- 更多网络例句与刻线相关的网络例句 [注：此内容来源于网络，仅供参考]
-
During the experiment, the circular grating with 1200 grating lines was adopted, and the precision of the twist angle (less than 0.001°) was acquired while the rotational speed of the principal axis is within the range of 0～1500r/min.
实验中，测量系统采用1200条刻线的圆光栅，在主轴转速为0～1500r/min的范围内测量其扭矩，扭转角精度小于0.001°。
-
Slightly below or beyond the mark will not affect the normal operation of the gear reducer.
运行后观察油窗中的油位在油窗中间刻线处为宜，略高或略底均不会影响减速机的正常运行。
-
1 Unless otherwise agreed upon by the producer and user, scribe creepage is defined as "one sided", that is, from the original scribe line to the creepage front.
7.2.1 除非生产商和使用者另有达成的协议，刻线蠕变被定义为"一面的"，就是，从原先的刻线到蠕变前面。
-
Record the representative mean, maximum and minimum creepage from the scribe, and note whether or not the maximum is an isolated spot.
记录从刻线处代表性的平均值，最大值，最小值变化，标注最大值是否是一个孤立的点。
-
During the design of the line graticule, we did not use the ruling technique on glass, but selected Wwire to make the LOS and welded two electrodes at the two ends respectively. This design can avoid any possible error caused by the replacement of the crossline graticule observation when a multispectral optical system is tested.
该装置十字分划线的设计未采用常规的玻璃刻线工艺，而是选取电阻率较高的钨丝制成十字分划线，并在分划线的两端焊上电极，避免了测试时由于更换十字分划线靶标而可能产生的误差。
-
In his article entitled "On the manufacture of diffraction gratings and theoretical," the paper wrote,"If every inch with the same number of two engraved lines in contact with photographic copies of the state, the two grating The engraved lines are almost parallel will result in a set of parallel stripes, the direction of the two grating carved exterior angle between the line bisection, and their distance decreases with increasing inclination."
他在一篇题为"关于衍射光栅的制造和理论"的论文中写到"如果把每英寸具有同样数目的刻线的两个照相复制品处于接触状态，使两个光栅中的刻线几乎平行则就会产生一组平行的条纹，其方向将两个光栅刻线之间的外角二等分，而其距离随着倾角的减小而增大"。
-
In this paper, the hardwareconstitution, software module, core process technique including connected area disposalfor character recognition, infielder subdivision arithmetic for azimuth orientation andcompound of overall reading of system are emphatically introduced.
文中重点介绍了系统的硬件框架组成、软件模块结构、字符识别的连通域处理算法、刻线精确定位的内插细分算法以及系统总读数的合成。
-
This is achieved by using a unique multi beam technology, demonstrated in figure 2, which reduces the power density, minimizes the thermal load, and reduces the kerf width in the wafer.
这是采用独特的多光束技术实现的，图2显示了其工作原理，降低了功率密度，减小了热负载，缩小了刻线宽度。
-
Line scale is engraved on the front of a carved-foot line as the ruler's zero, as Figure 6-1-1b shows, when measured at a distance of access to high accuracy.
刻线尺是以尺前端的一条刻线作为钢尺的零点，如图6-1-1b所示，在距离丈量时可获得较高的精度。
-
Quasi-single field reflective scanning method.
钢带用做刻线模板，其刻线周期为200 m。
- 更多网络解释与刻线相关的网络解释 [注：此内容来源于网络，仅供参考]
-
line carver：刻线刀
line breaker 断路器 | line carver 刻线刀 | line casting machine 放钓机
-
dividing machine：刻线机
dividing error 分度误差 | dividing machine 刻线机 | divining rod 探深杆
-
photolithographic beam：光刻线
photoelectron 光电子 | photolithographic beam 光刻线 | photolithography 光刻法
-
beam, photolithographic：光刻线
beam, molecular 分子束 | beam, photolithographic 光刻线 | beam-deflection tube 射束偏转管
-
Reticle：刻线
此外,不仅设计技术不会直接转移至光罩上,光罩刻线(reticle)的形状与刻印在晶圆上的电路也会有所差异,让光罩检验的工作面临严苛的挑战. Numerical的Virtual Stepper软件可支持仿真式的光罩检验作业,能仿真硅组件在光罩以特定蚀刻条件蚀刻后所产生的结果,
-
scribe coating：刻线
scribe line definition 划线图案形成 | scribe-coating 刻线 | scribed circle method 圆形网格法
-
graduating machine：刻线机
车削 turning | 刻线机 graduating machine | 刮削 scraping
-
scrieve：划线,刻线,刻划
scriber 划线针,划线器 | scrieve 划线,刻线,刻划 | scrubber 净气器,滤尘器,洗涤器,洗涤塔,板刷,擦布,
-
ruled grating：刻线光栅
rule of similarity 相似规则 | ruled grating 刻线光栅 | rules for rounding off 舍入规则
-
Lubber's line：艏向刻线
恒向线 loxodrome; rhumb line | 艏向刻线 lubber's line | 光度 luminance; luminosity