- 更多网络例句与气隙相关的网络例句 [注：此内容来源于网络，仅供参考]
-
This paper analyzes the features of the current transformer with non-magnetic air gap.
同时分析铁心带气隙的电流互感器，总结了铁心有非磁性气隙的特点。
-
The magnetization intensity and direction of AlNiCo PM can be controlled by pulses of d-axis stator current vector.
通过定子直轴电流矢量脉冲控制铝镍钴的磁化强弱和方向，使钕铁硼和铝镍钴产生的磁通共同穿过气隙；或者使钕铁硼产生的磁通部分穿过气隙、部分被铝镍钴在转子内部旁路，利用永磁体的记忆能力使永磁气隙主磁通受控。
-
Near rated point, the equivalent length may be 1.4 times of the designed length, while in some abnormal states, the equivalent length may be 2 times of that.
在额定点附近，等效气隙长度达到设计值的1.4倍，而在临界失稳工况下，等效气隙长度达到后者的2倍以上。
-
A mathemetical model of magnetic field in electromagnetic separation of inclusions from molten aluminum under rectangle coil and 50Hz current is presented according to the magnetic vector potential integral equation and the basic theory of magnetohydrodynamics. The magnetic field distribution in the gap of coils is simulated by the model and the actual magnetic field distribution also is measured. The experimental results show that the magnetic field distribution in the gap of coils is uniform and is consistemt with the model simulation. The magnetic field designed accord the simulated result is proved suitable in the practice.
摘 要：根据电磁流体力学的基本理论，利用矢量磁位积分，建立了在采用矩形电磁线圈和工频电源的条件下电磁分离铝熔体中夹杂的电磁场数学模型，模拟计算了电磁感应线圈气隙中的磁场分布状态，同时对制做的感应线圈的实际磁场进行了测量模拟计算磁场的分布状态与实际磁场的测量结果基本一致，都表明在电磁感应线圈气隙中磁场分布均匀，可以进行分离铝熔体中的非金属夹杂。
-
The four sets of stator bars including those retired from three large generators and the standby bar subjected to Dynamic Mechanical Analysis, Scanning Electron Microscopic and optical microscope observation. It was revealed from DMA that the peak value tan d m of mechanical loss thermogram tan d ~ T shift toward a higher temperature and a lower amplitude, indicating that the amount of movement monomers diminished greatly in the insulation aging process, the tan d 195, increased very slightly with the service time of insulation, showing the degrading of bonding properties at interface, and the presence of more defects in insulation. The observation of SEM and optical microscope showed that more and more voids appears in insulation, and delamination was formed due to development of voids in aging process.
对不同运行年数的线棒进行了 DMA 、 SEM 、光学显微镜等微观分析试验，动态力学分析发现(参见 Hao et al， CEIDP， 2002：404)，力学损耗温度谱 tan d ~ T 的峰值 tan d m 随老化时间向高温、低值方向移动，表明促成环氧发生玻璃化转变的活性侧基或发生局部运动的活性链段减少，分子链的刚性增强；195℃的力学损耗 tan d 195随老化时间有缓慢增大的趋势，表明有更多的能量耗散在界面处，界面的粘合性变差，甚至由于界面粘结不良出现微观缺陷； SEM 和光学显微分析发现(参见 Hao et al-2， IEEE DEI， 2003)，老化后的绝缘气隙增多，随着老化时间气隙不断扩展或相互连通，绝缘逐渐分层。
-
There is no ferromagnetic material in the outside of ironless PM motors airgap. Because of this characteristic, airgap magnetic field of ironless PM motor belongs to 3-dimentions (3-D) open boundary magnetic field. Engineering problem of open boundary magnetic field is a hot research issue in the computation electromagnetics field recently.
无铁心永磁电机气隙外没有铁磁材料，其自身的结构特点决定了无铁心永磁电机的气隙磁场属于三维开域磁场，开域磁场工程问题的计算是近年来计算电磁学的研究热点之一。
-
As a result, the equivalent magnetic flux leakage coefficient and the equivalent air-gap magnetic flux density calculating coefficient, which are important for the motor design, are put forwar.
分别对其气隙磁通密度沿周向和轴向的分布进行了分析研究，提出了该种电动机所特有的等效漏磁系数和等效气隙磁通密度计算系数的概念和计算方法。
-
The direct measure mode is that Hall part is set into the interspace of loop winding or magnet coil, then the magnetism voltage difference or the current is measured.
直测式是将霍尔器件置于具有线圈绕组或直穿母线的环型铁磁体气隙中，测出气隙里的磁压降，即为被测电流。
-
The first control strategy has the disadvantages such as a large amount of computations, inherent pull-out torque, difficulties in realizing the adaptive control and so forth. For the rotor flux-oriented control, changing of load or the rotor speed will result in increased or decreased torque winding currents, which will change the magnetic field distribution in the air gap. Assumption that magnetic field is approximately equal to that generated by torque windings will affect the levitation performances.
分析表明：气隙磁场定向控制中存在最大转矩限制、非线性机械特性，难以实现自适应控制等问题；对转子磁场定向控制而言，当负载或转速变化时，由于转矩控制绕组转矩电流变化将导致气隙磁场发生改变，如果仍以转子磁场近似替代气隙磁场作为悬浮依据，必然影响到悬浮控制性能。
-
The thermal boundary condition of the cast iron cooling stave with surface alloyed steel pipe was used for numerical simulation of temperature field and commercial software ANSYS and the method of coupling heat-structure were used to calculate thermal deformation of steel pipe at high temperature,and analyze the influence of air gap and thermal deformation on the life of cooling stave.The optimal size of air gap and hot load to guarantee long life of cast iron cooling stave were obtained.
根据合金化管铸铁冷却壁热态试验数据确定了合金化管铸铁冷却壁温度场数值模拟的边界条件，利用ANSYS软件、采用热-结构耦合的方法计算了高温状态下合金化管铸铁冷却壁内钢质冷却水管的变形，分析了气隙层和水管热变形对合金化管铸铁冷却壁寿命的影响，得出保证合金化管铸铁冷却壁长寿的最佳气隙层厚度和相应的最佳使用热负荷。
- 更多网络解释与气隙相关的网络解释 [注：此内容来源于网络，仅供参考]
-
gap admittance：气隙导纳
"gap adjustment ","气隙调整" | "gap admittance ","气隙导纳" | "gap ampere turns ","气隙安匝(电机的)"
-
gap admittance：间隙导纳,气隙导纳
gap adjustment | 间隙调整 | gap admittance | 间隙导纳,气隙导纳 | gap ampere-turns | 气隙安匝(电机的)
-
air gap field：气隙磁场
air gap diameter 气隙直径 | air gap field 气隙磁场 | air gap flux 气隙磁通
-
air gap clearance：气隙长度,空气间隙
air gap aymmetry protection 气隙不对称保护[装置] | air gap clearance 气隙长度,空气间隙 | air gap coil 气隙线圈
-
air gap clearance：气隙长度,气隙间隙
air-gap | 空气燃料混合气 | air-gap clearance | 气隙长度,气隙间隙 | air-gap field | 气隙磁场
-
air gap clearance：气隙长度
"air-gap barrier ","气隙隔板" | "air-gap clearance ","气隙长度" | "air-gap coil ","气隙线圈"
-
air gap diameter：气隙直径
air gap coil 气隙线圈 | air gap diameter 气隙直径 | air gap field 气隙磁场
-
air gap induction：气隙磁感应
air gap flux waveform 气隙磁通波形 | air gap induction 气隙磁感应 | air gap insulating cylinder 气隙绝缘筒
-
air gap induction：气隙磁感应,气隙磁密度
air-gap gauge 气隙量规 | air-gap induction 气隙磁感应; 气隙磁密度 | air-gap leakage flux 气隙漏磁通
-
air gap induction：气隙感应
"air-gap inductance ","气隙电感" | "air-gap induction ","气隙感应" | "air-gap insulating cylinder ","气隙绝缘筒"