极限的

基本解释 (translations)

crippling  ·  ultimate  ·  uttermost

与极限的相关的网络例句 [注：此内容来源于网络，仅供参考]

Theoretical Part: Through theoretical analysis of chemothermodynamics, combustion and engineering thermodynamics, factors that affect explosion limit were determined, which include temperature, pressure, spark ignition energy, electrode shape, direction of flame propagation and size of explosion vessel.

理论部分：根据化学热力学、燃烧学和工程热力学的基础理论，从本质上定性地分析了爆炸极限的影响因素，包括温度、压力、爆炸容器的大小、点火能量大小、以及火焰传播方向等，得出了这些影响因素对爆炸极限的影响规律，以确保实验有完整的理论基础指导；在此基础上本文提出了一种新的推算在常温常压下可燃性纯质和混合工质制冷剂爆炸极限浓度的理论方法，该方法由可燃性气体的化学组成来推算上下限浓度，不需要其它条件；对混合工质制冷剂，只要再知道混合配比，即可以推算出爆炸极限，使预测爆炸极限的工作更简单、方便。

Limit is the soul of differential calculus, limits' calculation is an important content of the limit theory.

极限是微分学的灵魂，极限的计算是极限理论的重要内容。

This paper presents the concepts of double limit, repeated limit , directional limit and weak double limit of binary function, and discusses the relationships among them.

给出了二元函数的二重极限、累次极限、方向极限、弱二重极限的概念，讨论了这几种极限之间的关系。

By using the limits of functions and the exchange limit theorem,we considered the relationship between the double limit of function with two variables and its repeated limit s.

应用函数列的极限与函数的极限交换次序定理，研究了二元函数的二重极限与它的两个累次极限的关系定理，研究了二元函数的两个二阶混合偏导数可交换次序定理。

The uncertain relationship between the double limit and the quadratic limit is explained and the determination methods to the nonexistence of the odd function's limit are given.

本文阐明二重极限与二次极限的不确定关系，给出齐次函数的极限不存在的判定方法。

Moreover, we constructed the limit and inverse limit sturcture in the category of quantale.

此外，还讨论了范畴Quant中的极限，逆极限和定向极限，给出了Quant中极限和逆极限的结构。

Forming limit stress diagram was investigated theoretically and experimentally.

本课题通过试验，有限元仿真和理论分析，研究了应力成形极限的路径相关性问题，应力成形极限和应变成形极限的转换关系，材料各向异性对成形极限的影响，以及应力成形极限在板料成形分析中的应用等。

The forming limit stress diagram which established with limit stress is independent on the strain paths and it is practical to use as the criterion of forming limit under cmplex strain paths.

由极限应力构成的应力成形极限图独立于应变路径，可作为复杂应变路径下成形极限的判据。

This paper is also concerned with the nonlinearity measure of the PKM, which depend upon differential geometry curvature. The nonlinearity can be reflected by the curving of the solution loci and the equal interval input of joints mapping into inequable interval output of the end-effector.

从而解决了PKM设计中根据进给能力需求优化结构参数、确定关节伺服轴极限转速，以及在数控编程中由机床结构参数、关节伺服轴极限转速和加速度评价刀具进给能力的软极限的两类互逆问题。

Typical results of the limits of superheat and su p er-depressurization for methane and propane are given,and the critical liquid st orage conditions that can lead to limits of super depressurization are analysed.

以 甲烷和丙烷为例给出了过热极限和过减压极限的典型计算结果，分析了可能使液体达到过减压极限的储存条件。

与极限的相关的网络解释 [注：此内容来源于网络，仅供参考]

limiting ambient temperature：极限环境温度,极限周围温度

limiting 限制,界限;极限的 | limiting ambient temperature 极限环境温度,极限周围温度 | limiting amplifier 限幅放大器

limitable：可求极限的

limit value | 极限值 | limitable | 可求极限的 | limitation | 限制,局限性,极限,界限,限度

limiting：极限的,限定的

limiter 限制器 | limiting 极限的,限定的 | limiting clearance 极限间隙

Limiting clearance：极限间隙

limiting 极限的,限定的 | limiting clearance 极限间隙 | limiting stopper (悬架)限位块

ultimate tensile stress：极限抗拉应力

ultimate tensile strength 极限抗拉强度 | ultimate tensile stress 极限抗拉应力 | ultimate 极限的

ult：最终的;极限的

上月 ult. | 最终的;极限的 ult. | 最终的;极限的;极端的;总的 ultimate

UTS ultimate tensile stress：极限的拉伸应力

UTS ultimate tensile strength 最大抗张强度,极限抗拉强度 | UTS ultimate tensile stress 极限的拉伸应力 | U-tube U形管

unbeatable：打不垮的;(价格等)已达极限的

Buff: (美国口语)健壮的 | Unbeatable:打不垮的;(价格等)已达极限的 | Uncanny:奇特的

utmost：极限的

utter说出;彻底的 | utmost极限的 | 90. undergo v. 经历,遭受

Throw the book at Somebody：是指给某人最大极限的惩罚

17、love makes the world go round 爱使世界转动 | 18、throw the book at somebody 是指给某人最大极限的惩罚 | 19、speaking of the devil说曹操,曹操到