- 更多网络例句与堵塞现象相关的网络例句 [注：此内容来源于网络，仅供参考]
-
It is normal that the inverter has some radiation, please keep the fixing condition airiness and clean, don't build up the hole of airiness.
电源在使用过程中有一定的发热量属正常现象，但要保持安装环境的通风散热、干净清洁，特别不能堵塞通风孔。
-
Print cleansing:"nozzle cleaning agent" instead of a plug nozzle in the ink, the use of vector graphics software print the color block nozzle phenomenon clearance, re-use exchange for the return of the original ink.
打印清洗：用"喷头清洗剂"代替有堵塞喷嘴现象的墨水，使用矢量图形软件打印该颜色的色块，至喷头堵塞现象清除，重新换回原用墨水。
-
At work in the case of injector clogging, cleaning business card printing headers.
在工作中如出现喷孔堵塞现象，就要清洗制卡头。
-
At the same time to see oil eye nonblockage phenomenon is detected, and should be of the dredge.
同时要观察油眼有无堵塞现象，一旦发现，应予以疏通。
-
XRD and SEM analysis showed that the main composition of the white substance which formed in cracks is CaCO3, which can block cracks and is probably the main cause of self-sealing. Two processes which called surface reaction process and diffuse reaction process are defined in the formation process of CaCO3.The phenomenons in self-sealing experiment can be explained by those two processes.
对试件裂缝中沉积的白色物质做SEM、XRD分析得出其成份主要为CaCO_3，CaCO_3堵塞裂缝应该是引起自愈现象的主要原因；CaCO_3的生成包括表面反应和扩散反应两个阶段，这在一定程度上解释了自愈现象先快后慢和自愈幅度砂浆＞混凝土＞净浆。
-
It would take an hour or more to unravel the traffic jam.
得花上一个小时或更多的时间才能解除交通堵塞现象。
-
Inertial force still plays leading role under micro-metre scale, it could move the particles in micro-fluid so as to eliminate the chocking phenomenon of micro-nozzle.
惯性力在微米尺度下仍然起主导作用，可以驱动微流体中微粒的移动，消除微喷嘴堵塞现象。
-
The results shown that the surface was covered and the pores were blocked obviously for the coked catalysts, the specific surface area and pore volume lost greatly, pore size distribution shifted to small pore end.
结果表明，结焦催化剂表面积炭沉积和孔道堵塞现象严重，比表面积和孔容大量损失，孔分布向小孔范围迁移，催化剂孔径越小，损失越严重。
-
When left when the test-drive after repair in shop main engine is adding this ship to 540r/min, supercharger occurrence asthma brace up phenomenon, rotate speed lifts slightly again, noise shakes very big, smoke evacuation temperature is normal, hair of on the high side of temperature of air inlet duct is very hot, as good as of smoke evacuation smoke constant, supercharger rotor rotate speed and the rotate speed of right leader supercharger that work normally comparative. 2 breakdown analyse this model diesel engine supercharger breathes heavily brace up the reason has the following sides. Bearing of 1 supercharger rotor damages, bring about on the low side of supercharger rotor rotate speed or wave motion, make inadequacy of compressor part air feed and diesel engine and its demand do not match, bring about air current not to stabilize generation to breathe heavily brace up. 2 diesel engine offers oil, match gas to time forbid, match gas, draw well time and disorder, bring about supercharger to breathe heavily brace up. 3 supercharger nozzle jams, cause smoke evacuation not free, circumfluence of exhaust stroke waste gas, enter jackknife of new energy of life with the below one stroke that take energy of life, produce air current to hit generation to breathe heavily brace up. Canal of 4 smoke evacuation jams, smoke evacuation not free, bring about waste gas circumfluence, hit generation of new energy of life to breathe heavily brace up. 5 jams into gas mouth, enter gas inadequacy, generation breathes heavily brace up. 3 trouble removal are based on above analysis, adopt the following measure to remove trouble.
该舰在厂修后试车时左主机在加至540r/min时，增压器出现喘振现象，转速再略升高，声响震动很大，排烟温度正常，进气管温度偏高发烫，排烟烟色无异常，增压器转子转速和正常工作的右主机增压器转速相当。2故障分析该型柴油机增压器喘振的原因有以下几个方面。1增压器转子轴承损坏，导致增压器转子转速偏低或波动，使得压气机部分供气不足和柴油机及其需求不匹配，导致气流不稳定产生喘振。2柴油机供油、配气定时不准，配气、发火定时紊乱，导致增压器喘振。3增压器喷嘴堵塞，导致排烟不畅，排气冲程废气回流，和下一进气冲程进新气重叠，发生气流冲撞产生喘振。4排烟管堵塞，排烟不畅，导致废气回流，冲撞新气产生喘振。5进气口堵塞，进气不足，产生喘振。3故障排除基于以上分析，采取以下办法排除故障。
-
Secondly, the results of heat pipe experiments show that when the experimental sets of LED illuminator of LED was used in horizontal angles, resulting in the heat pipe which fill 2.52g water volume have the best thermal properties than others.
第二个研究之 LED 散热模组的实验结果显示，在水平使用时以2.52g水量为最佳，以本实验 27W的 LED 热源功率为例，热源区可维持在50℃左右的平衡温度，而当管内水量高於2.52g时皆有蒸气堵塞现象使热源区温度上升。
- 更多网络解释与堵塞现象相关的网络解释 [注：此内容来源于网络，仅供参考]
-
sleep apnea：睡眠呼吸暂停
睡眠呼吸暂停(Sleep Apnea)是一种发生在睡眠过程的呼吸障碍,主要特征是睡觉时反复出现短时间停止呼吸现象. 睡眠呼吸暂停大多是由咽部的组织塌陷并堵塞气道造成的,发生呼吸暂停时空气无法进入肺部.
-
no clogging：无堵塞现象
no burr 无毛刺 | no clogging 无堵塞现象 | no damage on coil wire 无线圈损伤
-
Fouling：堵塞
参、触媒使用后积灰及堵塞(Fouling)现象参、触媒使用后积灰及堵塞(Fouling)现象参、触媒使用后积灰及堵塞(Fouling)现象参、触媒使用后积灰及堵塞(Fouling)现象NH3 slip只有以湿式法分析(wet-chemical)最可靠.
-
clogged：否
clog /阻塞/ | clogged /否/ | clogging /闭合/阻塞/堵塞/堵塞现象/