步量

词组短语

step off

与步量相关的网络例句 [注：此内容来源于网络，仅供参考]

Up to 3 voxels may be processed in one step and no accumulated error is made. The discriminator used in this algorithm is well refined, so that few calculations are required and the algorithm is simple and compact in form.

该算法是一个多步整数遍历算法，每一步可以遍历最多3个体素，且所用的判断公式非常精炼，不仅计算量很小而且没有累计误差。

The subdomain precise integration with multiple inner points can improve the precision. This paper gives alternating direction precise integration method for twodimensional diffusion equation, and discusses the parallel algorithm of this method.

给出了交替方向的二维扩散方程的精细积分算法，将一个时间步积分分为两个方向，使大规模矩阵的计算转化为一些小矩阵的计算，减小了每一步求解的计算量。

Recommends you use step-by-step method, step-by-step guide little girl, through the increase of time and action on the quality of the firm.

建议你们用循序渐进的方法，一步一步的引导小宝宝，通过时间上量的增加和行动上质的坚决。

Fourth,the number of nearest neighbor points is an important parameter for the local prediction method,which has an important impact on the prediction accuracy and computation complexity of the local model.

实验结果表明用该方法选取邻近点的局域线性预测方法和局域支持向量机预测方法的一步和多步预测性能较好，在满足预测精度较高的条件下，计算量较小。5。

The step motor can receive digital signal directly and has the ability to response outer environment immediately and has no accumulation error, which often is used in driving system. In this driving system, open-loop control system is composed of stepping motor, which can satisfy the demand not only for control precision but also for the target of economic and practicality. On this basis , the analysis of stepping motor in power calculating and style selecting is also given.

由于步进电机能够直接接收数字量，响应速度快而且工作可靠并无累积误差，常用作数字控制系统驱动机构的动力元件，因此，在驱动装置中采用由步进电机构成的开环控制方式，这种方式既能满足控制精度的要求，又能达到经济性、实用化目的，在此基础上，对步进电机的功率计一算及选型问题经行了分析。

We paced off the distance and found it to be 6 0 yards.

我们用步量了这段距离，发现它有60码。

Here, using the mathematica software and the outcome of the computation , we can see which interval is better easily. In chapter 2, the author firstly studies three two-stage simultaneous confidence intervals for the pairwise treatments with the same precision and reliability in a balance one-way classification model ,then work out the optimal sample size of the first stage by numerial computation.

第2章作者讨论了平衡单向分类模型中，成对效应对照的三种两步同时置信区间，接着在保证三种区间可靠度和精度相同的情况下，利用数值计算的方法对最优第一步抽样量及平均抽样次数进行比较。

To meet requirement of production and quicken rolling speed, No.2 heating furnace was put into operation in 2002 and No.3 in 2007. All automatic control was adopted, displacement of walking beam was detected by displacement transducer, and acceleration and deceleration control of walking beam was carried out through proportional valve and by use of slope technique in program of GE 90-70 PLC, thus, travelling speed of walking beam can be controlled and lift and release of slab can be operated lightly.

为适应生产的需要，加快轧制速度，2002年投产的2号加热炉和2007年投产的3号加热炉均采用全自动控制，利用位移传感器检测步进梁的位移量，通过比例阀以及在GE90-70PLC程序中采用斜坡技术对步进梁运动进行加减速控制，达到控制步进梁运行速度的目的，实现对板坯的轻拿轻放。

The results showed high class PbSt2 could be synthesized by this new saponifying process.Compared with metathetical process,the reaction time shortened,liquid-solid ratio and moisture content of filter cake decreased.Powder product could be prepared by one-step process,and particle product by two-step process.For the optimum processing conditions,the reaction temperature and time for one-step process were 65℃ and 10min,the amount of alkali added in the first step was 50%;reaction temperture and time were 65℃ and 10min for the two-step process.

结果表明，用皂化法工艺可得到优等品PbSt2，较复分解工艺，反应时间缩短、液-固比降低、滤饼湿含量比减小，一步式工艺得到粉状产品，二步式工艺得到颗粒状产品；最佳工艺条件为：一步式工艺反应温度65℃，反应时间10min；二步式工艺第一步的加碱量比50%，反应温度65℃，反应时间10min。

By connecting the pilot valve of stepping electric motor with machinery and hydraulic servomotor device, it can form the stepping microcomputer-based governor for water turbine.

以工业控制级单片机 80C552 为核心，开发出集测频、调速、调功、开停机操作、故障诊断及与上位机通讯等功能于一体的双微机型电气调节器，并与抗油污能力强、定位精度高、漏油量小的步进电机式引导阀及机械液压随动装置相配接，构成了水轮机步进式微机调速器。

与步量相关的网络解释 [注：此内容来源于网络，仅供参考]

chance move：随机步

chance event 随机事件 | chance move 随机步 | chance quantity 随机量

chance quantity：随机量

chance move 随机步 | chance quantity 随机量 | chance variable 机会变量

cls：儿童孤独量表

其中使用较多的是周步成编制的>(MHT)和王极盛编制的>、>(SCT-90)、>(SASC)和>(儿童,

constrain：强迫

)最新進展是利用 DNA 連接器(DNA linker)將某些塗布 DNA 的奈米粒子附加到一固態表面上,以更進一步強迫(constrain)與控制這些奈米粒子能如何連接. 這產生了更大的精密性,也因此是一種更可預測的、可重製的高生產量建構技術,

Offset：偏移量

图四 5、执行"滤镜"(filter)|"其它"(Other)|"偏移量"(Offset),水平和垂直都设为3. 图五. 至此,为立体感所做的准备工作结束. 下一步我们利用风动滤镜和扩散滤镜来实现那个斑驳的表面效果. 1、复制Alpha1到Alpha3,并使Alpha3为当前通道.

scallop：残留高度

在精加工时,吃刀量的选择与表面粗糙度有关, CAM 软件中通常提供有两种参数控制表面粗糙度:步距宽度( Stepover )和残留高度 (Scallop) . 采用步距宽度控制表面粗糙度时,步距宽度越小,表面粗糙度越小;采用残留高度控制表面粗糙度时,

Two-part Tariff：两步收费

练习性预演 Dry Run | 两步收费 Two-part Tariff | 量表 Scale

Step off：量出

step motor 步进式电动机 | step off 量出 | step out n. 失调

Fig. 38：節點密度800的平均訊息量

Fig. 37 節點密度600之平均回應步數 44 | Fig. 38節點密度800的平均訊息量 49 | Fig. 39節點密度1000的平均訊息量 50

step-by-step procedure：逐步的步驟

STEL, Short Term Exposure Limited 短時間時量平均 | step-by-step procedure 逐步的步驟 | sterile 無菌的