- 更多网络例句与电阻系数相关的网络例句 [注：此内容来源于网络，仅供参考]
-
Type, resistivity range and desired characteristic such as surface
填充物类型，电阻系数范围和希望的特点，比如
-
Resistance coefficient, with self-adjustment of oxide film and the brushes and commutator to maintain a smooth surface capabilities.
电阻系数大，具有自我调整氧化膜和保持电刷和整流子表面光滑的能力。
-
Shielding must be a set of materials with good mechanical properties and corrosion resistance of the non-magnetic material, in order to reduce the eddy current loss coefficient of resistance to a large selection of materials.
屏蔽套材料必须是具有良好的机械性能和抗腐蚀性能的非导磁材料，为了减小涡流损耗要选用电阻系数大的材料。
-
The dependence of the equivalent resistance coefficient on the applied bias voltage and strain is given.
给出了等效电阻系数随外加偏压及应力而变的依赖关系，得出了介观压阻系数与外应力的变化符合线性关系的结论。
-
The strength and toughness of the nanocomposites are improved because of the addition of anao-Zno. The volume resistance strength and toughness of the nanocomposites are improved because of the addition of nano-ZnO. The volume resistance coefficient is decreased 8×10 times, surface resistance coefficient is decreased 5.7×10^4 times, and the friction coefficient is decreased 29% by adding nano-ZnO. The friction, wear properties, and the antistatic property of MC Nylon 6/ZnO nanocomposite are better obviously than MC Nylon 6. The macro stress of MC Nylon 6 structure is changed by the tensile test so that the preferred orientation of crystal surface (002+202) is more obvious.
纳米ZnO的加入起到同时增强增韧的作用；使体积电阻系数降了8×10^4倍、表面电阻系数降了5.7×10^4倍、摩擦系数降低了29%，MC尼龙6/纳米ZnO复合材料摩擦磨损性能和抗静电性能明显优于MC尼龙6；经过力学拉伸试验的破坏，引起MC尼龙6结构发生宏观应力变化，造成（002+202晶面）产生明显的择优取向。
-
Heat treatment is generally performed by heating to a temperature below 482/538°C (900/1000°F) to obtain a zero temperature coefficient of resistance.
通常的热处理是加热到482/538°C (900/1000°F)以下以得到温度电阻系数为零的指标。
-
It is found that CO2 laser irradiation results in a drsmiatic decrease in the resistivity and remarkable increases in the insulator-metal transition temperature T(subscript P and the temperature coefficient of resistance TCR.
与传统的高温退火类似，经CO2激光辐照后，样品的电阻率从1.3mΩ？cm下降到0.5mΩ？cm，绝缘态－金属转变温度和温度电阻系数分别从255K和7.9%？
-
The best electrostatic results are achieved when the resistivity of the coating is between 25 and 50 megohms per centimeter.
最佳的静电效果是在涂料的电阻系数控制在25-50兆欧/cm时获得。
-
The volume resistance and transparence of nanocomposite films were slightly decreased with the amount of γ-Al2O3 increasing.
由体积电阻系数及光学穿透度分析结果显示，随著奈米γ-Al2O3的含量增加，呈现略为下降的现象。
-
The specific resistance of iron is not so small as that of copper.
铁的电阻系数不如铜的电阻系数那样小。
- 更多网络解释与电阻系数相关的网络解释 [注：此内容来源于网络，仅供参考]
-
fixed resistor：固定电阻
由实验得知任何物质的电阻与其长度(沿电流方向量度)成正比,其截面积(与电流方向垂直的面积)成反比. 电阻器是利用电阻系数较大的物质所作成的. 工作方式可分为固定电阻(Fixed resistor)和可变电阻(Variable resistor)两大类.
-
resistance type potential divider：电阻分压器
resistance tube 电阻管 | resistance type potential divider 电阻分压器 | resistivity 电阻系数
-
resistivity：电阻系数
有关雨滴大小尺寸分布请参考图3. 试验用水应使用品质良好之自来水,以避免阻塞喷嘴,且试验用水应过滤并去除矿物质. 试验用水之酸碱值为6.5~7.2,电阻系数(resistivity)不可小於500Ωm. 有关雨滴大小尺寸分布请参考图3.
-
surface resistivity：表面电阻
表面电阻(Surface Resistivity)又称表面电阻系数、表面比电阻或表面电阻率. 它是表征电介质或绝缘材料电性能的一个重要数据. 它代表了绝缘材料抵抗表面漏泄电流的能力. 其意义为每平方厘米电介质表面对正方形的相对二边间表面泄漏电流所产生的电阻.
-
volume resistivity：体积电阻系数
焊锡的体积电阻系数(volume resistivity)为0.000015 ohm.cm,比胶的0.0006 ohm.cm少得多,表示焊锡通常比胶的导电性好. 虽然无铅焊锡一般在刚性基板上的抗机械冲击比导电性胶更好,但是焊锡在柔性基板上易于应力开裂. 除了有高度柔性的配方之外,
-
volume resistivity：体积电阻率
(30)体积电阻率(Volume resistivity) 也叫体积电阻、体积电阻系数,是表征电介质或绝缘材料电性能的一个重要指标. 表示1cm3电介质对泄漏电流的电阻,单位是Ω.m或Ω.cm. 体积电阻率愈大,绝缘性能愈好.
-
volume resistivity：电阻率
(30)体积电阻率(Volume resistivity) 也叫体积电阻、体积电阻系数,是表征电介质或绝缘材料电性能的一个重要指标. 表示1cm3电介质对泄漏电流的电阻,单位是Ω.m或Ω.cm. 体积电阻率愈大,绝缘性能愈好.
-
variable resistor：可变电阻
由实验得知任何物质的电阻与其长度(沿电流方向量度)成正比,其截面积(与电流方向垂直的面积)成反比. 电阻器是利用电阻系数较大的物质所作成的. 工作方式可分为固定电阻(Fixed resistor)和可变电阻(Variable resistor)两大类.
-
volume resistance：体电阻,体积电阻,体积阻力
volume regulator ==> 音量调整器 | volume resistance ==> 体电阻,体积电阻,体积阻力 | volume resistivity ==> 体电阻率,体积电阻系数=>体積抵抗率
-
resistivity; specific resistance：电阻率;电阻系数
"体积电阻系数","resistivity, volume" | "电阻率;电阻系数","resistivity; specific resistance" | "电阻器","resistor"