- 更多网络例句与点火状态相关的网络例句 [注：此内容来源于网络，仅供参考]
-
The output torque and power kept steady as the engine operated under brief rich cursions through control of spark advance angle and throttle opening.
当发动机短时间工作在富燃状态时，通过控制节气门开度和点火提前角，可以获得稳定的功率和扭矩输出。
-
TPS the throttle valve position perceptron, this equipment might provide accelerator's immediate material to come with material and so on speed by engine revs to make the comparison judgment at that time engine's load conditions, adjusted engine's ignition angle of advance, obtained the good combustion efficiency, obtained the high power, and could achieve the province oil the effect, but the cost more then CDI .
TPS节流阀位置感知器，此装置可以提供油门的即时资料来跟引擎转速等资料作比较判断当时引擎的负荷状态，调整引擎的点火进角，来获得较佳的燃烧效率，获得较高的动力，并能达到省油的效果，但是成本比CDI来的高。
-
Data inspecting, saving, monitoring parameters real-timely and modifying injection and ignition parameters factitiously can be realized by communicating with ECU via RS-232C serial interface. Analyzing data, obtaining the best work nodes and drawing maps can also be realized by this system.
该系统使用RS-232C接口与自行开发的电喷系统的电控单元ECU进行通信，实现数据实时采集、保存、监控、在线修正的功能，并可以对采集的数据进行分析，获得各工况最佳工作状态点，绘制喷油和点火提前角MAP图，为实现电喷发动机的精确控制提供参考。
-
In the causal chain model,the unsteady state of t...
在因果连锁模型中把社会环境不稳定状态视为"燃烧物质"，而信息熵视为"助燃剂"，群体性突发事件视为"点火温度"。
-
The introduced techniques include changing the state of firebox in lamellar sample and the state of the sample in firebox, changing oxygen pressure in firebox and adjusting operation mode of rotating key which controls the electrical current of portfire.
该文分析了燃烧热测定实验常见的失败原因，并针对其中的主要原因，提出了 4点改进方法，即改变燃烧丝在片状药品中的状态和位置，改变药片在氧弹内坩埚中的状态，改变氧弹内氧气的压力值和改变点火电流控制转钮的操作方式。
-
Experimental results of G-type primer in a 100ml closed bomb show that this system is reliable and can quantitatively reflect primer ignition capability.
经对 G 型底火在 100 ml 爆发器内的试验结果表明，该系统测试方法可靠、结果稳定、能够定量反映底火点火能力状态。
-
The research contents of this subject are mainly: Proposing the overall scheme of the soft firing technology, than confirm the best scheme; On the basis of best scheme , set up the mathematical model of soft firing system, and set up the interior ballistic trajectory calculating model among MATLAB/Simulink, set up soft the three-dimensional dynamics model of firing system among ADAMS; Go on joint simulation, simulating the characteristic curve of bore pressure and the sport law of piston and shot; Through adjusting the parameters such as piston quality、the diameter of unilateral valve、 charge weight、charge form coefficient and the delay time of lighting fire etc to make the soft firing system reach the best state of dropping the composition of forces of gun bore and increasing initial velocity of pill.
论文的研究内容主要是：提出软发射技术总体方案，确定最佳方案；在最佳方案的基础上，建立起软发射系统的数学模型，并在MATLAB/Simulink中建立内弹道计算仿真模型，在ADAMS中建立软发射系统的三维动力学模型；进行联合仿真，模拟膛压特征曲线及活塞和弹丸运动规律；通过对活塞质量、单向阀直径、装药量、药形系数、点火延迟时间等参数进行调整，使软发射系统达到炮膛合力下降、弹丸初速提高的最佳状态。
-
The traditional refitted ignition products (for example, high-pressure cylinder line without diffraction, refittedly-complicated products that mix the spark plug and ignition power) are the primang products with no dynamic adjusted ability, which can't meet different requirements of motor under different conditions, thus impossibly causing the motor to be in the best condition.
传统点火改装产品（如：无内阻高压缸线、改装用火花塞及仿冒点火王动力复合仪等产品）均为无动态调节能力的初级改装产品，无法动态满足发动机在不同工况下的不同需求，因而无法使发动机持续工作在最佳状态。
-
Its battery protection system is capable of protecting itself at low voltage. Its engine state identification system can start heating and refrigerating when the vehicle engine starts. The water dispenser is Freon free and is environment friendly.
不怕路面颠簸等优点，卓越的电瓶保护及引擎状态识别系统，可在低电压时自动保护，发动机点火后自动工作，采用无氟制冷剂绿色环保节能高效，超大容量制冷。
- 更多网络解释与点火状态相关的网络解释 [注：此内容来源于网络，仅供参考]
-
Output State Check：输出状态检查
Orifice Spark Advance Control System 细孔点火提前真空控制系统 | Output State Check 输出状态检查 | Over-Temperature Control System(/) 超温过热冷控制系统
-
OSC Output State Check：输出状态检查
OSAD Orifice Spark Advance Control System 细孔点火提前真空控制系统 | OSC Output State Check 输出状态检查 | OTCS Over-Temperature Control System 超温(过热/冷)控制系统
-
power loss：功率损失
这将使系统置于"跛行"(limp-in)方式,功率损失(power loss)灯点亮. 如果系统工作正常,在怠速状态下逻辑模块将连续改变正时,以维持平衡的怠速运转. 在"跛行"方式中,点火正时是由逻辑模块确定的,这种状况对检查基本点火正时必不可少.
-
.st：起动
而不是保持正常运行的最佳性能.在简易控制中,ECU输出的燃油喷射信号和点火信号为一固定值,取代微机正常控制时的最佳喷射信号和最佳点火提前角.以满足发动机继续运行.后备集成电路(IC),根据起动(ST)信号和怠速(IDL)触点状态,
-
ignition timing：点火正时
通过准确了解引擎的燃烧状态,可在保持良好燃烧状态的情况下以1/10000秒为单位对点火正时(Ignition Timing)进行控制. 检测火焰中离子的原理已经应用于燃气设备的安全燃烧装置中. 由此,就能在确保引擎性能的条件下,向催化剂输送温度更高的尾气,
-
Unlocked：未锁门的
gain entry 进入 | unlocked 未锁门的 | in the ignition (汽车引擎)在点火或发动状态