- 更多网络例句与功率损耗相关的网络例句 [注：此内容来源于网络，仅供参考]
-
Based on the novel resistance heater, a new fused biconical tapermachine with high quality is developed. The consistency of performanceis improved exponentially. The consistency of power loss is increased by5 folds. The consistency of coupling ratio is increased by 4 folds. Theconsistency of drawing length is increased by 20 folds.
基于新型的电阻加热器，研制了一种高品质的新型熔融拉锥机，成倍地提高了器件性能的一致性，其中光功率损耗的一致性提高5倍、分光比的一致性提高4倍、拉锥长度的一致性提高20倍。
-
When the brack is fully applied and there is no relative motion between the frictional elements, the power loss in the brake will be zero.
当brack是完全适用，不存在相对运动之间的摩擦因素，功率损耗刹车将为零。
-
This paper provides a new framework for the analysis of loss of power.
本文提出了一种功率损耗分析方法的框架。
-
In order to optimize performances of shunt active power filter of harmonic compensation, attenuation ratio for switching ripple, stability and power losses, an improved LCL filter topology was presented based on the analysis of the frequency characteristics of the LCL filter, in which a switching-ripple shunt branch and a series-inductor were adopted to the damping resistor to reduce the power losses dramatically.
为了使并联有源滤波器谐波电流补偿性能、开关纹波衰减率、系统稳定性和功率损耗等方面性能得到系统的折中和优化，提出了一种改进型LCL滤波器拓扑，该结构充分利用了LCL滤波器的频率特性，在阻尼电阻两端引入开关纹波谐振分流支路，同时在阻尼电阻上串联一小电感，有效的减少了阻尼电阻的损耗而不改变系统的静态和动态性能。
-
Secondly, a method based on SCADA to revise the parameter of transformers is proposed, in which the data is obtained from the substation SCADA system and is processed by least orthogonal square method, then the fitting calculation of the curve is performed, finally the actual parameters of the transformer can be derived and it can be used as the basic data for the economic operation of the transformer.
通过变电站监控系统得到SCADA实时数据，采用最小正交二乘法，对变压器损耗曲线进行拟合计算，得到变压器实际参数和功率损耗特性，并以此作为变压器经济运行的基础数据。
-
This article trend research and current situation of computing technology analyze in survey, through to simple network familiarity that trend calculate, take circuit of simple equivalence as an example, carry on circuit voltage and calculation that power loss of the first part and the concluding paragraph mainly, and then regard a ring network circuit as the main example and carry on the detailed trend to calculate, calculate all nodal voltage power losses, use ATP software to carry on artificial calculation with this example again, it's a pity ATP software emulation has not succeeded.
该文在综述了潮流计算方法的研究和现状分析，通过对简单网络潮流计算的熟悉，主要以简单型等值电路为例进行电路首尾的电压和功率损耗的计算，再以一环网电路为主要例题进行详细的潮流计算，计算各节点的电压功率损耗，再以此例题用ATP软件进行仿真计算，可惜ATP软件仿真没成功。
-
In view of this, a new single phase PFC circuit which uses the Bridgeless PFC power module and partial PFC control method is presented.
但是由于该PFC电路采用不可控整流桥，使用的功率器件数量较多，导致功率损耗较大，且使用的PFC升压电感较昂贵，因此具有效率较低和成本较高等不足。
-
Controlling the activity factor (in order to reduce interference and power consumption) can include: reducing the power level, prohibiting transmission of one or more devices, schwduling the transmission activity according to a stored timetable (actualised by location information or congestion bulletins).
控制活动因数(以便减少干扰和功率损耗)包括减少功率电平、禁止一个或多个设备的传输、根据所存储的时间表(该时间表是由位置信息或拥挤公告实现的)调度传输活动。
-
When precalcined at 930℃, MnZn power ferrites have highest initial permeability and density, lowest power losses.
当预烧温度为930℃时，MnZn功率铁氧体具有最高的起始磁导率和密度，最低的功率损耗。
-
Using the new concept, It is clear to identify losses of different wheelings without any hypothesis, and these losses satisfy the superposition theorem.
从而使得各个电源在某个支路内流经的功率和产生的功率损耗满足迭加定理，便于实际应用。
- 更多网络解释与功率损耗相关的网络解释 [注：此内容来源于网络，仅供参考]
-
DB Decibel：相对功率的对数表达,在光传输中,通常用来描述损耗
Dark fiber 暗光纤,备用光纤 | dB Decibel. 相对功率的对数表达,在光传输中,通常用来描述损耗 | DC Directional coupler 定向耦合器
-
power dissipated：功率损耗
增强型专用集成电路 power ASIC | 功率损耗 power dissipated | 功率耗散 power dissipation
-
full-power output：全功率输出
转速不是恒定的发电机所产生的电是不可直接使用的, 必须先贮存在直流电池(Battery), 然后再经逆流器(Convertor)转换才可使用的, 当中会有传输损耗; 能源损耗及热损耗, 所以可使用的电能一定少於全功率输出(Full power output)的数字.
-
insertion loss：插入损耗
插入损耗(Insertion Loss)即连接损耗,是指因连接器的导入而引起的链路有效光功率的损耗. 插入损耗越小越好,一般要求应不大于0.5dB. 1.引言 在安装任何光纤系统时,都必须考虑以低损耗的方法把光纤或光缆相互连接起来,以实现光链路的接续.
-
power loss：功率损耗
5.最后一个较小的问题,就是当我们计算功率损耗(power loss)时,为甚麼一定要用 ,而不可以用 呢?是不是绝不可能用 呢?这些问题都是和能量传送的电路(circuit)有关,Wayne将会和你细心分析. 1.在此课题其实非常适合一些对物理没有太大兴趣的同学,
-
power loss density：功率损失密度
power loss 功率损耗 | power loss density 功率损失密度 | power management 功率管理
-
RING-IN POWER LOSS：调制解调器功率损耗
RESTORE ON AC/POWER LOSS 恢复奥纳克/功率损耗 | RING-IN POWER LOSS 调制解调器功率损耗 | PCI DEVIES POWER LOSS PCI设备功率损耗
-
loos, return：回送损耗
loos, power 功率损耗 | loos, return 回送损耗 | loos, shunt 分流损耗
-
loos, insertion：插入损耗
loos, hysteresis 磁滞损耗 | loos, insertion 插入损耗 | loos, power 功率损耗
-
active power relay：有效功率电驿
有效功率损耗 active-power loss | 有效功率电驿 active-power relay | 活动率,活动性,放射性,放射强度 activity