将电流应用于

基本解释 (translations)

galvanise

与将电流应用于相关的网络例句 [注：此内容来源于网络，仅供参考]

Based on the compensate admittance model of Steinmetz theory a method is put forward which use instantaneous values of load current and voltage to denote it. The simulations and practical application in the design of SVC model have shown that the proposed method is very effective, accurate, and with fast response performance.

本文基于不平衡负荷的平衡化原理(即Steinmetz原理)的补偿导纳模型，采用负荷电流电压瞬时值采样的方法补偿无功功率，并将该方法应用于SVC样机的设计，结果表明，它们是快速有效和准确的，具有实际的工程应用价值。

This invention concerns a current control process for a feed-in voltage converter, wherein a detected flux-inducing current component and a detected torque-inducing currrent component of an actual currrent vector of a rotating field machine are each controlled for a flux-inducing current component set value and a torque-inducing current component set value of the rotating field machine. To that effect, a control set-value (DELTA u*sp, DELTA u*sq) is determined, dependent each time upon a determined current component control deviation. From these, current components of an actual current vector are formed each time by overlay of a formed pilot value (u*spvor, u*sqvor). This invention also concerns a device for carrying out this process.

本发明涉及一种用于馈入电压式变流器的电流调节方法，其中分别将所检测的一感应式电机的一实际电流向量（i s 的磁通感应电流分量和一转矩感应电流分量i sq ）调节至该感应式电机的一额定电流向量的一磁通感应分量额定值和一转矩感应电流分量额定值，在这种情况下，分别根据所检测的一电流分量调节偏差计算出一调节器调节量（△u * sp ，△u * sq ），由这两个调节器调节量分别通过叠加所形成的一预控制量（u * spvor ，u * sqvor ）形成一额定电压向量的电压分量（u * sp ，u * sq ），本发明还涉及一种用于实施该方法的装置。

After the application of this model to the MITL-A of Sandia Z-accelerator, it is found that: the formation process of magnetical insulation leads to the increase of line current and the decrease of line voltage; If the initial line current is infinite, the terminal line voltage and current are almost the same as the initial ones; If the ratio of the terminal space-electron current to the terminal line current is less than 10%, the change of terminal line voltage and current of the MITL-A relative to the initial is less than 5%.

将模型应用于Z加速器的MITL-A发现：磁绝缘形成过程将导致线电流增加和线电压降低；如果初始时刻的线电流无限大，则终止时刻的线电压和线电流与初始时刻相同；当终止时刻的空间电子电流在线电流中的比例小于10%，则MITL-A终止时刻的线电压和线电流较初始时刻的变化在5%以内。