段长度

词组短语

segment length

与段长度相关的网络例句 [注：此内容来源于网络，仅供参考]

In a 4700 Assembler Language instruction, a method of addressing a field by specifying the segment

在IBM系统4700汇编语言指令中，通过在指令中指明段号、位移量和字段长度以对某一字段进行编址或寻址的方法。

In a 4700 Assembler Language instruction, a method of addressing a field by specifying the segment number, displacement, and field length in an instruction.

在ibm系统4700汇编语言指令中，通过在指令中指明段号、位移量和字段长度以对某一字段进行编址或寻址的方法。

However, more perfect structure of PEO segments is formed when the system exits in semicrystalline-semicrystalline state.3 When the composition of hard segments is 30%, the crystallizability of PETsegments exerts strong influence on the nucleation mechanism and growthdimensions of soft segments.

PEO嵌段的晶体尺寸小，结构不规整，结晶度低；当体系处于结晶—结晶态时，PEO嵌段的晶体结构比较规整，而且此时软段长度对其形态影响也比较大。3硬段含量为30％时，它的结晶与否直接影响软段晶体的成核及生长方式。

It is showed that the negative pressure increased with the lengthening of pipe outlet (ranging from 177 to 227 mm), and the siphonage and washing effect were enhanced. The water consumption reduced from 6 L to 5 L and the amount of sewage water decreased, when adjusting the length of pipe outlet to be the best value (227 mm).

结果表明，虹吸管出口段长度为177~227mm时，虹吸过程的负压值随长度增加而升高，虹吸作用随之增强、冲洗性能趋好；长度达227mm时，可使坐便器用水量从6L降至5L，所排污水量随之减少。

The monotonical dependence of 〓 vs.〓 in EOBTsamples implies that there certainly exists some connection between the lamellar thickness and〓.

上述BT硬链段结晶的熔点随平均硬链段长度单调变化的结果预示着硬链段平均长度和晶片厚度之间必然存在着一定的联系。

Control— Control—1 byte that consists of the binary sequence 00000011, which calls for transmission of user data in an unsequenced frame. A connectionless link service similar to that of Logical Link Control Type 1 is provided.

控制字段—长度为1个字节，该字段包含二进制数00000011，控制字段—长度为1个字节，该字段包含二进制数00000011 00000011，表示用户数据采用无序帧方式传输。

The DPD simulation results show that blending of copolymers is an effective way to control the morphology and inner structure of multicompartment micelles, and block sequence, block ratio, chain architecture and block length all have large effects.

混合体系中，嵌段共聚物的嵌段序列、嵌段比例、嵌段长度和共聚物分子构造都对最终的胶束形貌和结构有着很大的影响。

Then, to find the middle point, obvious inflexions and points which have an equal distance from any end point of the drawing symbol section, are first detected as candidate for middle points in our program, and then those other possible points are calculated after merging and deleting these former middle points.

在计算符号段中点时，首先分别计算境界线的明显拐弯点和距离两端半个符号段长度的点作为跳绘符号段中点，将这些中点进行一定的合并与删除后，再计算两两中点间可能存在的其余符号段中点。

And we know that when the last three sections are of the form(-1,0,1),(1,0,-1),the length of the third section increase when the length of the firstsection decrease,and prove that when the third section,that is section of v=0,is oflength 0 at the beginning,the analysis is also suitable.

并证明当右边3段是(-1，0，1)；(1，0，-1)形式时，在第1段时间长度减少的情况下第3段长度是增加的，而且证明了v＝0即第3段开始不存在即值为0时，也可以从无到有的发展。

Aiming at calculation of the equivalent rigidity of truss stiffening girder in an aeroelastic model design of a long-span suspension bridge with truss stiffening girder,Aizhai bridge,a super-long -span suspension bridge across deep valley with single span,was taken as an example for investigation.

针对大跨度桁架加劲梁悬索桥气弹模型设计中主梁等效刚度计算问题，以矮寨大桥为实例，建立不同长度空间桁架加劲梁节段模型有限元模型，通过悬臂梁位移法反算得到主梁的等效刚度特性，研究了不同荷载施加方式以及不同梁段长度对等效刚度特性的影响。

与段长度相关的网络解释 [注：此内容来源于网络，仅供参考]

anchorage length：锚固段长度

定长截断:fixed-length truncation | 锚固段长度:anchorage length | 端粒长度:Teloemere DNA length

radius of concave curve：凹弧半径

length of concave curved section 凹弧段长度 | radius of concave curve 凹弧半径 | length of convex curved section 凸弧段长度

equivalent length：当量长度. 即管件的局部水头损失相当于引起相同摩擦损失的直线管段长度

Effective Opening:(给水管道给水点的)最小横断面积. | Equivalent Length:当量长度. 即管件的局部水头损失相当于引起相同摩擦损失的直线管段长度. | Fixture Branch, Drainage:卫生器具排水支管.

FLC FixedLengthCode：固定长度编码

FLC FetchLengthControl 读取长度控制 | FLC FixedLengthCode 固定长度编码 | FLC FieldLengthCount 字段长度计数

FLC FieldLengthCount：字段长度计数

FLC FixedLengthCode 固定长度编码 | FLC FieldLengthCount 字段长度计数 | FLL FrequencyLockedLoop 频率锁定的环路

intermittent weld：间断焊缝

按照创建实焊角焊缝中的步骤 1-10 进行操作,但无需单击"间断焊缝"(Intermittent Weld) 复选框.单击"间断焊缝"(Intermittent Weld) 复选框时,将出现下列选项.使用这些选项来定义间断焊缝段的数量和间距方案: o o 段长度 (Seg Length) - 指定间断焊缝的段长度.

field label：字段标记

field heading 字段表头 | field label 字段标记 | field length 字段长度

OFO：原段偏移

? TL - 总长度 | ? OFO - 原段偏移 | ? OIHL - 原Internet包头长度

field mark：字段标记

field length 字段长度 | field mark 字段标记 | field name 字段名

Enter and tool length and radius cycles,subprograms and program section repeats：输入工具长度及半径圆,子程序和程序段循环

Circular arc with tangentical connection = 带... | Enter and tool length and radius cycles,subprograms and program section repeats = 输入工具长度及半径圆,子程序和程序段循环 | Define and call cycles = 定...