底涂层

词组短语

ground coat · bottom coat

与底涂层相关的网络例句 [注：此内容来源于网络，仅供参考]

Results indicate that surface roughness of the coating decreases and benthic diatom reduces attaching onto the coating with the increase of content of PTFE in paint studied.

结果表明，随着氟碳涂层中PTFE含量的增加，涂层的表面粗糙度降低，涂层上底栖硅藻的附着量随之减少。

By synthesizing three amine types inhibitor,we separately put them into top coat and ground coatings measuring with Electrochemical Impedance test and Salt fog test,the conclusion:corrosion inhibiting coal tar-epoxy coatings have more corrosion resistance than coal tar-epoxy coatings.

在环氧煤沥青的底漆和面漆中分别加入自行合成的胺类缓蚀剂R、Y和Z后，采用交流阻抗和盐雾实验等方法测试，结果表明，涂层的耐蚀性能有较大提高，涂层针孔电阻Rfp的值阻提高 2～ 3个数量级，并且涂层的物机性能不受影

This paper mainly studies effect and influence factor that typical corrosive medium (muriatic acid, vitriol, nitric acid, sodium hydroxide, sodium chloride etc.), consistence and condition temperature acts on the material coated on castiron centrifugal interface (PFEP, PPS, CPE, remodeled epoxy). It is studied that powder electrostatic spray, suspend fluid spray, suspend fluid electrophoresis underside coat etc. technics influences on coat quality coated with above four anticorrosive material. The property analysis is done that above four anticorrosive material and three coat technics adapt to centrifugal pump frame and running dynamic condition. In addition, the effect is introduced that castiron centrifugal coated anticorrosive material is used in coal water with alum.

本文侧重研究了典型腐蚀工作介质盐酸、硫酸、硝酸、氢氧化钠碱、氯化钠盐等品种、浓度、环境温度，对铸铁离心泵过流面的聚全氟乙丙烯、改性聚苯硫醚、改性氯化聚醚、改性环氧四种防腐涂层材料的试验使用效果和影响因素分析；研究了四种涂层材料粉末静电喷涂、悬浮液喷涂、悬浮液电泳底涂等涂装方法工艺对涂层质量的影响；四种涂层材料和三种涂装方法对离心泵结构和运行动态环境的适应性分析；介绍了铸铁离心泵防腐涂层在煤矿矾水中的应用效果。

The TCC technology was successfully applied to two of 160kA prebake cells in Pingguo Aluminum Company. It was shown that no tear-off of TCC was indicated after starting up of the cells. The operation of coating cells was improved to keep good shape of cell chamber, reduce the formation of sludge on the cell bottom, and gain more uniform current distribution.

将TIB：阴极涂层技术在160kA大型预焙槽进行了应用，并考核了涂层槽的指标，结果显示，焙烧启动后，TIB：阴极涂层不脱落，涂层槽的工作状态良好，炉膛规整，炉底干净，电流分布均匀；与对比槽比较，阴极内衬对钠的吸收减少，钠渗透速率减缓，炉底压降降低(平均降低39mv)，电流效率提高(平均提高0.41%)；涂层的寿命为38个月。

The TCC was still good and in integrity after 12h of electrolysis. The TCC technology was successfully applied to two of 160kA prebake cells in Pingguo Aluminum Company. It was shown that no tear-off of TCC was indicated after starting up of the cells. The operation of coating cells was improved to keep good shape of cell chamber, reduce the formation of sludge on the cell bottom, and gain more uniform current distribution.

将TiB〓阴极涂层技术在160kA大型预焙槽进行了应用，并考核了涂层槽的指标，结果显示，焙烧启动后，TiB〓阴极涂层不脱落，涂层槽的工作状态良好，炉膛规整，炉底干净，电流分布均匀；与对比槽比较，阴极内衬对钠的吸收减少，钠渗透速率减缓，炉底压降降低（平均降低39mV），电流效率提高（平均提高0.41％）；涂层的寿命为38个月。

The properties of TCC with ATS were as good as the TCC with HTS, better that the requirement of standard GB8744-88 for semi-graphitic carbon block. As good as TCC with HTS in industrial cells, the TCC with ATS also reduces the sodium penetration to cathodic lining, no tear-off of the coating was found after starting up of the cells. As compared with reference cells, the operation of coating cells with ATS was also improved to keep good shape of cell chamber, reduce the formation of sludge on the cell bottom, and gain more uniform current distribution. The ohmic drop of TCC cell bottom was lessened by 11. 5mV. The current efficiency was increased by about 1. 48% in average. It was estimated that the TCC life could be 44 months. Obviously, the TCC with ATS could also improve the performance of industrial cells, save energy, and increase the cell life.

对常温固化涂层槽的考核表明，与高温固化涂层槽一样，阴极内衬对钠的吸收减少，钠渗透速度减缓，从而减小钠膨胀危害，减少了铝电解槽早期破损的几率；启动后，常温固化涂层不脱落，同样具有良好的粘接性能；与对比槽相比较，常温固化涂层槽正常生产后，阴极表面干净、光洁，无沉淀或结壳，炉膛规整，阴极、阳极电流分布均匀，炉底压降降低（平均降低11.5mV），电流效率提高（平均提高1.48％）；涂层在电解槽内存在的时间可达到44个月以上；常温固化涂层同样可以起到改善电解槽工作状态、节能降耗、延长槽寿命的作用。

The properties of TCC with ATS were as good as the TCC with HTS, better that the requirement of standard GB8744-88 for semi-graphitic carbon block.AbstractAs good as TCC with HTS in industrial cells, the TCC with ATS also reduces the sodium penetration to cathodic lining, no tear-off of the coating was found after starting up of the cells.As compared with reference cells, the operation of coating cells with ATS was also improved to keep good shape of cell chamber, reduce the formation of sludge on the cell bottom, and gain more uniform current distribution. The ohmic drop of TCC cell bottom was lessened by ll.SmV. The current efficiency was increased by about 1 .48% in average. It was estimated that the TCC life could be 44 months.Obvi

对常温固化涂层槽的考核表明，与高温固化涂层槽一样，阴极内衬对钠的吸收减少，钠渗透速度减缓，从而减小钠膨胀危害，减少了博士学位论文摘要铝电解槽早期破损的几率；启动后，常温固化涂层不脱落，同样具有良好的粘接性能；与对比槽相比较，常温固化涂层槽正常生产后，阴极表面干净、光洁，无沉淀或结壳，炉膛规整，阴极、阳极电流分布均匀，炉底压降降低(平均降低11.smv)，电流效率提高(平均提高1.48%)；涂层在电解槽内存在的时间可达到44个月以上；常温固化涂层同样可以起到改善电解槽工作状态、节能降耗、延长槽寿命的作用。

The polymer of the over coat is dissolvable in a solvent that does not dissolve the polymeric base coat during application of the over coat.

所述顶涂层的聚合物可溶解于在涂覆顶涂层过程中不溶解聚合物底涂层的溶剂中。

RO_2·8% Y_2 O_3 was deposited by rf magnetron sputtering on NiCrAlY bond coat,thermal cyclingand fused salt effect experiments were made under the condition of 1100℃ room temperature 1100℃ cold water , and 900℃ room temperature,and were investigated by XRD and SEM,The results showthat ZrO_2·8% Y_2 O_3 deposited appears mainly as cubic and a little monoclinic phase and tetragonalphase.

将ZrO_2·8％Y_2O_3用射频磁控溅射技术沉积在NiCrAlY底涂层上，进行ll00℃→室温，1100℃→冷水和900℃→室温等热周期和熔盐作用的试验。随后进行X－射线衍射分析和扫描电镜（8EM）观察。结果表明，沉积态的氧化锆层主要为立方相和少量单斜相及四方相。

After paint has cured, you will probably see some texture to it - even if your undercoats were glass smooth.

经过油漆已经晾干了，你可能会看到一些纹理，即使你的底涂层平整地磨光。

与底涂层相关的网络解释 [注：此内容来源于网络，仅供参考]

antifouling coating：防污底涂层

antifoam 抗泡剂 | antifouling coating 防污底涂层 | antifouling composition 防污剂

blooming：起霜

底漆和底材中的颜料容易渗色的颜料在涂层表面析出的现象称之为起霜(blooming)产生的原因主要是因为橡胶底材表面的着色物质或底涂层中的着色颜料被面漆的溶剂溶解并迁移至面漆中导致渗...密封橡胶型材一般都是用黑色橡胶制造的,

coat：涂层

(2)涂层(Coat) 经一次施涂所得到的连续的膜. (4)底涂层(Priming coat) 在底材上涂底漆所形成的徐层. (5)中间涂层(Intermediate coat) 介于底涂层与面涂层之间的涂层. (7)湿膜(Film) 液态涂料施工到被涂物件表固后形成的可流动的液态薄层.

ground coat：底涂层

ground circle 基圆 | ground coat 底涂层 | ground colour 底色

ground coat paint：底漆,底涂油漆

ground coat 底涂层 | ground coat paint 底漆,底涂油漆 | ground colour 底色,底涂色

undercoat：底涂层

三、阳极电泳涂装(AED)和阴极电泳涂装(CED)的比较58二、车底涂层(undercoat)涂装工艺81四、汉高(Henkel)表面处理材料209

undercoat：底涂

undercoat 底漆;中间涂层;面漆下涂层 | undercoat 底涂 | undercooling 过冷

undercoating：底漆

undercoat 底涂层加敷底涂层 | undercoating 底漆 | undercommutation 整流不足

unpigmented base coat：无颜料的底涂层

gic activation factor 非生理性致活因子 | unpigmented base coat 无颜料的底涂层 | unpitched sound 噪声

scratch coat：底涂层

scraping straightedge 刮尺 | scratch coat 底涂层 | screed 抹灰准条