有两角的

基本解释 (translations)

biangulate  ·  dicerous

与有两角的相关的网络例句 [注：此内容来源于网络，仅供参考]

In addition, spot color screen angle in software will normally be preset to 45 ° c (45-degree, is considered the most comfortable utilizinghuman-aware, so that the angle of the dot is arranged in horizontal and vertical lines to equal rotation, you can reduce the human ability to mesh point detection), if a Duotone image or data file into the existing business card printing and membership card making four color black%(General in the four-colour screen business card printing and membership card-making Black mesh point-and-drop, in a 45-degree is 0 degrees for yellow, magenta to 15 degrees, 75 degrees), and spot color, or with more than two spot colors, the color screen is to a 45-degree output, so use the spot color, while if it is possible with other screening to overprint colors, you must open the output color separation software color settings or the print dialog box, on the halftone angles to make modifications.

另外，专色的增网角量在软件洋凡是城市预撤为45量（45量均被觉得是人眼感知最安适的角量，让网不背摆列在与程量和垂直线不败不等角量的标的目的上可以裁减人眼差网不背的发现本领），若是一个单色调影像或是数据文件洋既有制卡和会员卡制息四色暗不败外（凡是在四色增网制卡和会员卡制息洋，不兵暗网不背不收在45量，黄为0量、品赤为15 量、青为75量），又有专色，或者是有两个以上专色，则在分色增网时城市以45量输入，所以在差专色搁置浅网时，如果有不定与其他增网颜色有叠印，则务必在分色输入时开放软件颜色撤定或打印撤定的差话框，差专色增网角量举动编削。

If I have experienced both horned animals and horses , I can combine those two concepts to form a concept of a unicorn .

如果我有经验的两角的动物和马，我能把这两个概念形成的一个概念独角兽。

While there was no evidence of subordinate stress, one oryx which had been dominant but then was excluded for two years had three fold higher testosterone and corticosterone than the other males at estrus

没有证据表明从属个体压力的存在，一只弯角长角羚曾经是优势个体，但是后来有两年不是优势个体，与其他雄羚相比，这只雄羚在雌性发情期的睾酮和皮质酮水平有3个交迭出现的峰值

While there was no evidence of subordinate stress, one oryx which had been dominant but then was excluded for two years had threefold higher testosterone and corticosterone than the other males at estrus.

没有证据表明从属个体压力的存在，一只弯角长角羚曾经是优势个体，但是后来有两年不是优势个体，与其他雄羚相比，这只雄羚在雌性发情期的睾酮和皮质酮水平有3个交迭出现的峰值。

At first, an ordinary gear train composed of two gear pairs is analyzed. The constituting principle and the equivalent gear pair of a ordinary noncircular gear train are studied under two assembling circumstances, including phase angle exists between two gear pairs or not.

以分析两对齿轮副构成的定轴轮系为非圆齿轮机构分析的起始点，本文首先分析了两对齿轮之间有相位角与无相位角两种安装情况下，定轴轮系的构成原理与轮系等价齿轮副的传动关系。

Butt Weld and docking and corner combinations Weld, in Weld ends located arc plate and extraction plate in igniting board then leads to the welding seam, joint halfway shall weld joints in front of 2.0 mm Department Firing arc, welding pieces after preheating rod will return to weld the origin, pool filled to the required thickness, before forward welding; Welding speed : Isokinetic welding requirements to ensure weld thickness, width uniform, which masks to look for hot metal and slag bath equidistance (2-3 mm)%; Arc welding rod length : different models and determined that the general requirements of arc length is stable, acid electrode generally 3-4 mm, 2-3 mm normally alkaline electrode%; Welding perspective : According to determine the thickness of two pieces of welding, welding angle has two aspects : First, the angle between the direction of the rod and welding of 60-75 ; The second is the angle between two electrodes and welding around, the same thickness as welding, welding and welding pieces incident angle of 45 ; When the thickness ranging from welding, welding electrode and thick and thin pieces of welding electrode side angle greater than the angle between the side pieces; Arc : admission to the end of each weld should be filled crater, in the direction opposite to the direction of the back-arc welding, arc welding unchanged inside pit in 1974, to prevent the crater bite of meat.

对接焊缝及对接和角接组合焊缝，在焊缝两端设引弧板和引出板，必须在引弧板上引出后再焊到焊缝区，中途接头则应在焊缝接头前方15～20㎜处打火引弧，将焊件预热后再将焊条退回到焊缝起始处，把熔池填满到要求的厚度后，方可向前施焊；焊接速度：要求等速焊接，保证焊缝厚度、宽度均匀一致，从面罩内看熔池中铁水与熔渣保持等距离（2～3㎜）为宜；焊接电弧长度：根据焊条型号不同而确定，一般要求电弧长度稳定不变，酸性焊条一般为3～4㎜，碱性焊条一般为2～3㎜为宜；焊接角度：根据两焊件的厚度确定，焊接角度有两个方面，一是焊条与焊接前进方向的夹角为60～75 ；二是焊条与焊接左右夹角有两种情况，当焊件厚度相等时，焊件与焊件夹角为45 ；当焊件厚度不等时，焊条与较厚焊件一侧夹角应大于焊条与薄焊件一侧夹角；收弧：每条焊缝焊到末尾，应将弧坑填满后，往焊接方向相反的方向带弧，使弧坑甩在焊道貌岸然里边，以防弧坑咬肉。

I have here some $8000 in these letters sent to my office from all over the country——quarters、dimes、dollar bills from housewives、plumbers、car salesmen、teachers、imbeciles ...

这些信封里面有大约八千美元，是从全国各地寄到我办公室的，有两角五的、一角的、一元的，来自家庭主妇、水管工、汽车推销员、教师、残障人士。。。

The chelys-lyra had the same kollopes and plektron as the kithara, but the plektron cord was attached to the base of the outer arms more often than to the base of the soundbox.

以下内容引用自Diane Touliatos-Miliotis的文献：Chelys-lyre的其他部件包括：一个donax，这可能是安置在两角之间为之起桥梁和支架作用的芦苇杆；pecheis，里拉琴从外部置入共鸣箱的部分；zugon或者crossbar，被刻上刻痕并架在两角上部的末端，里拉琴像萨基拉琴一样也有kollopes和琴拨，但固定琴拨的绳索常常栓在角外侧的底部而不是共鸣箱的底部。

The "pecheis"were the arms of the lyre that entered the soundbox from the front. The "zugon" or crossbar was notched across the upper ends of the arms to which the seven strings of sheepgut were attached. The chelys-lyra had the same kollopes and plektron as the kithara, but the plektron cord was attached to the base of the outer arms more often than to the base of the soundbox.

以下内容引用自Diane Touliatos-Miliotis的文献：Chelys-lyre的其他部件包括：一个donax，这可能是安置在两角之间为之起桥梁和支架作用的芦苇杆；pecheis，里拉琴从外部置入共鸣箱的部分；zugon或者crossbar，被刻上刻痕并架在两角上部的末端，里拉琴像萨基拉琴一样也有kollopes和琴拨，但固定琴拨的绳索常常栓在角外侧的底部而不是共鸣箱的底部。

Cografts point in general there are two: vertical tool grinder mill out of an arc-shaped blade angle, as in Figure 2 illustrated horizontal grinder mill out of cografts is straight, as in Figure 2 is shown below.

刃角通常情况下有两种：用立式磨刀机磨出的弧线型刃角，如图2所示；用卧式磨床磨出的刃角为直线型，如图2所示。

与有两角的相关的网络解释 [注：此内容来源于网络，仅供参考]

biannual：半年刊,一年两次的

biangulate 双角的 | biannual 半年刊,一年两次的 | biapiculate 有两尖顶的

cosecant：余割

(cosine)、正切(tangent)、余割(cosecant)、正割(secant)和余切(cotangent). 22边角边公理(SAS) 有两边和它们的夹角对应相等的两个三角形全等23 角边角公理( ASA)有两角和它们的夹边对应相等的两个三角形全等24 推论(AAS) 有两角和其中一角的对边对应相等的两个三角形全等25 边边边公理(SSS) 有三边对应相等的两个三角形全等

cotangent：余切

(cosine)、正切(tangent)、余割(cosecant)、正割(secant)和余切(cotangent). 22边角边公理(SAS) 有两边和它们的夹角对应相等的两个三角形全等23 角边角公理( ASA)有两角和它们的夹边对应相等的两个三角形全等24 推论(AAS) 有两角和其中一角的对边对应相等的两个三角形全等25 边边边公理(SSS) 有三边对应相等的两个三角形全等

biacuminate：两尖的,有两尖端的

bi- 二,两,双 | biacuminate 两尖的,有两尖端的 | biangulate 双角的

biangulate：双角的

biacuminate 两尖的,有两尖端的 | biangulate 双角的 | biannual 半年刊,一年两次的

biangulate：具二棱角的, 有两角的

biangular | 双角的 | biangulate | 具二棱角的, 有两角的 | biannual | 一年二次的

bicornuate：双角的; 新月形的, 月牙形的 (形)

biconvex 两面凸的 (形) | bicornuate 双角的; 新月形的, 月牙形的 (形) | bicorporal 有两个身体的 (形)

bicornuous：双角的, 新月状的

bicornuate | 双角的, 新月状的 | bicornuous | 双角的, 新月状的 | bicorporal | 有两个身体的,有两个主要部分的

bicorporal：有两个身体的,有两个主要部分的

bicornuous | 双角的, 新月状的 | bicorporal | 有两个身体的,有两个主要部分的 | bicorporeal | 有两个身体的,有两个主要部分的

bicorporal：有两个身体的 (形)

bicornuate 双角的; 新月形的, 月牙形的 (形) | bicorporal 有两个身体的 (形) | bicultural 二元文化的; 两种语言的 (形)