等长轴的

基本解释 (translations)

equiaxial

与等长轴的相关的网络例句 [注：此内容来源于网络，仅供参考]

Methods: The sign object was put at each acromial end and clavicle end of normal acromioclavicular joint. And then acromioclavicular joint was tested the locations in abducetion+superduct 、 endoduction 、 anteflexion 、 post-extention 、 external and interior rotation by using 3D- laser scanning camera .Computer calculate the rotation of the two sign objects in x 、 y 、 z axis(x delegate clavicle axis,y delegate coronal section ,z delegate sagittal axis).

通过在正常活体肩锁关节的锁骨端及肩峰端分别安装一个激光照相扫描仪的探测端子，3D-激光扫描相机扫描肩关节在做前屈+上举，后伸，外展，内收，外旋及内旋等不同位置下两端子的位置，通过计算机计算出两端子在X、Y、Z轴（X轴代表锁骨的长轴，Y轴为冠状面与X轴垂直轴，Z轴为矢状轴）上的旋转情况。

Methods morphology ,opening,closing and hemodynamicon short axes section of large arteries and on long axessection of aorta were observed.results thickening,calcification ,hemodynamic,morphologic changes of the aortic wall were exacerated with increased age of patients.conclusion cdfi is of great valve in diagnosing bicuspid aortic valve.

重点通过大动脉短轴及主动脉长轴等切面观察二叶式主动脉瓣的形态、回声、启闭及血流动力学情况。结果：随着年龄的增长，瓣膜增厚、钙化、血液动力学、心脏形态学改变逐渐加重。结论：彩超对先天性二叶式主动脉瓣畸形及病变的诊断具有重要意义。

Analyzing the relation between earthquake and structure distortion, main fault belt, crust, upper mantle, ground fracture, hotspring, geotherm, conductance frame, stress state in Guanzhong area is analyzed with earthquake mechanism, isoseismal line, crustal stress measure, fault displacement measure, and simulating test results. Earthquake formation mechanism is discussed with dynamics mechanism in Guanzhong base. There are 3 forces and a good medium environment, which are main reasons caused earthquake happened in Guanzhong area. The first force is NE and NEE level extrusion one which is parallel with long axis of Guanzhong base. The second one is level strain which is vertical with long axis of the base.

对地震与构造形变、主要断裂带、地壳及上地幔、地裂缝、温泉和地热、电性结构等关系进行了分析研究，通过震源机制解、地震等烈度线、地应力测量、断层位移测量及模拟试验等成果，分析了关中地区的地应力状态，从关中盆地的动力学机制，对该区的地震成因机制进行了探讨，认为与关中盆地长轴平行的NE和NEE向的水平挤压力、与盆地长轴方向垂直的水平张力及地幔上涌力三组力的作用，加之壳内高导层这一有利的介质环境，是导致关中地区地震发生的主要原因。

Corolla purple to blue or white or yellow to red, zygomorphic, inside glabrous or puberulent; tube campanulate-cylindric to broadly tubular, sometimes ampliate basally, throat sometimes constricted, 1-4 X longer than limb, 2-8(-12) mm in diam.; limb slightly 2-lipped to 2-lipped; adaxial lip 2-lobed, slightly shorter than to nearly as long as abaxial lip; abaxial lip 3-lobed to 3-sect, lobes equal or subequal, apex rounded to acute.

花冠紫色到蓝色或白色或黄色对红色，左右对称，被微柔毛的里面无毛或；圆筒状的钟状的筒部对宽管状，有时基部，有时缢缩的喉，X长于瓣片，2-8毫米直径；对二唇形有点二唇形的瓣片； 2裂的正面唇，稍短于到近等长于背轴唇；背面的唇3浅裂的到3全裂，裂片等长或近等长，先端圆形的到锐尖。

Methods Nineteen bone impacted and unerupted teeth in 18 cases selected by orthopantomograph were scanned by 3DX-CT with 1.0 mm slice thickness. Images obtained by 3DX-CT (horizontally, sagittally, coronally) were analyzed after multi-plane reconstruction and 3D reconstruction including the angle of the bone axis impacted and unerupted teeth; maximum radius of the coronal teeth; distances between the tooth and the cortical bone around; distances to the neighboring tooth roots and nerve forum canal; the thickness of the bone tissue, etc.

对经曲面断层片筛选出的18例19枚埋伏牙进行牙科三维CT检查，扫描层厚1.0mm，重建后进行图像三维断面显示（包括水平位，矢状位，冠状位），对牙位图像进行分析及测量（包括埋伏牙牙长轴的角度，牙根弯曲度，牙冠的最大径，与骨皮质的距离，与邻牙根、神经孔／管的距离；骨质的厚度、高度等）。

This earthquake caused intensityⅤin Gu angzhou, Sanshui and Zhongshan , the long axis of isoseismic line with intensity about trends NW.

该次地震广州、三水、中山等地的烈度达5°，5°等震线长轴大体呈NW向。

The long axis of the low intensity isoseism of this earthquake is NW-trending, indicating the effect of the NW-trending west Wuyuan Fault.

包头西6.4级地震高烈度区等震线长轴呈NE向，与乌拉山北缘断裂接近，该断裂是包头西6.4级地震的发震构造。2次地震高烈度区长轴与低烈度区长轴走向相差近90 ，这是因为除发震构造外，烈度区还受一组与之交会的共轭断裂活动的影响。1989年大同-阳高6.1级地震，发生在从六棱山腹地向大同-阳高盆地延伸的NNE向大王村-西要泉断裂上，该断裂是大同-阳高地震的发震构造。

The product nearly can be applied to all fire occasions. For vertical turbine fire pump, it's suction immerges into water, the maximal suction height is 30m, it start up rapidly and run reliably. Especially it is suitable for engineering places that water level is below pump installation foundation such as docks, ocean platform, and so on.

立式长轴式消防泵采用独特的立式长轴结构，泵吸入口淹没于水中，泵安装面距液位高度最大可达30m，由于不存在引水问题使得可靠性大大提高，尤其适用于码头、海洋平台等消防水液位低于泵安装面的工程场所。

For the problem of breaking stalk with hit shear type and stubble with double shafts, the principle of press chop type with single shafe and the models of chopping with knife of different radius are put forward.

针对双轴击切式破碎秸秆和根茬所存在的问题，本文提出单轴压切原理和非等长刀切碎模型，并对秸秆切碎灭茬机的关键参数进行了优化设计。

Using harmonic analysis of the calculated tidal level and current, the distributions of co-tidal lines for K1, O1, M2 and S2 are obtained, whose maximum amplitudes can reach 112 cm, 96 cm, 50 cm and 15 cm, respectively. The distribution of the maximum probable current velocities in Qinzhou Bay is basically the same as that of isobaths, and the maximum probable current velocity can reach 200cms^(-1) nearby the Longmen Harbor. It is concluded by the analysis of K1 and M2 tidal current ellipses that the flow is rotating at the mouth of the bay, while its retilinear flow is in the nearshore area, estuaries and channels. The distributions of the major axes are closely related to the topography, and the rotation directions of both constituents are clockwise.

根据模拟结果计算得到了较以往更为精细的钦州湾K1、O1、M2、S2分潮的同潮图，潮汐最大振幅分别为112、96、50和15cm；最大可能流速的分布基本与等深线一致，龙门港附近最大可能潮流流速可达200cms^(-1)；钦州湾的外湾口海域开阔，一般为旋转流，近岸海区及水道、河口等多为往复流，K1和M2分潮流椭圆长轴的分布与地形密切相关，旋转方向均为顺时针，流速极值出现在龙门港区。

与等长轴的相关的网络解释 [注：此内容来源于网络，仅供参考]

blade：叶片

②叶舌(ligule)位于叶鞘顶端和叶片相连接处的近轴面,通常为低矮的膜质薄片,或由鞘口燧毛来代替,稀为不明显乃至无叶舌,在叶鞘顶端之两边还可各伸出一突出体,即叶耳(auricle),其边缘常生纤毛或燧毛;③叶片(blade),常为窄长的带形,亦有长圆形、卵圆形、卵形或披针形等形状,

cross section：横切面

横切面(cross section)是与树干长轴相垂直的切面,亦称端面或横截面. 在这个切面上,可以见到木材的生长轮 、心材和边材、早材和晚材、木射线、薄壁组织、管孔(或管胞),胞间道等,是木材识别的重要切面.

journal bearing：轴颈轴承

滚动轴承(rolling bearing)比轴颈轴承(journal bearing)的转动摩擦阻力小,因此相同的转速下,由于摩擦产生的温度会比较低. 滚珠轴承又有单珠和双珠两种,双珠价格要贵一些,但相比之下却拥有转速高、摩擦系数小、耐高温和低温、使用寿命长、品质稳定等突出优点,

multipolar neuron：多极神经元

(3)多极神经元(multipolar neuron):有一个轴突和多个树突,是人体中数量最多的一种神经元,如脊髓前角运动神经元和大脑皮质的锥体细胞等. 多极神经元又可依轴突的长短和分支情况分为两型:①高尔基Ⅰ型神经元,其胞体大,轴突长,在行径途中发出侧支,

stellate cell：星形细胞

胞体较小,呈颗粒状,包括星形细胞(stellate cell)、水平细胞(horizontal cell)和篮状细胞(basket cell)等几种. 以星形细胞最多,它们的轴突多数很短,终止于附近的锥体细胞或梭形细胞. 有些星形细胞的轴突较长,上行走向皮质表面,

umbel：伞形花序

(5)伞形花序(umbel). 花序轴极短,许多花从顶部一起生出,花柄近等长或不等长,状如张开的伞. 如五加、报春花(Primula malacoides)等. (3)复伞房花序(compound corymb). 花序轴上的分枝呈伞房状,每一分枝上又形成伞房花序.

crystallographic axis：晶轴

结晶学上根据晶轴(Crystallographic Axis)间相互的交角和长度,可以将各种矿物划分为六大晶系,如图. 所谓晶轴是通过晶体中心垂直相对两晶面的假想直线,常为三或四条,长度不等,交角也不一致. 等轴晶系:具有等长的结晶轴三条,垂直一条,水平二条,

equiaxial：等长轴的

equiangular等角的 | equiaxial等长轴的 | equicaloric等热量的

equiaxial：轴长相等的

赤道面观 equatorial view | 轴长相等的 equiaxial | 等细胞的 equicellular

journal bearing：轴颈轴承

滚动轴承(rolling bearing)比轴颈轴承(journal bearing)的转动摩擦阻力小,因此相同的转速下,由于摩擦产生的温度会比较低. <BR> 滚珠轴承又有单珠和双珠两种,双珠价格要贵一些,但相比之下却拥有转速高、摩擦系数小、耐高温和低温、使用寿命长、品质稳定等突出优点,