- 更多网络例句与工作电压相关的网络例句 [注：此内容来源于网络，仅供参考]
-
Based on the analysis of operation mechanism and development of the charge pump,as well as the factors limiting its efficiency and speed,a new method using triple-well structure and charge transfer switches is suggested to eliminate threshold voltage drop and body effect.The clock driving circuit is specially optimized to lower output resistance,and speed up the response.
在分析电压泵工作原理和结构演变并指出当前实现方法在驱动和响应上的制约因素的基础上，结合目前先进Flash Memory工作电压和工作要求，提出了结合三阱工艺和CTS方法以消除体效应和阈值电压降从而提高性能的四相位电荷泵设计方法，专门对时钟驱动进行的优化，提高了响应速度。
-
The "tile"is a power unit but , is voltage and voltaic product, voltage is to maintain fundamental note type computer operation operating voltage , electric current is the situation looking at operation , power consumption having diversity but, power consumption is higher if opening DVD and the trumpet , pure await the opportune moment power consumption is lower , the entirety comes say therefore the machine power consumption is not fixed, but is status have height to have consuming an electricity low.
而"瓦"为功率单位，为电压与电流的乘积，电压为维持笔记型电脑操作的基本工作电压，电流则视操作的状况，而有不同的耗电量，如开启DVD及喇叭耗电量较高，纯待机耗电量较低，所以整体来说，机器的耗电量不是固定的，而是有高有低的耗电状况。
-
Main features:- Hole spacing 2.25mm-operating voltage: 4.5 V to 24 V-switching offset compensation at 62Hz under - over-voltage Protection - VDD-pin Reverse voltage protection - Short circuit protection open-drain output is hot off - working magnetic field range: DC to 10kHz-output goes low with magnetic south pole contacts marked on the package side, while the higher magnetic flux density and area of S1, As S2-all temperature and supply voltage range magnetic parameters on-chip temperature compensation circuitry of the minimum drift - EMC meet DIN40839.
主要特点：–霍尔片间距2.25mm–工作电压： 4.5 V 至 24 V–开关偏移补偿在62Hz下–过电压保护– VDD-pin反向电压保护–短路保护漏极开路输出被热关断–工作磁场范围：直流到10kHz–输出变低用磁场南极接触封装上有标记边，而更高磁通量密度面积S1，如同S2–全温度和供电电压范围下磁参数的片上温度补偿电路的最小漂移– EMC适应DIN40839。
-
Using a single pulse solar cell tester with constant light intensity for 5ms, we have studied the performance of conventional crystalline silicon solar cell with low concentrator( 1～10 sun)and cells temperature of 15～110℃at laboratory.
结果表明，室温下常规太阳电池的最佳工作点电压V_m和光功率放大系数a随入射光强增加呈现先增后降的趋势，并且串联电阻小的电池下降速度慢，串联电阻大的电池下降速度快；温度对晶体硅太阳电池的工作电压和输出功率相当敏感；在严格控制太阳电池工作温度的条件下，串联电阻小的电池在较宽的聚光范围内可以获得良好的使用效果。
-
This product is applicable to coal mine where has explosible dangerous gas and coal dust,It is used for controlling direct starting stop and reversion of three-phase squierrel cage type asynchronous motor whose rated current up to 400A in system of AC50Hz rated voltage 1140V or 660V, Meanwhile it protects the electromotor and relative circuit, The starter can be combined with firedamp sensor and used to test the consistency of mining working area,the starter will trip when it exceed the limit ;adopt intrinsic safety type circuit for the control circuit; possess the function of local control and remote control by single set and multi sets procedure control; display working voltage current and gas consistency can remember fault parameter
该产品适用于具有爆炸性危险气体和煤尘的矿井中，在交流50Hz，额定电压为1140V或660V ，控制额定电流只400A的三相鼠笼式异步电动机的直接起动，停止及反转，同时对电动机及有关电路进行保护，起动器可与甲烷传感器相连接用于检测才掘工作面的甲烷浓度，当其超限时起动器跳闸；控制电路采用本安型电路；具备单台就地控制与远方控制及多台程序控制功能，能显示工作电压、电流、瓦斯浓度，并能记忆故障参数。
-
The experiment result shows, when extra magnetic field B=0, and supply voltage VDS is constant, inequipotential potentials VHO of the nc-Si/c-Si heterojunction MAGFET are close to zero output with increasing absolute value of the gate biased voltage VGS. Adopting gate biased voltage to compensate inequipotential potentials, compared with extra compensation resistance method, could improve magnetic sensor sensitivity, when supply voltage VDS is -1.0 V, magnetic sensitivity can be improved by 18%.
实验结果表明，当外加磁场B=0时，工作电压VDS恒定时，随栅极偏置电压VGS 绝对值增加，纳米硅/单晶硅异质结MAGFET不等位电势VHO逐渐接近零位输出；采用栅极偏置电压进行不等位电势补偿较外加补偿电阻方法可以使磁传感器灵敏度得到提高，在工作电压VDS为-1.0 V时磁灵敏度约提高18%。
-
Impact of an operating voltage on impulse over-voltage strength in the transformer is analyzed. Necessity of the operating voltage defined by the test voltage of the lightning impulse for UHV power transformers is pointed out. Through researches the maximum permissible operating voltage for the main isolation of UHV transformers is obtained.
分析了变压器的工作电压对冲击电压强度的影响；指出了雷电冲击试验电压定义下的工作电压对于特高压变压器的必要性；通过研究得出了特高压变压器的主绝缘的最大许用工作电压。
-
In this paper,the discharge capacity,stability voltage and the ratio of constant current charge capacity and battery discharge capacity of lithium ion battery were studied. For the lithium manganese lithium-ion batteries,the discharge capacity,mid-value voltage and stability voltage all increased with increasing charge cutoff voltage. As long as charge cutoff voltage was no less than 4.15 V,the battery discharge capacity loss would not exceed 6%. When charge cutoff voltage was 4.15V,the constant current charge capacity accounted for more than 85% of total charge capacity,a little change from 4.20 V.
主要研究了不同截止电压对锰酸锂离子电池的放电容量性能、工作电压和恒流/恒压充电容量等电池性能的影响，结果表明：对于锰酸锂材料锂离子电池，放电容量、中值电压和稳定电压都随着充电截止电压的升高而提高，电池的充电截止电压只要不低于4.15 V，电池放电容量损失就不会超过6%；当充电截止电压为4.15 V时，电池的恒流充电容量占总充电容量的85%以上，与4.20 V相比变化不大。
-
CJX2－d Series AC contactor is mainly used in the ciruit AC 50HZ (or-60HZ),rated insulating voltage is 380V unde AC-3 usage it can be combined with suitable thermal overload equipment into a electromagnetic starter to protect the circuit that may appear overload The comactor can be equipped with builbing block style auxiliary con tact group、air delaying contact、Interlonking mechanism and so on ac cessories to combined into time relay、reversible comtactor and star-delta starter.
CJX2-d系列交流接触器主要用于交流50HZ（或60Hz，额定绝缘电压为660V，在AC-3使用类别下额定工作电压为380V时额定工作电流至95A的电器中，供远距离接通和分断电器，并可与适当的热过载电器组成电磁起动器以保护可能发生过载负荷的电路。接触器可组装积木式辅助触头组、空气延时头、联锁机构等附件；组成延时继电器、可逆接触器、星三角起动器。
-
Disadvantage of this device is high voltage, in order to reduce the operating voltage to achieve the purpose of actual use, screening of high dielectric constant material as the dielectric layer material is topic of future research.
缺点是工作电压偏高，需要进一步筛选出介电系数高的物质来作为介电绝缘层材料，以便降低工作电压，达到实际可以使用的目的。
- 更多网络解释与工作电压相关的网络解释 [注：此内容来源于网络，仅供参考]
-
operating alternating voltage：交流工作电压
411. operate power 操作功率,运行功率 | 412. operating alternating voltage 交流工作电压 | 413. operating availability 可操作度
-
operating voltage：工作电压
其中,启动或放电电压(Discharge Voltage)是启动或者点亮灯管(CCFT)所需要的最低电压;灯管电压(Tube Voltage)或工作电压(Operating Voltage)是灯管被点亮以後的电压;灯管电流(Tube Current)是灯管被点亮以後的电流;CCFL的亮度直接与灯管的电流成比例;
-
operating voltage：操作电压,工作电压
operating range 操作范围,使用范围 | operating voltage 操作电压,工作电压 | operation 操作,运转,控制
-
Operating Voltage Indicator：工作电压指示器
operating voltage 工作电压 | operating voltage indicator 工作电压指示器 | opposed-voltage protective system 对消电压保护系统; 起动保护系统
-
optimum operating voltage：最佳工作电压
optimum anode voltage 最佳阳极电压 | optimum operating voltage 最佳工作电压 | optimum voltage 最佳电压
-
maximum operating voltage：最大工作电压
maximum machine voltage (计算机的) 最大运算电压 | maximum operating voltage 最大工作电压 | maximum output voltage 最高输出电压
-
nominal operating voltage：标称工作电压
nominal operating condition 正常工作条件 | nominal operating voltage 标称工作电压 | nominal output 额定输出,额定生产率
-
WV：工作电压
工作电压(WV):工作电压(working voltage)简称WV,为绝对安全值;若是surge voltage(简称SV或Vs),就是涌浪电压或崩溃电压;,超过这个电压值电容会爆!根据国际IEC 384-4规定,低於315V时,Vs=1.15×Vr,高於315V时,Vs=1.1×Vr.Vs是涌浪电压,Vr是额定电压(rated voltage).
-
VC--Clamping Volage：嵌位电压
VRWM--Work Peak Reverse Volage 反向工作峰值电压 | VC--Clamping Volage 嵌位电压 | VWM--Working Stand-off Volage 关态工作电压
-
working volts：工作电压
working volts direct current 直流工作电压 | working volts 工作电压 | working volume 工作容积