放热

词组短语

give out heat · heat production

与放热相关的网络例句 [注：此内容来源于网络，仅供参考]

H value of rhizobia was very different from actinomyces and fungi, and the values were smaller than actinomyces and fungi.

同时， DTA曲线的△ H 值一般呈现第3放热峰大于第1放热峰与第2放热峰的规律。

Lastly, experimentations are carried out on Chaochai 6102BQ engine and the data of the thermal parameters according to different oil-apply lead angle is derived. The influence of the change of oil-apply lead angle on the rate of heat release is researched, then a reference is provided for building an accurate heat release model.

最后，在朝柴6102BQ柴油机台架上进行了试验，对不同供油提前角下柴油机的热工参数进行实机测试，对试验结果进行了处理、分析，研究了供油提前角的改变对放热规律的影响，为建立该故障下的燃烧放热模型提供参考。

They can be classificated to two kinds. One kind is build by photomultiplier; another kind is build by MCP. The mechanism of delayed luminescence is discussed with subradiation. A photon count system is built. To proof the biophoton is a kind of ultra weak photon stream originate from exothermic reaction, and primarily discuss the relationship between the delayed luminescence and proteins activity, we chose microphyllous banyan leave , ficus elastica leave, gingkgo leave, Chinese fan palm leave, and cinnamomum camphora leave as biological samples. The ultra weak photon emission from normal biosamples, and proteins inactivated biosample were measured separately with photon count system. The results showed that the delayed luminescence of biosamples have

在研究过程中，作者从辐射陷获的角度讨论了延迟发光的产生机制，对生物光子的生物化学起源与相干场起源的统一性进行了探索；自行搭建了单光子探测系统；测量了小叶榕树、印度橡树，银杏树，蒲葵树香和樟树等多种植物叶片样品的延迟发光，获得了大量实验数据；为了证明生物光子是一种起源于放热化学反应能量释放的微弱光子流，并初步探讨生物蛋白活性与延迟发光衰减之间的关系，测量了正常生物样品、生物蛋白灭活样品的延迟发光，同时测量了多种不含蛋白质的无机化学体系作为比对，实验结果和实验数据的回归分析表明：弱光子发射来源于放热的化学反应，延迟发光的强度与衰减时间与生物蛋白活性密切相关。

The results show that in the case of iso-octane direct injection at the latter stage of n-heptane high temperature heat release, the iso-octane mainly undergoes high temperature diffusive combustion with stable ignition and insensitiveness to the port injected n-heptane equivalence ratio.

当异辛烷在正庚烷低温反应之前喷入，发生预混合燃烧；当异辛烷在正庚烷HCCI燃烧负温度系数区和高温放热初期喷入，主要发生预混合燃烧；当异辛烷在正庚烷HCCI高温放热末期或结束后喷入，则主要发生扩散燃烧。

On the basis of model of steady state of two dimensional semi infinite vertically buried tube and Newton exchange heat formula, the outside heat release coefficient is deduced from vertical tube in different depth of geothermal water well to ambient medium.

根据二维半无限大垂直埋管表面的稳态放热模型及牛顿换热公式，推导出地热水井在不同深处的垂直管道外表到周围介质的外部放热系数。

Heat release is a measure of the contribution that a burning material makes to a fire in progress, for example, a high rate of heat release will produce a high rate of rise of temperature in surrounding unburnt material and accelerate fire spread.

放热是易燃材料在燃烧过程中所起作用的衡量尺度。打个比方，高速率的放热将对不完全燃烧的材料产生了高速率的升温并且加速了火焰的蔓延。

Canopy transpiration and latent heat transfer progress have been specially treated in themacro-thermal-environment simulation program,by which,the effects of outside solar radiation andair temperature,greenhouse insulation,and backwall and floor on the macro-thermal-environmentcan be simulated.

根据上述模型就室外太阳辐射、室外气温、温室的保温、温室后墙和地面的蓄放热等对生态温室主体热环境的影响进行了模拟，证明温室透光盖层在白天损失了大量热量，建议改进盖层的透光保温综合性能；一面坡温室后墙和地面对室内的放热贡献相近，但后墙向外界的热损失是其向室内放热的2倍左右，其具体大小还与后墙的尺寸等因素有关。

The experimental results indicated that under the steady operating conditions, the ignition timing of the base fuel (PRF90-90% iso-octane+10% n- heptane), which is equivalent to RON 90, delayed and the peak value of the heat release rate was low compared to the base fuel with single additive (Ditert-butyl peroxide-DTBP, Dicumyl peroxide-DCP, Tert-butyl hydroperoxide-TBHP, Tert-butyl cumyl peroxide -TBCP or Cumene hydroperoxide-CPO) which advanced ignition timing and increased the peak of the heat release rate obviously.

试验结果分析表明，在HCCI发动机燃烧稳定工况下，没有添加剂的基础燃料记作PRF90(为90%异辛烷与10%正庚烷的混合，相当于90号汽油)着火滞后，燃烧放热率峰值低，而混有单一添加剂(Ditert-butyl peroxide-DTBP、Dicumyl peroxide-DCP、Tert-butyl hydroperoxide-TBHP、Tert-butyl cumyl peroxide-TBCP或Cumene hydroperoxide-CPO)的基础燃料则着火明显提前，燃烧放热峰值升高。

It can be seen from their DTA curves that the addition of rare earth oxides could make the first exothermal peak of ammonium perchlorate hysteresised and the second exothermal peak advanced.

结果表明：所有稀土氧化物均能使高氯酸铵的第一放热峰滞后，而第二放热分解峰提前；随着稀土添加量的增加，两分解峰逐渐靠近，最终合并为一个分解放热峰，分解热也大大提高。

The drug release experiments in vitro indicated that with the increase of PLA molecular weight, the drug release rates decreased. 4ac releasing from 4ac-PLA-NP could be characterized by Weibull's equation. The interaction between 4ac and others compositions was not detected by DSC. The peak position of 4ac in DSC did not changed comparing 4ac with 4ac-PLA-NP lyophilize injection. Thc X-ray result showed that the peak of 4ac-PLA-NP was piled up between 4ac and other compositions.

差示扫描量热分析结果表明药物与各组分之间无明显的相互作用，制成4ac-PLA-NP冻干针剂后，其放热峰主要表现为聚乳酸的放热峰：X-射线衍射结果表明药物与载体间无相互作用，4ac-PLA-NP主要表现为4ac与载体之间的叠加峰；TLC、FT-IR也同样表明药物与载体无相互作用，它们之间是一种物理结合，并未有新物质生成。

与放热相关的网络解释 [注：此内容来源于网络，仅供参考]

exothermic：放热

与在DTA曲线中,吸热效应用谷来表示,放热效应用峰来表示所不同的是:在DSC曲线中,吸热(endothermic)效应用凸起正向的峰表示凹下的谷表示 (热焓增加),放热(exothermic)效应用凹下的谷表示(热焓减少).

exothermic compound：放热化合物

exothermic reaction 放热反应 | exothermic compound 放热化合物 | exothermic 放热的

exothermic ferroalloy：放热性铁合金

exothermal reaction 放热反应 | exothermic ferroalloy 放热性铁合金 | exothermic gas 放热型气体

exothermal：放热的

exotherm 放热曲线 | exothermal 放热的 | exothermalchange 放热变化

exothermal：放热的;生热的

exospore 外生孢子;胞子外壁 | exothermal 放热的;生热的 | exothermic 放热的;发热的

exothermal change：放热变化

exoskeletal construction 骨架式建造术 | exothermal change 放热变化 | exothermal character 放热特性

exothermal character：放热特性

exothermal change 放热变化 | exothermal character 放热特性 | exothermal reaction 放热反应

Exotherm：放热图解

exothermic 放热的 | exotherm 放热图解 | exopeptidase 肽链端解酶

exoergic：放热

exoenergic || 放热 | exoergic || 放热 | exogenous electrification || 外源起电

heat emission factor：放热系数

heat emission 放热 | heat emission factor 放热系数 | heat engineering 热工学