- 更多网络例句与前驱相关的网络例句 [注：此内容来源于网络，仅供参考]
-
So, the smaller precursor and product were obtained. When decomposed into ceria particles, the precursor burst apart from～510nm to～300nm because of the gas come into being and expand.
在煅烧分解过程中，前驱物分解为二氧化铈粉末，由于气体的产生、膨胀使前驱物崩裂，发生崩裂及抽空行为，颗粒度由前驱物的～510nm变为产物的～300nm。
-
The washing procss of the precursor by water and alcohol can effectively reduce the hard aggregations.The best temperature for calcination of cobalt blue prceursor is about 950℃.
前驱体的洗涤过程采取水洗加醇洗的方法可有效减少样品的硬团聚现象，且前驱体的最佳煅烧温度为950℃左右。
-
In order to explore the mechanism of polymerization between lignin from effluent of pulping process and lignin precursors, the method and mechanism of co-polymerization of coniferin with model compound of β-O-4 type lignin were investigated.
为了探讨造纸废水中残余木质素与木质素前驱物之间的聚合反应机理，研究了β-O-4型木质素模型化合物与木质素前驱物松柏醇－β-D-葡萄糖苷－[α-13C]的聚合反应方法及其反应机理。
-
The results show that, using trioctylphosphane oxide or hexadecylamine as ligand, all of precursor ［In(η5-C5H5)］ decomposite and form the indium nanoparticles.
利用十六烷基胺或氧化三辛基膦配位体的作用，前驱体均可分解得到铟纳米颗粒；而在HDA相对含量高、溶剂中不含水和在紫外线照射作用下，前驱体分解反应产物为铟纳米线。
-
Through statistical analysis, it is demonstrated that the precursory wave related to the quiescent foreshock is more universal than the foreshocks.
统计表明，与寂静地震有关的前驱波比前震有更大的普遍性，出现的时间主要集中在主震前 7天之内，从一部分中等地震到特大地震之前都已观测到前驱波，这就说明大的脆性破裂之前，较小的缓慢破裂在自然界是存在的而且比较普遍。
-
Ultrasound chemical precipitation method was used to synthesize the precursor powderswith the ammonium oxalate and nickel nitrate hexahydrate as the raw materials.
然后，以Ni(NO_3)_2·6H_2O和(NH_4)_2C_2O_4·H_2O为原料，采用超声化学沉淀法制备出氧化镍前驱体，XRD图谱表明前驱体为NiC_2O_4·2H_2O，FTIR谱图分析进一步验证得到的前驱体是NiC_2O_4·2H_2O。
-
Precursors of sulfates and alkali halides prepared in co-deposition process were mixed homogenously, annealed at high temperature and then formed CoO and NiO fibers, XRD, XPS, Raman and SEM were used to characterized the samples, the growth of these fibers might be a special LS mechanism: soluble precursors in molten salt decomposed gradually to form initial crystal nucleus and succeeding particles adhered to these nucleus and grew anisotropically in the special high temperature fluent medium, the higher decomposition temperature and solubility of the precursor are two key factors in this method, which are in favor of a longer growth process and result in larger sizes of the final metal oxides crystals.
以共沉淀方法生成硫酸盐与碱金属卤化物融盐的均匀混合前驱物，在高温下退火制备出了CoO和NiO的晶须，以XRD和XPS等对成份进行了分析，SEM分析了形貌特征，研究了不同前驱物热分解特性，认为本方法是一种简单的LS生长机制：可溶性前驱物于融盐中热分解后逐渐析出成核，后续的粒子附着在核上，在融盐环境下沿一定方向作准一维生长，其产物形貌之不同源于硫酸盐的高分解温度和在融盐中的可溶性，导致晶体生长过程中成核过程与生长过程竞争的结果对一般前驱物结果的偏移。
-
The performace of material was tested by DSC,XRD,SEM,EIS and charge-discharge cycles . The influences of various synthesized condition , sintering time and the amount of F were studied and correlative technics parameter to improve performance of material were optimized. DSC shows that three endotherimc peaks and one large exothermic peak are observed in the temperature range 150-400℃, which is because of the removal of water,the decomposition of the organic constituents and the formation of spinel. Only the citrate precursor is sintered at least 450℃, the crystallinity of spinel phase could be formed intactly.
通过DSC、XRD、SEM、EIS和充放电循环等手段对材料进行性能测试，比较了不同合成温度、烧结时间和不同掺杂元素量等条件对材料性能的影响，优选出提高材料性能的相关工艺参数， DSC表明，采用溶胶-凝胶-络合法制备的前驱体在150-400℃中有三个小的吸热峰和一个大的放热峰，这是前驱体中的水分、柠酸酸及其盐和醋酸及其盐在蒸发及分解，柠檬酸前驱体至少需在450℃以上才可能形成完整的尖晶石材料。
-
The method is as follows: n-butyl titanate, absolute ethyl alcohol, surfactant and concentrated hydrochloric acid are fully mixed and stirred for 4 to 6 hours under room temperature to obtain precursor solution, then the precursor solution is spinningly coated on a clean conductive glass substrate of an indium oxide tin coating, and then the conductive glass spinningly coated with the precursor solution is preserved for 25 to 72 hours at the temperature of between 20 and 30 DEG C and the relative humidity of between 50 and 75 percent below, and finally undergoes a high-temperature calcination at the temperature of between 350 and 700 DEG C.
将钛酸正丁酯，无水乙醇，表面活性剂和浓盐酸充分混合，在室温下搅拌4小时-6小时得到前驱剂，然后将前驱剂旋涂在清洁的氧化铟锡镀层的导电玻璃基底上，接着在20℃-30℃，相对湿度在50％-75％下，将旋涂有前驱剂的导电玻璃保存24小时-72小时，最后经过350℃-700℃高温煅烧。
-
At first, the difference of the iron chloride and iron nitrate precursor was studied. By the photoelectrochemical results, the film prepared by iron chloride precursor showed better photoelectrochemical response than the film prepared by iron nitrate precursor, and the reasons were discussed.
研究中首先比较使用氯化铁前驱液与硝酸铁前驱液所制备出的氧化铁薄膜的差异，由实验结果知道，使用氯化铁前驱液的薄膜，其光电化学表现比使用硝酸铁前驱液的薄膜来得好，而研究中也探讨了其可能的原因。
- 更多网络解释与前驱相关的网络解释 [注：此内容来源于网络，仅供参考]
-
Prodromal exanthem：前驱疹
Pringle's disease; Sebaceous adenoma; Sebaceous nevus 皮脂腺瘤; 皮脂腺痣; Pringle氏病 | Prodromal exanthem 前驱疹 | Prodromal pellagral rash; Prodromal pellagra 前驱性玉蜀黍红斑
-
FWD：前驱
RAV4和CRV提供前驱(FWD)和全时四驱(AWD)车型,森林人全系标准配置为全时四驱. 基础版森林人X基础售价为19995美元,极限版XT售价在28195美元,全系列有5种截然不同的价格. 本田CRV前驱基本版FWD LX为20700美元,
-
Prodromal pellagral rash; Prodromal pellagra：前驱性玉蜀黍红斑
Prodromal exanthem 前驱疹 | Prodromal pellagral rash; Prodromal pellagra 前驱性玉蜀黍红斑 | Productive pulmonary tuberculosis 产生性肺结核
-
precursor：前驱物
已有研究显 已有研究显 已有研究显 已有研究显 示心房早期收缩是心房颤动之前驱物 (Precursor) 示心房早期收缩是心房颤动之前驱物 (Precursor) 示心房早期收缩是心房颤动之前驱物 (Precursor) 示心房早期收缩是心房颤动之前驱物
-
prodrome of labor：分娩前驱症状
prodromal stage 前驱期 | prodrome of labor 分娩前驱症状 | producd fibers 生产纤维
-
premedicate：前驱用药
premedicant 前驱药 | premedicate 前驱用药 | premedication 前驱给药法
-
prodromal：前驱症状的
prodigiouss 很大的 | prodromal 前驱症状的 | prodromalprodromicprodromous 前驱的
-
prodromal：前驱的 前驱症状的
prodmark 椎痕 | prodromal 前驱的 前驱症状的 | prodromalperiod 前驱期
-
prodromic：前驱的
prodromeoflabor 分娩前驱症状 | prodromic 前驱的 | prodromous 前驱的
-
Precursors：前驱材料,前驱体
precipitators 沉淀器,滤尘器 | precursors 前驱材料,前驱体 | prefabrication 预制