- 更多网络例句与滑动量相关的网络例句 [注：此内容来源于网络，仅供参考]
-
Owing to that the main shaft speed and the beating speed of reed can not attain the normal values at setting - on, the warp tension and the beating force of the reed can neither reach the normal level.
织机开关车时由于主轴转速、钢筘打纬速度达不到正常数值，使经纱张力及钢筘打纬力达不到一定的正常数值，以致打纬过程中经纬纱线相对滑移量比织机正常运转时的数值小、共同移动量比正常运转时的数值大，所形成的织物达不到正常的纬密，在织物上产生横档疵点。
-
Owi ng to that the main shaft speed and the beating speed of reed can not attain the norma l values at setting-on, the warp tension and the beating force of the reed can neither reach the normal level. Therefore, the relative slippage movement of the weft against the warp du ring beating will be less, while the common movement of the weft together with the wa rp will be bigger than those at normal running. As a result, the setting-on place is the n caused by the normal density not being obtainable in the woven fabrics.
织机开关车时由于主轴转速、钢筘打纬速度达不到正常数值，使经纱张力及钢筘打纬力达不到一定的正常数值，以致打纬过程中经纬纱线相对滑移量比织机正常运转时的数值小、共同移动量比正常运转时的数值大，所形成的织物达不到正常的纬密，在织物上产生横档疵点。
-
It is difficult to measure the static friction coefficient of the material like polyurethane. The state of friction under very low velocity with small sliding distance is a special state between static and dynamic friction. This state of friction can be called initial stages'friction.
聚氨酯弹性体材料的静摩擦系数是比较难以确定的，本文建议把滑动量较小而滑动速度又很低的这一时期的摩擦称为"初期摩擦"，它是界于静摩擦与动摩擦之间的一种特殊的摩擦状态。
-
With Simulink, you can move beyond idealized linear models to explore more realistic nonlinear models, factoring in friction, air resistance, gear slippage, hard stops, and the other things that describe real-world phenomena.
藉由 Simulink ，你能超过理想化线性的模型移动探究比较现实的非线性模型，磨擦，空气阻力，齿轮滑动量，硬式障碍物的贷款保收，和描述真实的现象其他的物。
-
When the hand rolls, the tilt sensor on the metacarpus detects the rolling angle which determines the orientation of the direction line of the cursor movement.
本研究手套滑鼠操作是以倾斜度感测器取得手盘翻转的角度变化，再由弯曲度感测器决定移动量的大小。
-
Research on deep anti-sliding stability and reinforcement of entirety polygonal line gravity dam;2. The 2D Elastoplastic Finite Difference Method is adopted to analyze the deep anti-sliding stability for the dam foundation of Longkou hydropower station factory dam.
采用二维有限差分程序对龙口水利枢纽混凝土重力坝厂房坝段进行深层抗滑稳定分析，采用强度折减方法，根据特征点位移突变临界破坏判据和止水帷幕部位夹层错动量达到1mm临界破坏判据分别得出了厂房坝段的两个深层抗滑稳定安全系数。
-
To the single axis control model of the stabilized platform, the sliding mode rule is founded. The value of extraneous disturbances is estimated by using GM (1, 1) grey prediction algorithm, and then it is added to the sliding mode control rule as the compensating part. At the same time, the value of the switching function is predicted by the grey prediction method, by which the control chattering phenomenon is reduced greatly.
基于稳定平台的单轴控制模型，设计了滑模控制律，采用GM(1，1)灰色预测算法估计扰动量，将其作为控制律中的补偿分量，同时应用灰色预测方法对滑模控制策略进行预测输出，有效地减弱了滑模控制的抖动现象。
-
It is found that the off west coast of South Island of New Zealand earthquake has several basic characteristics as follows:① Moment magnitude is about M 7.8; Rupture duration time is about 40 s;② The static slip distribution is simple and the whole rupture process contains only one slip concentrated patch; This earthquake is mainly a unilateral rupture event with the rupture propaga ting southwestward.
结果表明。这次新西兰南岛西海岸近海地震的破裂过程具有如下基本特征：①矩震级约为M7.8；②地震主要破裂持续时间约为40 s；③滑动量在断层面上的分布比较简单，整个地震破裂只包含一个滑动量较大的区域；④这次地震基本上是一次单侧破裂事件，破裂主要朝向西南方向。
-
The effect of heattreatment on bonding strength of the Cu./Al bimetal interface was also investigated. When the semicone angle or the percent reduction goes up, the relative slide will also increase. Suitable diffusion heattreatment can improve the bonding strength.
试验结果表明，过大的锥形模半模角α和过大的断面减缩率r％，均会加大铜和铝之间的相对滑动量；合理的扩散热处理制度可以进一步增大Cu／Al双金属界面的结合强度。
-
Some of the indirect informations such as the relative slip of friction pairs and the variations of friction force were also obtained in this test.
文章指出，利用这种测录仪还可得出一些间接的信息，如摩擦副的相对滑动量和试验过程中试样摩擦力的变化等。
- 更多网络解释与滑动量相关的网络解释 [注：此内容来源于网络，仅供参考]
-
extensometer：伸缩仪
若藉由最小读数[0.0025mm][ ]之伸缩仪(Extensometer)所量测到的钢材滑动量小於[0.025mm][ ]时,则该试验将满足要求. 量测对象为下层最突出之钢材. A. 将振动马达(Vibratory Motor)安装在钢轨上,该马达在频率[2,850cpm][ ]下足以输出[2,
-
slinger ring：挡油环
sliding door 趟门 | slinger ring 挡油环 | slip 允许滑动量