- 更多网络例句与电池充电器相关的网络例句 [注：此内容来源于网络，仅供参考]
-
This paper NCP1207 (switching power supply chips PWM control)+ S3F9454 (charger chip integrated management control of) the principle of the Ni-cd, Ni-MH battery charger for the working principle of the system design and analysis, intelligent fast Ni-cd, Ni-MH battery charger of the design process, and in the mature Ni-cd, Ni-MH battery charger on the basis succeeded in achieving effective in preventing Ni-cd, Ni-MH battery charge in the case of fast The charge-off phenomenon.
本文结合NCP1207(开关电源PWM控制芯片)+ S3F9454(充电器集成控制管理芯片)的原理对Ni-cd、Ni-MH电池充电器的工作原理进行了系统的开发设计及分析，实现快速智能Ni-cd、Ni-MH电池充电器的设计过程，并在成熟Ni-cd、Ni-MH电池充电器基础上，成功地实现了有效地防止Ni-cd、Ni-MH电池在快充情况下的过充现象。
-
Alloy frame, Double Wall Alloy tire circle, Dishing brake, forging suspension front fork, Alloy adjustable handlebar stem with gears, alloy handle, alloy retroflex saddle tube, alloy adjustable rack, middle parking rack, Alum-plating electric mudgurads, alloy cranks, 1.75 glisten tires. SHIMANO 6-speed chains linker, SHIMANO gearlever, spring saddle,24V.9AH/13AH battery, intelligent meterplate, LED front and rear lights, 3-grade Electric Assist Driving System（1st,Bike;2nd,1:1 Standard Riding Pull-assist; 3rd,Strong Pull-Assist） 6-grade Manual speed changes,1.8A NiMH Battery chargerAlloy Power-cut Brake handle
描述： 6061#铝合金高强度车架，铝双层车圈、前后碟刹、铝前花鼓、锻造铝合金减震前叉、有牙铝合金把立、铝合金把横、铝合金翻转鞍管、铝合金可调节衣架、中支撑、铝合金曲柄，镀铝导电型前后泥板、1.75反光轮胎、禧玛诺外6速拨链器、禧玛诺变速杆、弹簧减震坐垫、9AH/13AH镍氢电池、智能仪表盘、LED照明前灯、后LED灯、三档电动助力驱动系统（一挡、自行车；二挡、1：1标准骑行助力；三挡、强助力）、6档机械变速、1.8A镍氢电池充电器、全铝断电刹车握把。
-
The best solar battery chargers are flexible, thin-film solar cells .
最佳太阳能电池充电器是灵活的，薄膜太阳能电池。
-
Products include: Bluetooth headsets, walkie talkie, cell phone batteries, camcorder batteries, laptop batteries, battery chargers, car cell phone charger and cell phone with the people launching a series of pieces of more than 800 kinds of products.
系列产品包括：蓝牙耳机、对讲机、手机电池、摄像机电池、笔记本电脑电池、电池充电器、手机汽车充电、及手机配民件等八大系列800余种产品。
-
Deltran SuperSmart Battery Tender Plus 12-Volt 1.25 AMP Battery Charger Constantly monitors the battery without the damaging effects of trickle chargers- a trickle charger will eventually boil dry or overcharge a battery Battery Tender Plus' voltage output compensates for temperature changes- providing additional protection Initial charge brings battery to full charge at approximately 14.2V After full charge is reached- converts to float charger and monitors battery at 13.2V Although a constant charge is being applied to the battery- there is little or no current (approx. 10mA) Periodic maintenance is recommended- but Battery Tender can monitor a battery for years without the fear of boiling or destroying the battery Optional pouch for safe and easy storage or transportation 12V Battery Tender Plus has fused quick-disconnect rings with a weather cover Photo's are for reference only.
Deltran SuperSmart电池投标加12伏直流电1.25腺苷电池充电器不断监测电池的破坏性影响涓流充电器一个涓流充电器，最终将沸腾干燥或过高的电池电池投标加'输出电压补偿温度变化提供额外的保护初始充电电池将全面负责在大约14.2V完全充电后达成，转换为浮动充电器和电池监测13.2V虽然恒电荷正适用于电池很少或没有电流定期维修建议，但电池投标可以监测电池多年而无需担心沸腾或破坏电池的任择邮袋的安全和方便储存或运输12V的电池投标融合加了快速环断开与天气覆盖了图片是供参考仅仅。
-
I have heard anodizing can be done using a car battery charger, but I have not tried this, so I am not sure what exactly the requirements are for the charger.
我听到阳极氧化可以使用汽车电池充电器，但是我还没有尝试的，所以我不能肯定，究竟要求的充电器。
-
6 Batteries, as described in 4.25.10, and battery chargers.(1) Battery connectors must be constructed of material with a V-0 flame rating or have a glow wire ignition rating of 750°C.(2) The battery charging system shall not present a risk of fire due to a short-circuit condition applied to any point in the length of a charger/battery interconnecting cable when tested inaccordance with 8.19.7.(3) During charging, battery-charging voltages shall not exceed the recommended charging voltages when tested in accordance with 8.19.6.(4) Battery chargers must be certified to the appropriate current national standard, for example UL, CSA, or equivalent standards body. 8.19.6 Battery Overcharge Test—Each battery shall be charged with its intended charger continuously for 336 h. The test shall not result in the release of electrolyte, or cause explosion or fire. 8.19.6.1 If the battery can be charged in the vehicle, place the battery in the vehicle and connect it to the charging circuit. Drape the charger, cable, and battery with a double layer of cheesecloth. The test shall not result in ignition of the cheesecloth or in the release of electrolyte.
4.25.10.6 电池(如4.25.10中的描述)和充电器(1)电池的连接器必须是使用UL94V0防火等级的材料做成的，或使用燃点为750度的发热线(2)按照8.19.7测试时，当在充电器和电池间的导线上的任意一点发生短路时，电池充电系统不允许出现着火的危险(3)充电时，按照8.19.6的测试方法，充电电压不允许超过推荐的充电电压(4)电池充电器必须通过相应的现行国家标准的认证，比如UL，CSA或等同的标准机构 8.19.6电池过充测试---每个电池都需要采用其默认的充电器连续充电336小时，测试不允许导致电极的泄露，导致爆炸或火灾 8.19.6.1若电池可以在交通工具上使用时，将电池放到交通工具上，并将之与充电电路连接起来，用双层粗棉布将充电器，连接线和电池遮挡起来。
-
This article introduce one kind of the method that monolithic integrated circuit programming to control nickel cadmium cell intelligence battery to charger integrated circuit principle, and produce the nickel cadmium intelligence battery charger practical application electric circuit which this chip constituted.
本文介绍了一种用单片机编程控制的镍镉电池智能充电器集成电路的原理，并给出了使用该芯片所构成的镍镉智能电池充电器的实际应用电路。
-
Input Power Factor Correction: The rectifier shall be power factor corrected so as to maintain an input power factor of 0.98 lagging to unity at all load levels to ensure generator compatibility and avoid reflected harmonics from disturbing loads sharing the utility power.
UPS模块的设计须可使之作为双变换和在线反向输送系统在下列模式下正常工作。A。正常模式：逆变器须可不断向临界负载输电。整流器/电池充电器须从交流电源获取电能并向逆变器供电，同时以浮动方式给电池充电。
-
PWM-controlled single-chip switching power supply lithium-ion battery chargers, effectively overcome the general charge, under-charging, low efficiency of the shortcomings, the charger for charging the overall management process, To be completed by pre-charge, fast charge and trickle charge function of the basic charge and battery safety monitoring functions and display functions, the realization of the intelligent charging, and to ensure that the charging effect .
PWM 控制的单片开关电源式锂电池充电器，有效地克服了一般充电、充电不足、效率低的缺点，该充电器对充电过程进行全面管理，可完成预充电、快速充电和涓流充电的基本充电功能和电池安全监测功能以及显示功能，实现了智能化充电，且保证了充电效果。
- 更多网络解释与电池充电器相关的网络解释 [注：此内容来源于网络，仅供参考]
-
die Batterie：电池
电池充电器??das Akku-Ladegeraet | 电池??die Batterie | 威士忌杯??der Whiskybecher
-
battery charger：电池充电器
公司目前主要业务为从事荷兰VICTRON逆变电源(INVERTER)、蓄电池充电器(BATTERY CHARGER)等电源产品 和意大利波特力POTERE UPS等相关产品的分销与技术服务,VTN品牌逆变电源、蓄电池充电器广泛应用于船舶、游艇、特种汽车、太阳能、风能等领域.
-
Ni-Cd battery charger：镍镉电池充电器
nibbling forceps 持针钳 | Ni-Cd battery charger 镍镉电池充电器 | nick 刻痕,凹痕
-
solar battery charger：太阳能电池充电器
solar battery array 太阳能电池阵 | solar battery charger 太阳能电池充电器 | solar battery measuring instrument 太阳能电池测试仪
-
BYC battery charger：电池充电器
BRKG breaking 断开 | BYC battery charger 电池充电器 | CA compressed air 压缩空气
-
battery holder：电池盒
"Battery Snap","电池扣",199052 | "Battery Holder","电池盒",199053 | "Solar Car-Battery Charger","太阳能汽车电池充电器",199054
-
Battery Holder, Battery Snap：电池盒及电池扣
"Dry Batteries Accessory","乾电池附属设备",199078 | "Battery Holder, Battery Snap","电池盒及电池扣 ",199079 | "Batteries Charger","电池充电器",199080
-
battery eliminator：等效电池
battery charger 电池充电器 | battery eliminator 等效电池 | battery pack 电池包;电池组件
-
Battery, Cell, Charger, and Module：电池,充电器及相关模组
1976 半导体生产设备 Semiconductor Production Equipment | 1990 电池,充电器及相关模组 Battery, Cell, Charger, and Module | 1999 其他消费性电子及电器产品 Other Consumer Electronics & Electrical Product...
-
Battery Chargers：电池充电器
090218 电池 Galvanic cells | 090266 电池充电器 Battery chargers | 090083 电池充电器 Chargers for electric batteries