect models prebiological organisms are fi brous kerite crystals,crystallized in pegmatite voids according to the VLS mecha nism,their shape,structure and composition are very close to those of living org anisms.
前生物有机体的理想模型是纤维状黄绿蛭石，它是按照VLS机制在伟晶岩的孔洞中结晶出来的，其形态、结构和成分与生物有机体十分相似。
-
In addition,p-phenylenediamine could be incorporated into copolymer to make the copolymerhave phenazine or phenazine like cyclic structure,which was proved by thereflectance FTIR spectra of polymer and copolymer.
同时，聚合物的扫描电子显微镜，表明对苯二胺的加入不仅加速了聚合反应，而且由于对苯二胺进入聚合物的骨架引起了聚合物结晶方式的改变使表面形貌有无规则的颗粒状变成纤维状。
-
Adding minor Mn and Cr to Al-Mg-Si alloy can improve the tissue at as-cast treatment. The transformation of the platelike ?
含Mn、Cr相的弥散质点可阻止合金热挤压过程中的再结晶，得到纤维状组织，并促进细小时效强化相β′的析出，从而强化了合金。
-
They can be used for separating the suspension with solid phase particle size of more than 0.1mm and with the concentration of 30-80%, especially suitable for chemical industry and light industry, such as the processing of mirabilite, salt and polassium fertilizer.
适合分离含固相物(结晶状、无定形或短纤维状)粒度大于0.1mm，浓度范围为30-80%的悬浮液。适用于轻工、化工等行业，如芒硝、食盐、钾肥等产品加工。
-
Combined crystallization kinetics analysis obtained via rheometry and morphological observation of crystals growth performed on POM, two different mechanisms of shear-enhanced crystallization for PP/ grafted MWCNTs composites were suggested:(1) at low temperature, strong heterogeneous nucleation plays a dominant role on the. crystallization behavior, which would be saturated at a higher filler content, and the effect of shear-enhanced crystallization was weak;(2) at high temperature, the effect of heterogeneous nucleation was substantially depressed, and the crystallization of the composite was obviously accelerated by pre-shear and the thread-like crystallites were generated earlier than the spherulites.
结合流变测试结果和热台偏光显微镜观察的结晶形貌发展过程，对于PP／G—MWCNTs体系得到了两个不同的剪切影响机理：(1)在低温条件下，强烈的异相成核作用对结晶行为的影响占主导优势，而剪切作用对结晶的影响十分微弱，同时，在填料含量较高是，异相成核作用具有饱和性；(2)在高温条件下，异相成核作用被抑制，复合体系的结晶主要受到预剪切作用的影响，并且纤维状晶体较球晶更易生成。
-
Adding silica sand to cement whose temperature ranges from 110～150℃or maintaining it in 110℃about three days, cement can form the fiber C5S6H5. After temperature above 150℃, it form thick needle C6S6H which can to some extent effectively curb the high-temperature recession of cement strength.
在水泥中加入硅砂时，在110～150温度范围内，或110℃养护时间超过3天，水泥石中分别出现了由纤维针状结晶C5S6H5，温度超过150℃后，又出现粗大针状结晶硬硅钙石C6S6H，这两种产物在一定程度上有效地抑制水泥石强度的高温衰退现象。
-
Some cell dropped into the cavity and became free. Thrombosis or part organization could be seen. The internal elastic layer became thin, disappear or broken. In internal and middle layer existed fibroblasts, fibrocytes and collagen. Some of the wall indicated hyaline change, soomth muscle cell decreased greatly. The massive inflammatory cells invaded the middle and external layer. There were many foam cells in the capsule tissue. Cytoplasm was filled with fatty tissue and cholesterol. some cavities were full of thrombosis. Some thrombosis was fibrosis, the bottom was organization. The surface of the thrombosis existed red blood cell and librae.(2)Elatic fibrila staining: the internal elastic menbrane almost completely disappeared, the intact internal elastic menbran could be seen in the new small vessels.
动脉瘤管壁厚薄明显不均，全层或局部区域显著变薄向外膨出，内皮细胞空泡变性或坏死脱落，部分内皮细胞剥离并突入管腔成游离状，可见血栓形成及部分血栓机化；内弹力板变薄、消失或突然中断；在内膜及中膜部位主要为纤维母细胞、纤维细胞和大片胶原；部分动脉瘤壁呈均质状玻璃样变，平滑肌细胞明显减少；中膜和外膜可见大量的炎性细胞浸润；瘤壁组织有纤维母细胞、纤维细胞、大片胶原成分及较多泡沫细胞，胞浆内充满脂类物质及胆固醇结晶；部分动脉瘤腔内充满血栓，有的血拴已经纤维化，血栓基部机化，血栓表面有红细胞和纤维素。
-
The effects of such parameters as temperature, pH, feeding rate,concentration, [NH_3]_T/_T molar ratio, surfactants and agitation, on the morphology and size of the particles, were studied and conclusions obtained are as follows:(1) The morphology and size of the particles are mainly decided by the species of nickel oxalates present.(2) Speeding up dissolution-recrystallization process benefits the preparation of the particles of being composed of a single species with uniform morphology and high aspect ratio.(3) The variations of nucleation and growth supersaturation under different conditions have definite effects on the morphology and size of the particles.(4) Adding PVP25 at a proper amount is beneficial to the preparation of fibrous nickel oxalate particles with high aspect ratio. 3 The formation mechanism as well as the morphology and size control of fibrous cobalt oxalate particlesThe cobalt oxalate particles with fibre morphology were prepared using CoCl_2 solution and mixed(NH_4)_2C_2O_4, NH_3·H_2O solution by a double jet process.
研究了温度、pH值、加料速度、浓度、[NH_3]_T/_T摩尔比、表面活性剂及其添加量、搅拌等对颗粒形貌与粒度的影响，主要结论为：(1)草酸镍化合物种类是决定颗粒形貌与粒度的最主要因素；(2)提高陈化中溶解—再结晶速度，有利于得到物相单一，形貌规整，轴向比大的粉末；(3)不同条件下，颗粒形核与生长过饱和度改变，也会对粉末形貌与粒度产生一定影响；(4)适量添加PVP25有利于大轴向比纤维状草酸镍的制备。3纤维状草酸钴的形成机理及其形貌与粒度控制采用CoCl_2溶液与(NH_4)_2C_2O_4和NH_3·H_2O混合溶液并流加料合成的方法，研究了纤维状草酸钴的制备。
- 更多网络解释与纤维结晶状相关的网络解释 [注：此内容来源于网络，仅供参考]
-
cellulase：纖維分解酵素
经由离子交换层析法纯化得到B39菌株分泌之纤维分解酵素(cellulase),此酵素分子量约为148 kDa,在60°C、pH6.5条件下,具有同时分解水溶性羧甲基纤维素(carboxymethylcellulose, CMC)与微结晶状纤维素(microcrystalline cellulose)(Avicel)之最大活性.
-
spherulite crystallization：球晶状结晶化
"球晶","spherulite" | "球晶状结晶化","spherulite crystallization" | "球晶原纤维","spherulitic fibril"
-
cholesteatoma：胆脂瘤
胆脂瘤型 胆脂瘤(cholesteatoma)是一种位于中耳内的囊性结构,而非真性肿瘤. 囊的内壁为复层鳞状上皮,囊内充满脱落上皮、角化物质及胆固醇结晶,囊外以一层厚薄不一的纤维组织与邻近骨壁或组织紧密相连. 胆脂瘤由于其对周围骨质的压迫,
-
fibrillar：纤维状的;纤维质的
fibriform 纤维状 | fibrillar 纤维状的;纤维质的 | fibrillar crystals 丝状结晶
-
haematoxylin：苏木精
桑色素(morin)为无色针晶,存在于桑树中,而暴露在空气中的木材则为黄色. 苏木素(brazilin)和苏木精(haematoxylin)为无色针状结晶,存在于豆科苏木中,在碱性条件下氧化,显示红色,利用这种性质,苏木精常用于纤维染色技术中.
-
spherulitic fibril：球晶原纤维
"球晶状结晶化","spherulite crystallization" | "球晶原纤维","spherulitic fibril" | "球晶成长","spherulitic growth"