- 更多网络例句与折角线相关的网络例句 [注：此内容来源于网络，仅供参考]
-
The vessel's upper deck camber is to be of knuckled line, and the knuckle camber is 150mm; poop deck has parabola camber of 150mm; compass deck is to have a parabola camber of 150 (half width of 12m).
本船上甲板梁拱为折角线，折角梁拱为150mm；首、尾楼甲板为抛物线梁拱150mm；罗经甲板为抛物线梁拱150（半宽12m时）。
-
The quasi-phase-matched conditions of collinear and noncollinear optical parametric generator are analyzed and the deflection angle is achieved.
分析了共线和非共线光学参量产生器的准相位匹配条件，得出满足准相位匹配条件的光偏折角。
-
When you fold the analysis of a mark line well-distributed, so that the entire line of flat, and mark; and scrape marks point to edges and corners are distinct, but the book these special molding semi-products, every 5 this cross-laminated broadcasting applanation machine applanation until the fully finished post-drying.
折挝痕线时用力要均匀，使整条痕线平直地翻起，并刮平痕角，使其棱角分明，把对裱成型的半成品书，每5本交叉叠放送压平机压平，待充分干燥后。
- 更多网络解释与折角线相关的网络解释 [注：此内容来源于网络，仅供参考]
-
knuckle line：折角线
knuckle line 船体棱缘线 | knuckle line 折角线 | knuckle line 折线
-
knuckle line：船体棱缘线
knuckle joint 肘接 | knuckle line 船体棱缘线 | knuckle line 折角线
-
knuckle line：折线
knuckle line 折角线 | knuckle line 折线 | knuckle mast 可折桅
-
knuckle molding：折角线缘材
knuckle molding 折角饰材 | knuckle molding 折角线缘材 | knuckle of the stern counter 尾部型线折角
-
knuckle molding：折角饰材
knuckle mast 可折桅 | knuckle molding 折角饰材 | knuckle molding 折角线缘材
-
length between perpendiculars：不等边角铁、不等边角钢
折角线L iron | 不等边角铁、不等边角钢length between perpendiculars | 两柱间长length overall