- 更多网络例句与最佳工况相关的网络例句 [注：此内容来源于网络，仅供参考]
-
By simplifying air spring mechanics model, We analyze the damping characteristics for air spring suspension system of single degree of freedom, then educe optimal damp of air spring suspension with throttle hole under various situation and optimal diameter of throttle hole. The capability opinion guideline of air spring suspension system is analyzed.
通过简化空气弹簧的力学模型，对单自由度有阻尼空气弹簧悬架系统的阻尼特性分析，得出带有节流孔的空气弹簧在各种工况下的最佳阻尼及节流孔的最佳直径，并分析了空气弹簧悬架系统的性能评价指标。
-
To make the engineering machine economize on energy efficiently will spread to move system to carry on a control towards launching machine and, reasonable allotment power, make it be placed in the best work condition;For easing a pilot to labor strength and improvement to manipulate function, need to adopt an automatic control, carry out an engineering machine automation;To complete the homework of high technical ability need intelligence to turn;For the sake of exaltation safety, demand safety control, carry on circulating appearance surveillance, the breakdown reports to the police automatically;Because the construction realm expands, in order not to the personnel arrive can't and not come-at-able place and the very bad place of the homework environment go to homework, need to be adopted long-distance leave remote control and no man to drive a technique.
要使工程机械高效节能，就要对发动机和传动系统进行控制，合理分配功率，使其处于最佳工况；为了减轻驾驶员劳动强度和改善操纵性能，需要采用自动控制，实现工程机械自动化；要完成高技能的作业，就需要智能化；为了提高安全性，需要安全控制，进行运行状态监视，故障自动报警；随着建设领域的扩展，为了避免人员到达无法及不易接近的场所及作业环境十分恶劣的地方去作业，需要采用远距离遥控和无人驾驶技术。
-
At present situation economize energy and protect environment are being paid more and more attention, design of control for industrial boiler, accord with guarantee safe work, should make it work under optimal condition which minimum the loss of combustion, pollution of environment, maximum thermal efficiency.
在愈来愈重视节能和环境保护的今天，对于工业锅炉的控制，应该在保证安全生产的条件下，使其在燃烧热损失最小，热效率最高，对环境污染最小的最佳工况下运行。
-
At present situation economize energy and protect environment arebeing paid more and more attention,design of control forindustrial boiler,accord with guarantee safe work,should make itwork under optimal condition which minimum the loss of combustion,pollution of environment,maximum thermal efficiency.
在愈来愈重视节能和环境保护的今天，对于工业锅炉的控制，应该在锅炉节能减排论文安全生产的条件下，使其在东方锅炉厂有限公司热损失最小，热效率最高，对环境污染最小的最佳工况下运行。
-
Using spray to simulate the mist eliminator's actual working environment, at the condition of normal temperature and normal pressure, the relation between separation efficiency and outlet gas velocity, the relation between pressure drop and outlet gas velocity was investigated by experiment.
分离效率先随出口气速的增大而增大至临界点即最大值，然后随出口气速的增大而减小；最佳工况下的分离效率达95%以上。③压降随气速的增大而增大。
-
The purpose of the experiment is to make sure the best condition of copper sulfate for killing algae.
目的通过对硫酸铜灭藻影响因素的试验研究，确定出硫酸铜灭藻的最佳工况条件。
-
After multi-objective optimization pressure ratio equaling 32 and compression ratio equaling 13 were obtained.
经过多目标规划计算后得到了气动发动机在最佳工况时的工作参数和气缸的几何尺寸。
-
Ball mill is an important equipment widely use in domestic and abroad coal-burning power plant.
钢球磨煤机是国内外火电厂大量采用的重要辅助设备，但在使用过程中还存在着一些亟待解决的问题，其中最突出的是在很多火电厂无法实现自动控制，不能运行在最佳工况。
-
It has been found out that an optimum operation point exists for this type of mechanical seal,and it can be achieved by means of controlling the spring pressure...
试验研究发现，运行中的机械密封存在一个最佳的密封工况点，通过对弹簧比压的调节与控制，可以实现这一工况。
-
The transmission of heat differential equation for the heat conduction process of thermoelectric module was derived And the solution with the first kind boundary conditions under the influence of Thomson effect and the solution with the third kind boundary conditions without the influence of Thomson effect was obtained.
在假设热电制冷的热端温度固定的条件下，得出热电制冷器在不同工况下的最佳工作参数并进一步求得在三类边界条件下的最佳工作参数；导出了电偶臂在电与热的偶合作用下传热微分方程，并对其进行解析求解：在考虑汤姆逊效应的影响下得出一类跟三类边界条件下传热方程的解析解，在忽略汤姆逊效应的影响下得出二类跟三类相的边界条件下传热方程的解析解。
- 更多网络解释与最佳工况相关的网络解释 [注：此内容来源于网络，仅供参考]
-
harmonious：谐
──本文所用"调谐"(Harmonious)一词,指通过调节有关互相影响的因素,配合协调,获得有效的以至最佳的运行工况. 按诸无线电学关于调谐的定义,当调节可变电容器或电感线圈,使收音机接收系统与无线电波达到谐振(自振频率一致)范围,
-
TUNE：调节
按诸无线电学关於调谐的定义,当调节(Tune)可变电容器或电感线圈,使收音机接收系统与无线电波达到谐振(自振频率一致)范围,就进入了有效收音工况;如达到确切的谐振点,则可获得音正量足的最佳收音效果,称为调谐工况.