- 更多网络例句与电解分析相关的网络例句 [注：此内容来源于网络，仅供参考]
-
By means of investigation of parameters (reactant strengths electrobath voltage reaction time reaction temperature membrane stuff material variety and the additive) in the sulfate and sulphuric acid electrolysis process, and compared the electrolysis process through analyzing several important technique factors, found the optimized parameters of peroxysulphate and peroxysulphuric acid electrolysis preparation.
通过对硫酸铵、硫酸电解过程中各工艺参数(反应物浓度、槽电压、反应时间、反应温度、膜材料、阴极室物料种类、添加剂)的考察，并结合对电解过程中重要技术指标的比较分析，确定了电解制备过二硫酸铵以及过二硫酸的较优条件，为工业化电解制备过二硫酸铵以及过二硫酸提供了可靠的基础数据以及工艺参数。
-
This article analysizes the current situation of EMM,including a review of the eneter prises of this kind.
文章分析了电解金属锰行业清洁生产的现状，对电解金属锰企业在《电解金属锰行业清洁生产评价指标体系》中的水平作了评价，指明了该行业清洁生产的前进道路。
-
The process of electrolytic etching and graining on the surface of Al-Mg-Si alloy has been studied systematically by means of electrochemical measurement.
本文通过电化学测试，系统研究了Al-Mg-Si合金表面的电解刻蚀图纹化过程，并对电解刻蚀表面的形貌、组成及结构进行了分析，结合电解刻蚀过程的理论分析，探讨了Al-Mg-Si合金电解刻蚀图纹化的机制。
-
Because the sapogenin wastewater is highconsistency organic wastewater,we developed the twophase anaerobic digestion with three stages that acidification phase, inner electrolysis phase and methane phase.
开发了三阶段两相厌氧工艺即酸化、内电解、厌氧产甲烷的工艺处理皂素废水。从理论上分析了该工艺处理黄姜皂素废水的机理和优势。在实验条件相同时，改变内电解在工艺中的位置进行间歇式厌氧处理，测得2种厌氧工艺的处理效果。实验结果表明内电解在两相厌氧中间CODC r的去除率要优于内电解在酸化前
-
Content The course begins with an introduction to features, applications and trends of electroanalytical methods.
本课程共分七章，第一章绪论主要介绍电化学分析法的种类、特点、应用和发展趋势，第二章介绍该方法的基本理论，随后几章分别讨论电导分析、电位分析、电解分析和库仑分析、极谱分析等内容。
-
Analyzing basic characteristics of aluminium electrolytic capacitors we have discussed performances of high-frequency low-impedance poleless aluminium capacitors, have developed new operating electrolyte s and selecting appropriate materials we have made high-frequency low-impedance poleless aluminium electrolytic capacitors with maximum temperature 85℃ and lifetime 3000h.
从铝电解电容器的基本性能分析入手，对高频低阻抗无极性铝电解电容器的特性进行了分析和讨论，开发出新型的工作电解液，并选择合适的材料，研制出了可用于85℃，3000h的高频低阻抗无极性铝电解电容器。
-
Oxidizing feature which is oxidizing leaching of every element, studied kinetics of anode oxidation, analyzed oxidizing slag with XRD and SEM during suspension electrolysis of zinc sulphide mine. The results show that zinc sulphide concentrate in different suspension electrolysis solution can be oxidized. However, the ore in zinc sulphide, ammiaonia sulfate and sulfuric acid suspension electrolysis solution can be oxidized obviously and has better oxidation rate.
确定了硫化锌矿悬浮电解时的电解液后，我们又对硫化锌矿在悬浮电解过程氧化特征即矿物氧化时其中各元素的氧化溶出情况进行分析，对阳极氧化进行了动力学研究，对氧化渣进行XRD和SEM分析，以了解其含锌矿物在悬浮电解过程中的氧化规律，还进行了渣中元素硫的回收。
-
We put zinc sulphide mine into different sulphate system and analyzed polarization curve about anodic oxidation.we found that the mine was oxidized effectively and the rapid oxidation happened when we adopted the zinc sulphide ore suspension electrolyte which contained ZnSO_4,(NH_4)_2SO_4 and H_2SO_4. This system was suffice to product metal zinc industrially. The appropriate suspension electrolyte composition consisted of zinc 90～130g/l,(NH_4)_2SO_430～50g/l, H_2SO_430～50g/l, suspension electrolysis temperature 50℃, anodic oxidation potentiometer 0.6～0.8V.
研究了硫化锌矿在不同的硫酸盐体系中的溶解，通过阳极氧化极化曲线进行分析，得出当以硫酸锌、硫酸铵和硫酸作为硫化锌矿悬浮电解液时，矿物能够有效地被氧化，氧化速度最快，能满足工业上生产金属锌的要求，并且合适的悬浮电解液组成为：锌90～130g/l，硫酸铵30～50g/l，硫酸30～50g/l，悬浮电解温度40～50℃，阳极氧化电位0.6～0.8V。
-
After the research of anodic oxidation slag, we got the composition of the suspension electrolyte of zinc sulphate solution. 2 The results of electrode kinetic of anodic oxidation showed that the electron transfer during the process of electrochemical oxidation was 1, and the electrochemical mechanism was: ZnS=Zn~(2+)+S~-+e Zn~(2+)+2S~-=ZnS + S~0 3 The flow sheet which can produce zinc according to suspension electrolysis principle in industry was put forward. 4 Elemental sulfur in oxidizing slag was recovered by distillation.
本文的创新点是： 1提出了以硫酸锌溶液为基础的悬浮电解液体系；通过对阳极氧化渣进行系统的分析研究，得出了硫化锌矿物的悬浮电解的电解液组成； 2通过阳极氧化电极过程动力学分析得到，电化学氧化过程中电子转移数为1，电化学机理为： ZnS=Zn~(2+)+S~-+e Zn~(2+)+2S~-=ZnS+S~0 3提出了工业上利用悬浮电解原理生产金属锌的工艺流程； 4对氧化渣中的元素硫采用蒸馏法原理进行回收。
-
This thesis has chosen the H_2SO_4 anode oxidation. From degreasing, alkaline cleaning, neutralization, the effect of surface before hand treatment on the quality of surface anodizing treatment is discussed. From electrolyte concentration, electrolyte temperature, voltage, timing, additive, the effect of anodizing oxidation on the quality of surface treatment are discussed, From hole sealing liquid composition pH, value, timing, the effect of hole sealing on the quality of surface oxidation treatment are examined.
对氧化的各个工序进行了较详细的分析，通过脱脂、碱蚀、中和等表面预处理进行了详细的研究讨论，确定了三个预处理工序的最佳工艺控制参数；从阳极氧化机理着手，对阳极氧化电解液浓度，氧化电解液温度，氧化时间、电流密度，氧化电压，添加剂等对氧化质量的影响因素进行了分析；对化学氧化工艺进行了传统的铬酸盐-磷酸盐氧化法正交实验研究，讨论了各个氧化液成分对氧化膜性能的影响。
- 更多网络解释与电解分析相关的网络解释 [注：此内容来源于网络，仅供参考]
-
electrochemical corrosion：电解腐蚀
electrochemical analysis 电化分析 | electrochemical corrosion 电解腐蚀 | electrochemical equivalent 电化当量
-
ductility：延展性
镀铜是一个比较稳定的工序,二十年来镀铜在覆盖能力(Throwing Power)、均匀性(Uniformity)、延展性(Ductility)等方面不断改进. 尽管很多镀铜槽液无需过多的维护,但为了保持镀层的高质量和一致性等,还是要分析电解液的4个成分:
-
electroanalysis：电解分析
electrical sheet 电工钢板 | electroanalysis 电解分析 | electrobrightening 电解抛光
-
electroanalysis：电解分析=>電気分析
electroanalgesia apparatus 电止痛设备 | electroanalysis 电解分析=>電気分析 | electroanalyzer 电分析仪
-
constant current electroanalysis：恒电流电解分析
constant current dynamo 恒流发电机 | constant current electroanalysis 恒电流电解分析 | constant current generator 恒流发电机
-
constant current electroanalysis：恒流电解分析
constant current | 恒流 | constant current electroanalysis | 恒流电解分析 | constant current feeding | 恒流供电
-
electrochemical analysis：电化分析
electrochemical action 电化酌 | electrochemical analysis 电化分析 | electrochemical corrosion 电解腐蚀
-
electrodeposition analysis：电沉积分析
electrodeposition 电解沉积,电附着=>電着,電析 | electrodeposition analysis 电沉积分析 | electrodeposition method 電着法
-
Electrolytic Analyzer：电解分析仪
electrolytic analysis | 电解分析 | electrolytic analyzer | 电解分析仪 | electrolytic arrester | 电解避雷器
-
electroaffinity：电亲合力
electroanalysis 电解分析 | electroaffinity 电亲合力 | electroadsorption 电吸附