板条

基本解释 (translations)

batten  ·  lath  ·  lathing  ·  slat  ·  wattle  ·  lathwork  ·  wattling  ·  battened  ·  battens  ·  laths  ·  slats  ·  wattles  ·  panellings

与板条相关的网络例句 [注：此内容来源于网络，仅供参考]

For the heat input of 8kJ/cm and preheated temperature of 60℃, impact toughness value of specimen was highest for the formation of fine grains and a certain quantity of granular bainite which can effectively partite lath bainite.

当采用8kJ/cm的线能量和60℃的预热温度时，粗晶区的晶粒较细，组织由板条贝氏体和一定量的粒状贝氏体组成，由于粒状贝氏体对板条贝氏体的分割作用，使板条贝氏体的长度较小，方向性差，表现的韧性最优越。

Observation of transmission electron microscope reveals that the f＇me structure of CGHAZ and IRCGHAZ of both in- service welding and routine is ferrite laths and the second phase particles that distribute on or between ferrite laths.

透射电镜下，在役焊接和常规焊接的粗晶区与临界粗晶区的主要形貌都是铁素体板条和分布在板条之间或板条基体上的岛状物，铁素体板条的亚结构都是高密度位错。

The struetural constitution of lath martendsite is composed of bundles of parallel jaths with varying sizes,stuffing martensite in irregular shape stuffed among laths at the boundary and corner of the pack- ets and retained austenitie thin film or platelet l...

板条马氏体组织是由一簇簇平行排列的大小板条，以及填充在马氏体板条间，束界和界隅内的不定外形的填塞马氏体和条间残余奥氏体薄膜或膜片所构成。

Moreover, its microstructural characters possess several configurations under TEM, which are (1) ferrite laths with obvious interface,(2) ferrite laths without obvious interface, but the interface can be discerned faintly from the linear arrangment of those directional islands,(3) the coexistence of ferrite laths and non--equiaxed grains. These are somewhat different from those of weld structures, which are generally thought to consist of an assemblage of interwoven ferrite laths.

管线用针状铁素体钢热轧板材中有明显界面的板条束或针状片条束；没有明显界面的板条束或针状片条束，可根据条状物或岛状物的有方向性的线状分布依稀辨别界面的存在；板条或针状片条与非等轴晶共存等多种不同形态，并不象焊接组织那样通常是单一的针状片条束或板条束形态。

The result proves that the thermal lensing effect of slab has been improved due to adoptation of adiabatic construction.

板条热透镜效应实验结果表明，在500Hz重复频率下，未装绝热结构的板条热焦距为0.78m，而装有绝热结构的板条的热焦距为1.93m，热聚焦大为改善。

In view of easy fusion flaw between connecting of doubler strake and deck plating or bottom plating strengthened, this paper puts forward a fire-new welding technics for the purpose to improve the technics of welding connecting of doubler strake. Under the help of this way, connecting of doubler strake can be penetratingly fillet welded, but not fuse with deck plating or bottom plating strengthened, at the same time the figure of weld surface can also be managed for increasing fatigue strength of connecting.

本文针对复板条对接接头容易和被加强的甲板或船底板发生粘连的缺点，从改善复板条对接接头的工艺入手，提出了新的焊接工艺，使得复板条对接接头既能保证完全焊透，又不会和被加强的甲板或船底板发生粘连，同时对焊缝表面形状进行处理，以提高接头的疲劳强度。

But it has some shortcomings. Connecting weld of doubler strake is directly welded on plating strengthened, in this way welding fluid fuse with plating strengthened such as deck plating or bottom plating, and then connecting of doubler strake fuse with deck plating or bottom plating strengthen. So breakage like crack of connecting of doubler strake may immediately destroy deck plating or bottom plating strengthened, which became of navigational accident.

但是，增设复板条来提高船舶总纵强度的方法有其缺点，每段复板条之间的对接焊缝是直接在被加强的板上施焊，焊缝就会溶入被加强的甲板或船底板，使得复板条对接接头与被加强的甲板或船底板发生粘连，这样，复板条对接接头的开裂等破坏就会直接引起船舶被加强的甲板或船底板的破坏，从而导致海难事故。

In this paper, thermal edffect in slab laser and parasitic oscillation in amplifier are analysized.Using the same method, we also calculate thermal effect in photonic crystal fibers with hollow claddings.

本文针对板条激光介质的特点，重点研究了板条激光器的热效应以及板条放大器的寄生振荡现象，并将热效应的计算方法推广到光子晶体光纤中。

Laminated flooring base board cutting and processing, processing of lath of furniture specification, wood package box lath cutting and processing, super long slab and environment-friendly acousitc board and cutting and processing, solid wood laminated floor tension channel processing, board furniture, office furniture and draving, forming and processing of special filling honey comb pager special for wood door.

现主要生产&多片锯&&链带式背槽机&&蜂窝纸拉伸定型机&，设备适用於：实木门规格板条开料加工、实木复合地板基材板的开料加工、家俱规格板开条加工、木制包装箱板条开料加工、超长大坯板和环保吸音板开料加工、实木复合板应力坑槽加工、板式家俱、办公家具、非木质填充材料和木门专用填充蜂窝纸拉伸定型加工等。

The distinguishing features of the paper are selection of oblique strip and loading transmission, negative yielding line in irregular slab with simple supports, point support and shear split of slab.

本文的主要特点为有料向板条的选取及荷载传递、简支不规则板的负弯矩裂缝线以及点支承板条和板的剪切劈裂问题。

与板条相关的网络解释 [注：此内容来源于网络，仅供参考]

lath：板条

板条马氏体组织由原奥氏体晶粒、板条束 (Packet)、板条块(Block)以及板条(Lath)等几个层次组成. 研究发现,只有板条之间为小角度晶界(5°),其它均为大角度晶界. 板条马氏体钢的断裂存在两种方式:对于以拉伸为代表的韧性断裂方式,

lath：水果装舱隔板板条

lath 板条 | lath 水果装舱隔板 板条 | lath 水果装舱隔板板条

lath martensite：板条状马氏体

lather浮渣、泡沫 | lath martensite板条状马氏体 | lath of martensite马氏体板条、板条状马氏体

lathing：板条筛网,钉板条

lathhouse 板条房屋 | lathing 板条筛网 钉板条 | lathinghatchet 锤斧 板条斧

lathing hatchet：锤斧,板条斧

lathing 板条筛网,钉板条 | lathing hatchet 锤斧,板条斧 | Latia name of Australian ladybeetle 澳洲瓢虫拉丁名

skelp mill：(制管)板条轧机

"(有缝管用)板条","skelp" | "(制管)板条轧机","skelp mill" | "板条轧机","skelp mill"

slat：板条

本实用新型公开了一种由无纺布所形成的遮阳工具用板条,为解决现有垂直百叶窗及水平百叶窗上的板条(slat)存在成本高等问题而提出. 本实用新型的由无纺布所形成的遮阳工具用板条,在设置于窗户上遮挡外部阳光、防止被窥视的垂直百叶窗及水平百叶窗一样的遮阳工具上,

lathy：板条似的; 细长的 (形)

lathing 钉板条; 板条; 用板条作成之物 (名) | lathy 板条似的; 细长的 (形) | lathyrism 山黧豆中毒 (名)

battened partition：板条间壁

batten 条板;压条;夹板;板条;挂瓦条;压缝条;装条板 | battened partition 板条间壁 | battened wall 板条墙

FC Crate, fruit：水果板条箱 水果板条箱

EN Envelope 封套 封套 | FC Crate, fruit 水果板条箱 水果板条箱 | FD Crate, framed 加外框的板条箱 加外框的板条箱