单道

词组短语

single track

与单道相关的网络例句 [注：此内容来源于网络，仅供参考]

Different coupling methods and anchor strength of the detecting rod have different interferences on signal reception.

首次采用了单道信号分析的方法，对比分析了接收探杆的不同耦合方式和锚固强度对信号接收的干扰特点，并研究了减弱或消除干扰的接收探杆耦合方法。

QDCSM can explain the properties of nuclear force quanlitatively, but can not reproduce the precise properties of the deuteron. The main reason is that the long-range of the interaction decays more rapidly than the real nuclear force.

QDCSM能定性的解释核力，但是单道和道耦合的计算发现不能很好描述氟核这个束缚态的种种精细性质，主要是长程相互作用比实际核力衰减得快。

Elding on metal base of anti-acid stainless steel.A 5kW laser with CO2 flow transverse was used for cladding Co-base alloy or Ni-base alloy powder replaced on the base metal.

使用5kW横流CO2激光器对预置于基体上的Co基自熔合金粉末进行单道或多道扫描。

This spectrometer can communicate with general purpose computer and can be controlled by it also.This spectrometer is high automatic and has powerful data processing ability. Single-chip microcomputer,Mssbauer spectrometer,Software

MS—2000型穆斯堡尔谱仪相对于FH—1918型Mssbauer谱仪具有以下新功能：能产生线性度很好的三角波，提高了Mssbauer谱的准确程度；自动单道测量γ能谱，并"卡"γ共振能峰犤5犦；谱数据掉电保护功能；上电自动

Because the traditional methods of measuring the energy spectrum adopt the single-channel and multiple-channels which results in needing certain distinguish time and cannot solve the problem of superimposed effect of near pluses, a new method adopting the inverse filter to measure energy spectrum is proposed.

由于传统测量能谱的方法是采用单道、多道的方法，其有一定的分辨时间，并且无法克服相近脉冲的迭加效应，提出了采用逆滤波器法测量能谱的方法。

When the austenite was deformed in the recrystallization region, sufficient deformation per pass brought about fully recrystallization, and refined the grain.

结果表明奥氏体再结晶区变形时，单道次变形量越大则再结晶进行得越充分，再结晶后的晶粒就越细。

The results of simulation experiments for single channel data or arbitrary channel of multi-channel data show the clearer event, the better wave shape and the higher SNR compared with the conventional convolution filter and common SVR based on RBF. So it is possible that SVR based on Ricker wavelet kernel function is applied to suppressing noise in seismic prospecting data.

对单道记录或多道记录中任选道的仿真实验表明，与传统的基于径向基核函数的支持向量回归及褶积滤波方法相比，使用本方法去噪后的同相轴更为清晰，波形恢复得更好，信噪比也较高，因此有可能将其应用于地震勘探记录的去噪处理中。

This paper using the FEM software Marc, for the 50 and 60 degree V groove of flat plate butt joint simulate the one-layer and three layers welding, finish each welding and cooling it down to room-temperature then start the next welding true represent process and get the temperature field, residual deformation and welding residual stress, according to the theory analysis and empirical equation verified the temperature field and residual deformation all correct, comparison with experiment verified the welding residual stress regularity and correctly.

本文利用有限元软件Marc，对开60°和50°V型坡口的平板对接接头，动态的模拟了单层单道打底焊，焊完一道后让试件冷却到室温以及单层单道满焊，每焊完一道后让试件冷却，然后再焊下一焊道，道间温度≤200℃，在以此为初始边界条件下开始下一道的焊接，真实的再现了焊接过程，得出了温度场，残余变形和残余应力场的分布规律，根据理论分析及经验公式验证了温度场以及残余变形的正确性，角变形的大小，这些结果与数值计算相吻合。通过与实验测得的残余应力进行比较，验证了焊接残余应力的分布规律及模拟的正确性。

Finally, by the deposit welding experiments of a single-track and multi-layer part and a multi-track and multi-layer part, the test results show that the measures are effective.

进行了单道多层和多道多层的堆焊试验，试验证明所提出的方法有效。

Self-fluxing Fe-Cr-Ni-B-Si alloy prowders are laser clad on medium carbon steel substrate of dimensions 80×35×10mm〓. The investigation results of this clad layer are: micro-defects, micro-cavity and occluded forin substance, are the micro-cracks and crack resourses in clad layer; crack of coating propagates along the boundary of two kinds of eutectic sutructure; The included angle θ between the cracking direction and laser scanning direction in multitrack overlapping clad is smaller than that in one-track clad because of crack propagating along crystalline growth direction and crystalline direction in overlapping zone being different from it in one-track clad.

在调质态的45〓钢表面，采用预置粉末法进行FeCrNiBSi合金的多道搭接激光熔覆，对其熔覆层进行分析表明：多道搭接激光熔覆层裂纹扩展方向与激光扫描方向间的夹角θ与单道熔覆时相比明显变小，前者θ0°，后者θ角基本都为90°，这主要是因为多道搭接时，搭接区结晶方向发生了变化以及裂纹沿结晶方向扩展所致；激光熔覆层裂纹大多是以覆层与基材交界面的孔洞、熔覆层内不同方向共晶团间的显微缩孔、夹杂物的边界等三种显微缺陷作为裂纹源，并沿低熔点物相形成元素偏析造成弱化膜的共晶团界面扩展延伸。

与单道相关的网络解释 [注：此内容来源于网络，仅供参考]

SCA：单道分析器

本实用新型通过聚光式光电探测器高效地收集单个离子的微弱信号,用单道分析器(SCA)对信号进行甄别处理,极大地消除了背景噪声,提高了信噪比,得到幅度一致的窄脉冲信号,确保了对离子信号的迅速响应以及1000米距离范围内信号传输的可靠性,

SCAMP Single Channel Monopulse Processor：单道单脉冲信息处理器

SCAG Selective Coronary Arteriography 选择性冠状动脉造影术 | SCAMP Single Channel Monopulse Processor 单道单脉冲信息处理器 | SCAMS Scanning Micro-wave Spectrometer 扫描微波光谱仪

single-channel carrier frequency telephone terminal：单路载频电话终端机

single-channel analyzer 单道分析器 | single-channel carrier frequency telephone terminal 单路载频电话终端机 | single-channel digital exploration seismograph 单道数字地震仪

single-pass welding：单道焊

单面点焊 indirect welding | 单道焊 single-pass welding | 单层焊 single-layer welding

single-pass welding：单道焊接

单底船 single bottom vessel | 单道焊接 single pass welding | 单板结构 single-skin construction

single-pass welding：单道熔接

单道凝结器 single pass condenser | 单道熔接 single pass welding | 单柜 single pivot

single-pass condenser：单道凝结器

单头开口扳手 single open-end wrench | 单道凝结器 single pass condenser | 单道熔接 single pass welding

single-pass drawing：单道拉丝

单模拉丝机single draft drawing machine | 单道拉丝single-pass drawing( | 光纤)拉丝机pulling machine

single-pass drawing：单道拉拔

single particle 单颗粒 | single pass drawing 单道拉拔 | single pass welding 单道焊

single-pass drawing：一次拉伸、单道拉拔

sine curve正弦曲线 | single-pass drawing一次拉伸、单道拉拔 | single draught一道压下量、一次拉拔