- 更多网络例句与喷流相关的网络例句 [注：此内容来源于网络，仅供参考]
-
Large rare gas clusters of Ar〓, Kr〓, and Xe〓 and hydrogen clusters were produced in the process of supersonic adiabatic expansion. Rayleigh scattering method is used to diagnose the cluster size.
大尺寸惰性气体原子团簇和氢分子团簇喷流的制备和诊断利用高背压惰性气体和高背压低温氢气经锥形喷嘴向真空超声绝热膨胀来产生团簇，用Rayleigh散射方法诊断团簇尺寸及团簇喷流的时间特性。
-
Numerical simulation of biconical body lateral jet is carried out by solving three-dimensional unsteady compressible Navier-Stokes equations,using AUSM+ scheme.
在导弹的侧向喷流设计中，必须考虑一些基本因素如喷管尺寸、位置、数量、流量、角度和喷流的温度影响等，其中最重要的是喷流与导弹外流的相互干扰，以及相互干扰所带来的气动力、力矩的变化[1-4]。
-
The aerodynamic pressure expression at jet location and in the area of jet interaction is established by blast wave principium.
采用爆炸波原理建立了喷流区和喷流干扰区的气动压力计算模型。
-
The skarn with special eruptive deposition and metasomatism is the main ore-bearing rock in Jiama deposits.
夕卡岩为西藏甲马铜多金属矿床的主要容矿岩石，具有独特的喷流沉积和喷流交代成因。
-
Relativistic jets are found in many radio-loud quasars and BL Lac objects. We explored the jet formation mechanisms for quasars, and found that the jets may probably be accelerated from the coronae above the disks at least in some active galactic nuclei with strong jets.
许多射电类星体和BL Lac天体已观测到相对论性运动喷流，我们研究了活动星系核的喷流形成机制，我们的结果表明至少部分活动星系核的喷流是从吸积盘的冕区被加速的。
-
The main characteristics of the skarn are as follows:(1)occurring as bedded,para-bedded in the contact zone between carbonate and microclastic rock,and its occurrence being accordance to the strata;(2)cut by later vein rock,so having no relation with the magmatic rock on genesis;(3)metasomatic skarn having replacement remnant texture,pseudobreccia structure,while depositional skarn,particulate crystall...
研究表明该夕卡岩的主要特征为：(1)呈层状、似层状赋存于碳酸盐岩和细碎屑岩接触带，产状与地层一致；(2 )被后期脉岩穿切，成因上与岩浆岩无关；(3)喷流交代夕卡岩具交代残余结构和假角砾状构造，而喷流沉积夕卡岩具微粒状结构、雏晶结构和层纹、条纹、条带状构造，反映了二者不同的喷流成因；(4)发育典型的低温夕卡岩矿物组合，其形成温度小于30 0℃；(5 )夕卡岩的稀土配分型式与围岩的一致。
-
Results indicate:(1) The newly developed simulation technology can form fairly average and easily controllable back pressure downstream the inlet, so it can he used to investigate the back pressure characteristics of hypersonic inlets.(2) By regulating the valve of injection pipe, the simulation technology can realize the switch of hypersonic inlet started state and unstarted state in about 8 milliseconds, so it is suitable to investigate the starting/unstarting/resarting problem of hypersonic inlets.
结果表明：(1)所提出的凹腔喷流技术可在进气道下游形成较为均匀的、可控的背压环境，因此可用于进气道的反压特性研究；(2)适当调节凹腔的喷流总压，并在实验中实时控制阀门的开度，凹腔喷流技术能够在较短的风洞实验时间内（约8s）实现进气道起动、不起动、再起动流态之间的切换，因此可用于进气道的不起动／再起动特性研究。
-
The effects of jet interaction on forces and moments are described by interaction amplification factor, and the algorithm to calculate the interaction amplification factor is presented, then the motion model and the dynamics model of interceptor are established according to the previous analysis.
根据大量参考文献的结论，分析了侧向喷流射入拦截弹外流的流场特征，以干扰放大因子来描述干扰效应对力和力矩的影响，给出了放大因子的计算方法，进一步建立了喷流侧向力和空气动力作用下的导弹运动学和动力学模型。
-
Compared with the low absorption efficiencies of a gas of atoms and molecules (less than 10%), it is demonstrated experimentally that a gas of clusters has much higher absorption efficiency. The absorption efficiencies to the laser energy are as high as 90% and 50% for rare gas clusters and hydrogen clusters, respectively.
实验发现，相对于原子或者分子气体喷流对激光的低吸收效率（小于10％），惰性气体团簇喷流和氢分子团簇喷流对飞秒强激光脉冲有非常强的吸收，吸收效率分别达90％和50％以上。
-
An analytical method to predict the effects of rotor downwash on engine jet was proposed to investigate the flow pattern of helicopter engine jet.
通过考察旋翼洗流对发动机喷流的影响来研究直升机发动机喷流的流动形式。
- 更多网络解释与喷流相关的网络解释 [注：此内容来源于网络，仅供参考]
-
backwash：喷流
backwash pump 回流泵 | backwash 喷流 | backwash-regeneration cycle 反冲洗-再生循环
-
backward backwash：尾流喷流冲洗
Backus normal form 巴科斯范式 | backward backwash 尾流喷流冲洗 | backward bent vane 后弯式叶片
-
jet deflection system：喷流偏转系统
jet deflection 喷流偏斜 | jet deflection system 喷流偏转系统 | jet deflector 射联向器
-
jet deflexion：喷流偏转
jet deflector 射联向器 | jet deflexion 喷流偏转 | jet deviator 偏流器
-
exhalation deposit：喷流矿床
喷出岩|effusive rock | 喷流矿床|exhalation deposit | 喷气孔|fumarole
-
gasjet：气体喷流 燃气流 煤气喷嘴
gasionizationdetector 气体电离探测器 | gasjet 气体喷流 燃气流 煤气喷嘴 | gasjetmethod 气体喷射法
-
squirter：喷(流),喷射器,喷出
渗入,透过,充满 penetrate | 喷(流),喷射器,喷出 squirter | 射流器 ejector
-
abrasive jets：磨料喷嘴;喷射磨料钻头;磨料喷流
abrasive jet wear testing 喷砂磨损试验 | abrasive jets 磨料喷嘴;喷射磨料钻头;磨料喷流 | abrasive lapping 磨料研磨
-
Jetting：喷流
浇口位置与喷流(Jetting)的关系 浇口若能布置成冲击型浇口 -- 也就是使得进浇后的塑胶熔体立刻冲击到一阻挡物(如型腔壁,芯型销等),让塑流稳定下来,就可以减少喷流的机率.
-
spouted bed dryer：喷流层干燥机
"rotary dryer ","回转式乾燥机" | "spouted bed dryer ","喷流层乾燥机" | "spray dryer ","喷雾式乾燥机"