压力喷嘴

词组短语

pressure nozzle

与压力喷嘴相关的网络例句 [注：此内容来源于网络，仅供参考]

One or several pressure nozzles are used to atomize the liquid feed for fountain atomization, depending on the plant capacity.

一个或几个压力喷嘴用于雾化液体饲料的喷泉，根据雾化装置容量。

To accelerate the widespread of Synchronous Chip Seal and improve the operation quality of Synchronous Chipsealer, key techniques which influence the operation quality is studied detailedly, including the control of distributing quality, the dynamics characteristics of hydraulic system and the spray characteristics of asphalt nozzle of Synchronous Chipsealer.1 The factors which influence Synchronous Chip Seal quality are studied. Fiducial probability of simultaneous distribution density is advised to be used in evaluating the distribution bias and standard deviation of asphalt and aggregates simultaneously, which is more advanced than the single index evaluation method used before.2 The volume efficiency formula of asphalt pump is revised after analyzing the data of volume efficiency with mathematical statistics, which is helpful to match the asphalt spray system and control the flow out of asphalt pump accurately. With equation deduction and experiment, dynamic of hydraulic system used in Synchronous Chipsealer is studied, which lay the theory foundation on improving the stability and efficiency from design and controlling.4 Simulation on hydraulic system used in Synchronous Chipsealer is done with AMESim; the results indicate that multi-circle parallel connected hydraulic system with constant pressure power is better than that with load-sensing pressure power at present, because the latter will oscillate when the multi circles work at the same time. This conclusion has been proved during the debug of Synchronous Chipsealer.5 Asphalt nozzle characteristics, such as flat jet shape, flow distribution, are studied with experiment, the results indicate that cross quality of asphalt distributing is not increased linearly follow the increase of fan overlap level, the best point usually exists between two whole overlap level, asphalt distributing quality is better than±4% at the 2.5 overlap level, meets the superior specified in standard; The distribution quality of Synchronous Chipsealer can be increased by spray asphalt of different flow rang with nozzle of different diameter

为了加快同步碎石封层技术的推广，提高同步碎石封层设备的作业质量，本文对同步碎石封层设备作业质量的影响因素与控制方法、液压系统的动力学特性和沥青喷嘴的喷洒特性等关键技术进行了深入细致的研究：1研究了影响同步碎石封层作业质量的因素，提出了采用联合密度分布置信概率对同步碎石封层中沥青洒布量和碎石撒布量的系统偏差和标准差指标进行综合评价的方法，克服了传统评价方法只能对单一指标进行评价的缺陷；2采用数理统计的方法，研究了沥青泵的容积效率特性，修正了沥青泵容积效率公式，为沥青喷洒系统的匹配和沥青泵出口流量的精确控制提供了依据；采用数理方程推导与试验相结合的方法，研究了同步碎石封层设备液压系统的动力学特性，为从设计和控制的角度提高同步碎石封层设备液压系统的稳定性和效率奠定了理论基础；3运用AMESim软件对采用负载敏感控制和恒压控制的两种同步碎石封层设备液压系统进行仿真，结果表明：负载敏感控制的并联液压系统在多回路同时工作时，由于液压泵排量控制参考压力不稳定，容易引发液压系统振荡，恒压控制的并联液压系统是目前技术条件下比较理想的同步碎石封层设备工作装置驱动方案；该结论亦通过同步碎石封层设备装机试验得到了验证。4采用试验的方法对沥青喷嘴的喷洒特性进行了研究，结果表明：沥青洒布的横向精度并不是随着喷洒扇面重叠度的增加线性增加，其最高点通常出现在二个重叠度之间的"半重叠位置"，"2.5重叠"洒布时，沥青的横向洒布精度≤±4%，可以达到国家相关标准中的优级标准；同步碎石封层设备还可以根据不同洒布量情况下的流量需求，采用不同通径的喷嘴进行喷洒，提高沥青洒布精度。

The heat transfer coefficient in the different water press, water flux and compared with the actual heat transfer coefficient the error in 5%~9% are got in the tests, It is shown that the tests of the nozzle heat transfer character provides proof for rational disposal nozzles and optimizing secondary water cooling system.

通过对喷嘴传热性能的测试，得到了水／气－水喷嘴在不同喷水压力下的传热系数；实验得到的双喷嘴平均传热系数与生产过程数据计算的传热系数的误差在5%~9%以内，研究结果表明喷嘴传热性能的热态实验可以为合理布置喷嘴、优化二冷制度提供依据。

The schlieren pictures were obtained at different injection pressure,sonic throat height and injector alignment.

采用纹影对天然气/空气流场进行光学显示，得到了不同喷射压力、喉道高度和喷嘴布置(单列6喷嘴和3列18喷嘴)条件下的流场纹影照片。

The invention also relates to a nozzle body (31) comprising a nozzle outlet which is disposed on the combustion chamber side end thereof, a nozzle needle (33) which is arranged in an axially displaceable manner and/or which can is actuated in a longitudinal recess (32) of the nozzle body (31); a throttle disk (25) which is arranged between the nozzle body (31) and the control valve (20) and which is closed on the rear end (oriented away from the nozzle outlet) of the longitudinal recess (32). Said throttle disk forms an opening stop for the nozzle needle (33) which co-operates with the rear front surface (orientated away from the nozzle outlet) of the nozzle needle (33) and defines the opening stroke of the nozzle needle (33), and a control chamber (45) formed between the rear nozzle needle front surface and the throttle disk (25), said control chamber being hydraulically connected to a pressure connection (29) which is used to supply fuel.

还设置了：一个喷嘴体(31)，在该喷嘴体的燃烧室侧的端部上构成一个喷嘴出口；一个喷嘴针(33)，该喷嘴针在轴向上可运动或可操作地安置在该喷嘴体(31)的一个纵向开口(32)中；一个封闭该纵向开口(32)的后面的端部的、安置在喷嘴体(31)与控制阀(20)之间的节流盘(25)，该节流盘构成用于该喷嘴针(33)的一个打开止挡，在此与该喷嘴针(33)的后面的端面协同作用并由此限定该喷嘴针(33)的打开行程的边界；和一个在该后面的喷嘴针端面与该节流盘(25)之间构成的控制室(45)，该控制室与一个用于燃料输入的压力接口(29)处于液压连接中。

In order to study the pressure-swirl nozzle's atomization characteristic, the particle diameter distributions along axis of the nozzle have been measured by immerging.

摘要为了研究一种高压静电压力旋转喷嘴的雾化特性，采用浸入法测量了该喷嘴喷雾雾滴粒径在喷嘴轴向的分布状况。

When the injection pressure is about 0.1MPa, the air flow through the injector becomes critical, so if the swirl level variation reaches the required range, the pressure should be kept as low as possible.

空气射束的喷射压力越大，涡流比的变化范围也越大。而当喷射压力达到0.1MPa左右时，空气在喷嘴内的流动已接近临界状态。因此，射束喷射压力不宜过高，在满足涡流变化要求的前提下，喷射压力应尽量低一些。

The nozzle of the gasifier is simplified. The cold-flow field in the gasifier chamber is studied. The research shows that the chamber has recirculation along the whole length. The particles in the chamber perform a very good flowing characteristics even for the large particles of dp=150μm, and no abrupt change is observed. This is due to the operational pressure is high and the density of the gas is large there. The maximal reflux velocity of both phases, the reflux intensity, the concentrational distribution of particles, and the static pressure loss in the chamber are all related to following factors: the load of gasifier, the concentration of coal-water slurry, the diameter of the coal particle, the distribution ratio of oxygen in the two channels of the nozzle, and the angle of jet in nozzle.

本文对水煤浆气化炉喷嘴进行了简化处理，在此基础上，对气化室内的冷态流动过程进行了研究，发现：整个气化室都处于流动的回流区长度范围以内；水煤浆气化炉中，由于操作压力很高，气相密度很大，所以即使对于dp=150μm的较大煤颗粒，其对流体的跟随特性也很好，没有发生流动特性突跃的现象；两相的最大回流速度、回流强度，颗粒相的浓度分布，以及气化室内的静压力损失等，均与气化炉的负荷、水煤浆浓度、煤粒直径、O2在喷嘴两个流道中的分配比例、以及喷嘴的射流角等参数有关。

The spray characteristics of three configurations of effervescent atomizers are measured in detail by the MF laser-scattering-analyzer, showing the effects of airliquid ratio, available pressure drop, atomizer geometry and axial distance from exit of atomizer.

这些结果显示了气液比，气液供应压降、喷嘴几何参数、混合腔压力、喷嘴轴向距离等因素对气泡雾化喷嘴喷雾特性的影响。

Therefore, by comparing particle distribution of the spraying under different water pressure, and the nozzle's outlet velocity simulation get by Ansys, which is a software for mechanical simulation, a proposal of the application of 1.5mm nozzle, 8Mpa water pressure on the spot was put forward.

在比较多种光学测粒仪的基础上，选择Winner313系统测量不同孔径喷嘴在不同供水压力下喷雾雾场的粒径分布。通过分析比较喷嘴在不同压力下喷雾雾场的粒径分布和Ansys模拟得到的喷嘴内部及出水口速度场，建议现场应用1.5mm喷嘴、供水压力为8MPa进行喷雾。

与压力喷嘴相关的网络解释 [注：此内容来源于网络，仅供参考]

CFM：每分钟立方英尺

在孔径测量处,测试器表明在喷嘴口要输送100psi(6.9MPa)的压力所需的空气量,以每分钟立方英尺(CFM)或每分钟立方米(m³/min.)计. Fe2O3 3.15% 氧化铁 (III)

deltoid：三角形的

deltamax 磁性合金 | deltoid 三角形的 | deluge nozzle 压力喷嘴

deluge nozzle：压力喷嘴

dclthirna size 冷法松香胶 | deluge nozzle 压力喷嘴 | deluge tower 烟道气洗涤器

nozzle dribbling：滴流喷嘴

鼓风喷嘴 nozzle; blast | 滴流喷嘴 nozzle; dribbling | 压力喷嘴 nozzle; pressure

sucking jet pump：吸引喷嘴泵

sucking and forcing pump 抽气压力泵 | sucking jet pump 吸引喷嘴泵 | sucking pump 抽吸泵

UNSTEADY：非定常

并不需要喷嘴流道尺寸变化之详细资料. 所造成之总质量流率的误差,例如:滑动(slip)及气泡体积因流场压力改变混合室之出口压力亦即喷嘴(Nozzle)的入口压力. 般而言,喷嘴的入口效模拟与对应. 因此,开发一套二维甚至是三维的,非定常( unsteady)的,

bottom hole flow bean：井底喷嘴

bottom hole dynamic condition 井底动态条件 | bottom hole flow bean 井底喷嘴 | bottom hole flowing pressure 井底流动压力

pressure nozzle：压力喷嘴

pressure lubrication system 压力润滑系 | pressure nozzle 压力喷嘴 | pressure nozzle 压力喷嘴

pressure nozzle：压力式喷嘴

可调喷管:Regulated-nozzle | 压力式喷嘴:pressure nozzle | 涡流喷嘴:Vortex nozzle

Combined spin-flow pressure nozzle：旋流式组合压力喷嘴

pressure nozzle相关词的翻译: | 旋流式组合压力喷嘴:Combined spin-flow pressure nozzle | 低压燃油喷嘴:oil nozzle at lower pressure