均差

词组短语

divided difference

与均差相关的网络例句 [注：此内容来源于网络，仅供参考]

First, we discuss several theories of risk measures respectively such as theories ofcoherent measures of risk, spectral measures of risk and distortion measures of risk.Within the framework of these theories, we discuss and compare standard deviation,mean absolute deviation, lower partial moment, Ginis difference, VaR, CVaR and soon. We conclude that CVaR is superior to other measures with respect to theoreticalproperties.

首先，本文分别讨论了一致风险测度理论、谱风险测度理论、失真风险测度理论和随机占优一致风险测度理论等风险度量评价理论，在这些理论框架内讨论和比较了标准差、平均绝对离差、下偏位矩、基尼均差、VaR以及CVaR等风险度量。

In Chapter 2, one kind of rational cubic spline interpolation with linear denominator has been proposed, whose derivatives are replaced with accurate derivative values, difference quotient and arithmetic average difference quotientrespectively.

第二章给出了一类分母为线性的有理三次插值函数，当其导数值分别取为导数的精确值，一阶差商，以及算术均差商时，便得到三种插值格式，分别为给定导数值的有理三次插值函数，基于函数值的有理三次插值函数，以及基于算数均差商的有理三次插值函数。

And then some ellipses that AUGR estimator is better than the OLS estimator and AUGL estimator is better than the OLS estimator are given, respectively.Second, the definition of the almost unbiased unified biased estimator is proposed. This definition includes the familiar almost unbiased estimators in literatures, and it is the unified expression of the familiar almost unbiased estimators. Followed the biased and variance are compared of AUUB estimator and the unified biased estimator, respectively. AUUB estimator has smaller bias than UB estimator and the variance of AUUB estimator is between the variance of UB estimator and 4 times of the variance of UB estimator. Finally the properties of AUUB estimator are discussed. The conclusion is gained that there are parameters made AUUB estimator is better than OLS estimator in terms of their mean square error. The sufficient and necessary condition that AUUB estimator is admissible is given. The ellipse is given that AUUB estimator is

然后给出了几乎无偏统一有偏估计的定义，该定义包括了文献中常见的几乎无偏估计，实现了常见几乎无偏估计的统一表达式；接下来我们比较了几乎无偏统一有偏估计与统一有偏估计的偏度与方差，得出了几乎无偏统一有偏估计比统一有偏估计有较小的偏度，几乎无偏统一有偏估计的方差介于统一有偏估计的方差与统一有偏估计的方差的四倍之间的结论；最后我们对统一有偏估计的主要性质作了讨论，证明了存在参数K，S使得几乎无偏统一有偏估计在均方误差意义下优于最小二乘估计的结论，给出了几乎无偏统一有偏估计为可容许估计的充要条件，还给出了在均方误差阵意义下几乎无偏统一有偏估计优于最小二乘估计的椭球。

Based on this concept, calculating the values influenced by factors in double factor product index is transformed into calculating the diagonal average difference of matrix.

引入矩阵的对角均差概念，将计算双因素积指标的因素影响值转化为计算矩阵的对角均差。

Although some results on convex and concave iterative roots are known, there are no results about convexity for more general iterative equations. In this chapter, convexity of both increasing solutions and decreasing solutions is investigated by the divided difference theory and fixed point theory.

本章在连续函数构成的紧凸集上构造一个连续自映射算子，利用均差理论和不动点理论证明了线性型迭代方程的凹凸解的存在唯一性及连续依赖性。

Studied present measuring methods" advantages and disadvantages, and presented the necessity and importance of researching propellant transient heat transfer.2.according to 130 and aeronautic 90 rocket projectiles" structure, analysed and acquired physical and mathematical models for propellant transient heat transfer, also designed propellant temperature field simulation units for test.3.acquired discrete transient heat balance equation and temperature calculation program, and gave contrasting curves between experimental temperature values and program calculating temperature values as well as maximum errors and average square root errors between them.4.by programs based on the first class boundary condition, worked out temperature distribution in propellant temperature field simulation units at different time, analysed temperature field distribution law and main elements affecting heat transfer, acquired propellant mass weighted average temperature and one at the half position of propellant maximum thickness as well as maximum errors and average square root errors between them.5.established transient heat transfer mathematical model and temperature calculation program for the third class boundary condition, drew contrasting curves between temperature experimental values and calculation values and gave maximum errors and average square root errors between them, got temperature distribution in the simulation unit at different time and main elements affecting heat conduction, figured out propellant mass weighted average temperature and one at the half position of propellant maximum thickness as well as maximum errors and average square root errors between them.

分析了现有测试方法的优缺点，提出了研究推进剂瞬态导热的必要性和重要性。 2。根据130和航90两种火箭弹的结构，分析得到了推进剂传热的物理模型和数学模型，设计了推进剂温度场模拟实验装置。 3。得到了离散形式的瞬态热平衡方程和温度场计算程序，给出了实验温度与程序计算温度值的对比曲线及其最大偏差与均方差。 4。利用程序求出了第一类边界条件下、不同时刻推进剂温度场模拟装置中的温度分布，分析了温度场的分布规律和影响传热的主要因素，求出了推进剂质量加权平均温度和最大肉厚1／2处的温度时间曲线并给出了两者之间的最大偏差与均方差。 5。建立了第三类边界条件下的瞬态导热数学模型和温度计算程序，求出了温度实测值与计算值的对比曲线并给出了两者之间的最大偏差与均方差，得到了不同时刻温度场模拟装置的温度分布与影响导热的主要因素，求出了推进剂质量加权平均温度和最大肉厚1／2处温度及两者之间的最大偏差与均方差，讨论并确定了能代表130和航90推进剂温度的特征点的位置。

The results show that the organic-inorganic specialty fertilizer 〔16-6-8-20 〕is favorite to the yield increase and nitrate content decrease against tumorous stem mustard, and the inorganic fertilizer type Ⅱ(19-7-9) follows. Single superphosphate is better than monoammonium phosphate in increasing the yield whilst poorer in decreasing its nitrate content,sulfate of potash is better than muriate of potash in increasing the yield while weaker in decreasing its nitrate content,and fused calcium magnesium phosphate shows little desired effects.

结果表明：有机无机型专用肥〔16-6-8-20〕对茎瘤芥增产和降低其硝酸盐含量的作用最佳，其次为无机型专用肥Ⅱ(19-7-9)，过磷酸钙对茎瘤芥增产效果优于磷酸一铵，但降低其硝酸盐含量不及磷酸一铵，硫酸钾的增产作用优于氯化钾，但氯化钾降低硝酸盐含量的效果较好，钙镁磷肥对其增产和降低硝酸盐含量的效果均差。

As we know,Newton's interpolation polynomial is based on divided differences which can be calculated recursively by the divided-difference scheme while Thiele's interpolating continued fractions are grared towards determining a rational function which can also be calculated recursively by so-called inverse differences.

大家都知道，牛顿的插值多项式是基于均差的，可以递归出均差，而Thiele插值连分式是一个有理插值，也可以递归地计算，即所谓的逆。

There was no significant difference of higher order wavefront aberrations between emmetropic and ametropic eyes. Comparing the age of 40 years or less with the age over 40 years, there were significant differences in RMS3 between the two under 7 mm pupil size, and statistical diffenences in RMS6 and RMSh between the two under 4 mm pupil size.

除第2阶像差均方根(RMS2)以外，正视眼及近视眼各阶像差平均RMS值在7 mm与4 mm瞳孔下，差异均无统计学意义。40岁及以下者与40岁以上者相比，在7 mm瞳孔时，两者第3阶像差均方根(RMS3)差异有统计学意义；而在4 mm瞳孔时，两者第6阶像差均方根(RMS6)及高阶像差均方根差异均有统计学意义。

In this study, six campaigns around Anping tide gauge, Tainan, were successfully performed and the collected GPS buoy data were processed with four types of precise ephemeris provided by IGS, including final product, rapid product, ultra-rapid product and ultra-rapid product with the use of PPP technique. Comparing the PPP results with DGPS, the differences reach 3~5 cm in the horizontal and 10 cm in the vertical with final product; 6~8 cm in the horizontal and 15 cm in the vertical with rapid product; 15~20 cm in the horizontal and 30~40 cm in the vertical with ultra-rapid product; 2~3 m in the horizontal and 3~4 m in the vertical with ultra-rapid product. In addition, the collected data were also processed by DGPS techniques using different reference stations to analyze the effect of various baselines. The results show that accuracy degrades when the baselines increase.

本研究在台南安平潮位站旁进行6次GPS浮标施测，首先利用与GPS浮标距离不同之GPS参考主站来进行差分定位，分析基线距离对GPS浮标定位成果的影响，由实验结果可得出基线越长则定位准确度越低；再以IGS提供之最终产品、快速产品、超快速产品(Ultra-Rapid product)之观测部分observed half、超快速产品(Ultra-Rapid product)之预估部分四种不同发布延迟时间的精密星历与精密时表改正资料对GPS浮标进行精密单点定位解算，与传统差分相对定位方法定位结果进行比较后，得出使用最终产品之平面方向均方根误差(Root Mean Square Error， RMSE)可达3~5公分，而高程方向均方根误差可达10公分；快速产品之平面方向均方根误差可达6~8公分，而高程方向均方根误差可达15公分；超快速产品观测部分之平面方向均方根误差可达15~20公分，而高程方向均方根误差可达30~40公分；超快速产品预估部分之平面方向均方根误差可达2~3公尺，而高程方向均方根误差可达3~4公尺。

与均差相关的网络解释 [注：此内容来源于网络，仅供参考]

arithmetic average difference quotient：算术均差商

分数次差商:Fractional difference quotient | 算术均差商:arithmetic average difference quotient | 共振瑞利散射:resonance Rayleigh scattering

average deviation：均差

平均差(average deviation)各变量 值的离均差的绝对值的算术平均数, 用AD表示. 单项数列计算平均差的 公式为: N 叉}X一妇 AD=上二一-一一一- N 式中X,为各变量值,X为各变量 值的均数,N为变量值的个数. 组距 数列计算平均差的公式为: k 艺!

method of average error：均差法

( 变式:分组法(3)均差法(method of average error) 又称平均差误法method of average error. 均差法假定,我们的感官是有变化性的,因此不能得到一个"真实的"测量值. 于是我们取得大量的近似值,这些近似值的平均数是唯一的最佳近似值,

central divided difference：中心均差

central difference operator 中心差分算子 | central divided difference 中心均差 | central element 中心元

deviation from the mean：离均差Btu中国学习动力网

deviation 偏差; 变差Btu中国学习动力网 | deviation from the mean 离均差Btu中国学习动力网 | diagonal 对角线Btu中国学习动力网

difference quotient：均差

difference product 差积 | difference quotient 均差 | difference schema 差分格式

divided difference：均差,均差

divided developer 双液显影 | divided difference 均差,均差 | divided difference operation 均差运算,均差运算

divided difference operator：均差运动

均差 divided difference | 均差运动 divided difference operator | 被除数 dividend

divided difference operation：均差运算,均差运算

divided difference 均差,均差 | divided difference operation 均差运算,均差运算 | divided dose 分剂量

evection：月球均差

月球間隔 lunar interval | 月球均差 evection | 月球均差 lunar inequality