- 更多网络例句与涂树脂于相关的网络例句 [注：此内容来源于网络，仅供参考]
-
Methods: Podophyllum resin was applied on the warts,then inject BDG polysaccharide and nucleic acid injection 1ml/qod for 18 times.
鬼臼根树脂溶液涂于疣体处，肌注卡介菌多糖核酸注射液，每次1ml，隔日1次，18次为一个疗程。
-
Methods: Podophyllum resin was applied on the warts,then inject BCG polysaccharide and nucleic acidinjection 1ml/qod for 18 times.
鬼臼根树脂溶液涂于疣体处，肌注卡介菌多糖核酸注射液，每次1ml，隔日1次，18次为一个疗程。
-
Objective:To observe the effectiveness of BCG polysaccharide and nucleic acid injection and podophyllum resin on condyloma acuminatum.Methods: Podophyllum resin was applied on the warts,then inject BCG polysaccharide and nucleic acid injection 1ml/qod for 18 times.
目的：观察卡介菌糖核酸注射液联合鬼臼根树脂溶液治疗尖锐湿疣疗效方法：鬼臼根树脂溶液涂于疣体处，肌注卡介菌多糖核酸注射液，每次1ml，隔日1次，18次疗程。
-
Specifically, it is applicable to the production of dissolvent type of coating materials such as formaldehyde phenol resin, alkide resin, epoxy resin, epoxy polyester and acrylic resin as well as water-soluble resin coating materials such as highly adaptable water-soluble epoxy ester dipping paint.
适用于酚醛树脂、醇酸树脂、环氧树脂、环氧聚酯以及丙烯酸树脂等溶剂型涂料以及各种水溶性树脂涂料（如：高适应性水性环氧酯浸涂漆等）；还可应用于厚浆型涂料、粉末涂料、有机钛防腐蚀涂料、带锈涂料和沥清漆、富锌底漆、防火涂料、耐热涂料等。
-
Two series of polyurethane acrylate grafted acrylic resins (Acr-g-TPU-PETA and Acr-gPPU-PETA) self-emulsifying systems are obtained by grafting -NCO group modified polyurethane acrylates with acrylic copolymer prepared from n-butyl acrylate, styrene,βhydroxyethyl methacrylate and acrylic acid The self-emulsifying systems showed Newtonian fluidity with viscosity closed to that of water, the solid contents were around 30% The T〓 of 15～4℃ for dried film before photocuring favored film formation at room temperature DSC and DMA results showed that PU-PETA is compatible with acrylic resin in the grafted resin The TG and dTG curves for Acr-g-PU-PETA samples were substantially different from the corresponding blends, and the brodened dTG peaks for photocured grafted resin suggest that there might be multiple interactions among chain segments The photocued film of the grafted resins self-emulsifying system exhibited good overall properties with polyurethane acrylate grafts ranging from 30% to 50%, and Acr-g-TPU-PETA series showed better properties than Acr-gPPU-PETA series The adhesion of the photocured film was 1～2 grade, impact strength was 50kg-cm and flexibility was 1mm The Shore hardness and the adhesion of the film decreased markedly if PETA was replaced by HEMA as photoactive group due to the lower C=C double bond content in the grafted resin The polyhydroxy amine-linked thioxanthones photoinitiators can be evenly dispersed in self-emulsifying system without color spot appearing in the dried film The films photocured with IV〓～IV〓 generally exhibited higher Shore hardness, gloss and solventresistance than that cured with Irgacure 2959 and did not induce the rusting of the iron substrate Pigmenting with titanium oxide had no effect on the photocuring The polyhydroxy amine-linked thioxanthone IV〓 and IV〓 can be new candidates for the formulation of titanium oxide pigmented photocurable water-borne coatings for their pale-yellow appearance and slight interference with the color of the coatings WB 4759 with high water-solubility coalesced and separated from the dried resin film, and even induced the rusting of iron substrate.
以丙烯酸丁酯，甲基丙烯酸-β-羟乙酯，丙烯酸及苯乙烯合成厂丙烯酸共聚树脂，并与含-NCO端基的聚氨酯丙烯酸酯接枝反应，经水性化后，得到两个系列（Acr-g-TPU-PETA和Acr-g-PPU-PETA）各5个不同配比的丙烯酸树脂接枝聚氨酯丙烯酸酯自乳化体系，粘度与水相近，为牛顿流体，固含量30％左右。光固化前干燥涂膜的玻璃化转变温度在-15℃～4℃之间，有利于室温下成膜。DSC及DMA谱表明两种树脂基本相容。Acr-g-PU-PETA的热失重行为明显不同于共混材料，接枝样dTG峰明显宽化，表明接枝样中链段之间的相互作刚有多重性，丙烯酸树脂与聚氨酯之间有一定的相容性。接枝树脂自乳化体系光固化涂层的综合性能以聚氨酯丙烯酸酯成分为50％～30％者相对较好，且以Acr-g-TPU-PETA系列更理想。光固化膜的附着力为1～2级，冲击强度为50kg·cm，柔软性多为1mm。以HEMA代替PETA作为接枝树脂的活性基团，碳—碳双键密度太低，光固化膜交联点太少，硬度和附着力均较差。多羟基胺连硫杂蒽酮光引发剂能均匀分散于树脂自乳化体系和接枝树脂干膜中，不出现色斑，光固化膜肖氏硬度一般高于以Irgacure 2959为光引发剂的光固化膜，光泽度及耐丁酮溶剂性能均有所提高，不会诱导铁基生锈，钛白着色对光固化结果几乎没有影响。本论文所合成的多羟基胺连硫杂蒽酮光引发剂IV〓与IV〓为浅黄色，对光固化涂层的颜色干扰较小，为配制钛白着色光固化水性涂料提供了新的光引发剂。水溶性太强的WB 4759在干膜中易聚结析出，且对所附着的铁基有诱导锈蚀作用。
-
Hisun's emulsion sealer R810 is a sealer based on acrylic resin. Applied on the surface as an ideal primer in paint system.
产品说明 DESCRIPTION 海生牌乳胶封闭底漆R810是一种丙烯酸树脂为基料的封闭底漆，专用于涂在施工表面为整个油漆配套提供一个理想的底漆。
- 更多网络解释与涂树脂于相关的网络解释 [注：此内容来源于网络，仅供参考]
-
isocyanate：异氰酸盐
油墨类型:异氰酸盐(Isocyanate)硬化剂的二液反应型快干性油墨. 用途:有高附着力,适用于经处理的PP、PE、POM涂漆面(特别是聚氯树脂烘涂层)、ABS、聚丙烯酸、聚氯乙烯、尼龙布及其它物料. 外观:半光泽外观,并对溶剂有高抗性(抗性高低随不同颜色而异).