疲劳极限

词组短语

endurance limit · limit of fatigue · fatigue limit endurance strength · fatigue limit · fatigue value

与疲劳极限相关的网络例句 [注：此内容来源于网络，仅供参考]

The climbing load design method for motor vehicle driving axle half shaft is a computational method recommended by IVECO,which is formed on the basis of driving torque required for a motor vehicle in climbing a 18% gradient of slope and combined with approximate fatigue limit of material.

汽车半轴杆径的坡道载荷设计法，是在IVECO推荐的汽车在18％坡道上所需驱动力矩基础上，融合了材料的近似疲劳极限而成的计算方法。

The experimental results illustrate that at 10 6---10 7 cycles regime, there is no horizontal asymptote in fatigue S--N curves for smooth specimens, so the conventional fatigue limit disappears.

结果表明，它们的光滑疲劳试样S--N曲线在10 6---10 7周期范围内无平台出现，疲劳极限消失。

The author determines the fatigue property in super long life region of the cruciform joint of 16MnR base material of one ...

作者利用瑞士RUMAL电磁高频疲劳试验机测定16MnR板材十字单面焊接接头在超长寿命区间的疲劳性能，并采用标准法和Dixon-Mood法对测得的试验数据进行处理，整理出十字单面焊接接头在超长寿命区间的疲劳极限，这些结果可以为焊接结构的可靠性设计及服务寿命估计提供试验数据基础。

After the fatigue curve with 50% reliability and a few fatigue test results of a crane element have been known, the method, namely JFKC method, in this paper can be used to get the fatigue limiting stress distribution of this crane element quickly, based on the Miner Hypothesis and.

本文在已知某种起重机零件可靠度为50%的疲劳曲线并有了该种零件的少量试件的疫劳试验结果的条件下，以作者提出的修正的曼耐尔假设和抛物线假设为基础，提出了起重机零件疲劳极限应力分布的快速测定法——JFKC*法。

The Parabola Hypothesis corrected by the authors. The authors have used this method on computer to get the bending fatigue test data of carburized and quenched gears and the fatigue limiting stress distribution. Furthermore, the...

然后对渗碳淬火钢齿轮的弯曲疲劳试验数据用JFKC法进行计算，得到了它的疲劳极限应力分布，并对比其相应的成组试验法测定的疲劳极限应力分布进行了分析和讨论。

The semi-low normal distribution membership function of fatigue limit is determined, and the anti-fatigue fuzzy reliability compute formula of rotor is deduced. The fuzzy reliability model of rotor anti-fatigue is set up. Taking an internal shaft of the rotor of aero electric generator for an example, its reliability design can be realized by adopting the anti-fatigue reliability design theory presented in the dissertation.

首次确定出了疲劳极限降半正态分布形式的隶属函数，推导出了转轴抗疲劳的模糊可靠度计算公式，建立了转轴抗疲劳的模糊可靠性模型；以航空发电机转子内轴为例，对其进行了抗疲劳的可靠性设计，并用本文建立的抗疲劳的模糊可靠度计算公式，对其进行了模糊可靠性校核。

Unless otherwise stated in the design brief, the North Atlantic scatter diagram should be used in ULS and FLS for unrestricted world wide operation.

除设计概要中另有说明外，北大西洋散点图应用于非限制全球作业的极限状态和疲劳极限状态。我翻译，我存在！

In this paper, thermograph method which has merits such as accuracy, short time, convenience and economy is applied to determine the fatigue limit of 45# steel from the temperature change, and the heat generation mechanism that resulted in temperature change during the fatigue was researched on.

文中利用具有准确、快速、便捷、低成本等优点的红外热像仪测量了45#钢疲劳过程中的温度变化，对疲劳过程中引起温升的机制进行了探讨，通过对试验数据的分析，实测值在疲劳极限估算值范围内，快速确定了45#钢的疲劳极限。

In practical application item, UIC515 Code is firstly applied for analyzing the complete welded frame by finite element method to get the area with bigger nominal stress and lower fatigue behavior, and then study the hot spot stress fatigue strength evaluation approach of the typical fillet ring joint at the connection of tubular transom and side frame, the plate to plate end weld between side frame web plate and anti-yaw damper hold and the non-close ring end weld at the connection of braking unit hold and tubular transom.

在热点应力疲劳评估时，首先对焊接构架中的环向角焊缝、板间端焊缝以及非闭合环向端焊缝进行简化，得出了相应的几何应力集中系数和热点应力疲劳极限，为热点应力疲劳评估提供了依据。

The rule that governs the moving of fatigue sources from the surface to the subsurface and again to the surface and its influence on the strengthening effect of shot peening are discussed.

探讨了疲劳源由表面进入内部又返回表面的规律性，及其对喷丸强化作用的影响，并提出了内部疲劳极限和表面疲劳极限的概念。

与疲劳极限相关的网络解释 [注：此内容来源于网络，仅供参考]

creep limit：蠕变极限

疲劳极限 fatigue limit | 蠕变极限 creep limit | 持久极限 endurance limit

endurance limit：疲劳极限

endurance failure 疲劳破裂 | endurance limit 疲劳极限 | endurance test 疲劳试验

endurance test：疲劳试验

endurance limit 疲劳极限 | endurance test 疲劳试验 | endurance testing machine 疲劳试验机

Fatigue limit：疲劳极限

fatigue fracture 疲劳断裂 | fatigue limit 疲劳极限 | fatigue loading 疲劳荷载

fatigue endurance limit：耐疲劳极限

fatigue criteria 疲劳判据 | fatigue endurance limit 耐疲劳极限 | fatigue failure 疲劳破坏

fatigue endurance limit：疲劳极限

疲劳 fatigue | 疲劳极限 fatigue endurance limit | 漂白织物 bleached fabric

corrosion endurance limit：腐蚀疲劳极限

corrosion depth 腐蚀深度 | corrosion endurance limit 腐蚀疲劳极限 | corrosion fatigue 腐蚀疲劳

endurance ratio：疲劳比

endurance limit 疲劳极限 | endurance ratio 疲劳比 | endurance test 疲劳试验

endurance strength：疲劳强度

endurance limit 疲劳极限 | endurance strength 疲劳强度 | endurance test 疲劳试验

endurance bending strength：弯曲疲劳极限,交变弯曲强度

endrem || 修内端凸轮,导程凸轮、 | endurance bending strength || 弯曲疲劳极限,交变弯曲强度 | endurance crack || 疲劳裂纹