- 更多网络例句与分解率相关的网络例句 [注:此内容来源于网络,仅供参考]
-
At the choosed conditions, oxidation rate of pyrite and arsenopyrite is 71.0% and 92.4% and decompound rate of nickel sulphide can reach to 88.8%.
在选定的工艺条件下,细菌对载金矿物黄铁矿、毒砂的分解率分别达到71.0%和92.4%;对硫化镍的分解率达到88.8%。
-
In the one half part, according to the strontium nature, thermodynamic calculation of correlative reaction and the principle of the vacuum aluminothermy reduction process, with the laboratory findings of preparation strontium by vacuum aluminothermy reduction compared and analyzed in different parameter conditions, a variety of factors which effect the decomposition rate of SrCO_3 and the percent reduction of strontia are gotten out. The factors include that the decomposition rate of SrCO_3 is influenced by different addition and pressure. They also include that the percent reduction of strontia is influenced by excess coefficient of reducing agent aluminium powder, the particle size of raw material or reducing agent, the pressure of barbecuing, temperature and reduction time. According to those, we can draw the conclusion as follows:(1) Decomposition temperature of SrCO_3 is decreased by adding carbon and alumina in different degree.(2) With quantitative carbon added under the vacuum condition, the decomposition temperature of SrCO_3 is decreased obviously, which can fall 150℃ compared with atmospheric pressure.(3) In keeping 1150℃ of 2.5h, under the 5Pa vacuum condition, the decomposition rate of SrCO_3 nearly keeps in 99% steadily.
在前半部分的真空铝热还原法中,根据锶的性质、相关反应的热力学计算及真空铝热还原法原理,通过对不同参数条件下的真空铝热还原法生产金属锶的实验结果的分析比较,得出了影响SrCO_3的分解率和氧化锶的还原率的种种因素,具体因素包括不同添加剂、不同气压对SrCO_3分解率的影响,还原剂铝粉的过量系数、原料与还原剂的粒度、制团压力、温度和还原时间等对氧化锶还原率的影响,得出具体结论如下:(1)添加碳和Al_2O_3能不同程度的降低SrCO_3的分解温度;(2)真空条件下加入一定量的碳可显著降低SrCO_3的分解温度,比之常压下可降低150℃之多;(3)在1150℃恒温2.5h、真空度达到5Pa的条件下,SrCO_3的分解率几乎保持稳定在99%;(4)氧化锶的还原率随还原剂过量系数的增大而增大,但是趋势越来越小,当过量系数超过25%后,氧化锶的还原率几乎不再增加;(5)氧化锶的还原率随原料与还原剂的粒度的变细而增加;(6)氧化锶的还原率随制团压力的增加而增加,但超过一定值后,氧化锶的还原率反而会下降;(7)氧化锶的还原率随还原温度的升高而增加;(8)氧化锶的还原率随还原时间延长而增加,在本实验条件下,超过2.5h趋于稳定。
-
The thermodecomposition of Li〓CO〓 charge was experimented and studied in a specially made vacuum furnace. The relationship of decomposition rate with temperature, pressure and time were obtained. The important principle of decomposition rate effected by pressure was acquired and conception of critical decomposition-pressure was presented.
在特制的真空炉内对碳酸锂物料真空分解进行了试验,得到了分解率与温度、压力、时间的关系;得到了分解率受压力影响的重要规律,据此提出了分解临界压力的概念,总结出了分解临界压力与温度的关系。
-
The best enzymolysis pH of cellulose was 6 and the enzymolysis temperature was 30℃.
该纤维素酶的最适酶解pH值为6,温度为30℃;Na对纤维素酶具有激活作用,Cu(上标 2+)则明显抑制纤维素酶的活性;VB2可以提高纤维素的分解率,VC使酶活力和纤维素的分解率明显升高。
-
The results show that the decomposition rate of ammonium jarosite can reach 98.03% under the following optimum conditions, which are m m=0.381 41, temperature 60 ℃, liquid-solid ratio 21, reaction time 2 h. During the alkaline decomposition, the impurity elements, such as Zn, In, Cu, Cd, Pb, Sb, Sn and Ag are left in the residue, while As is leached into the pregnant solution as AsO43 with leaching rate of 83.36%.
结果表明:在 m m=0.381 41、温度60 ℃、液固比21、反应时间2 h的最优条件下,铁矾渣的分解率达到98.03%,而原料中的杂质金属,如Sn、Sb、Zn、In、Cu、Cd、Pb和Ag等绝大部分留在分解渣中,As则以AsO43的形态大部分进入溶液,浸出率达到83.36%。
-
The paper analysed in detail the factors affect the fuel burning in calciner and the effect of CO2 concentration on meal calcining rate , and brought forward suggestion for design, alteration and operation.
详细分析了影响燃料在分解炉内燃尽的因素和分解炉CO2浓度对生料分解率的影响,针对烧无烟煤的分解炉的设计、改造和操作提出了针对性建议。
-
Meanwhile application of external re-circulation to calcining enhanced the thermal stability of calciner system. The required operating temperature inside a calciner may drop 30~ 50 ℃ by increasing recirculation ratio of 100%.
外循环方案有助于改善分解炉的热稳定性并降低分解炉的操作温度;在终分解率不变的情况下,物料循环率每增加100%,分解炉的操作温度可降低30~50℃。
-
When form solid film, cavitate bladder blow up in ultrasonic power, bring thousands K high temperature in the thumbnail time and the thumbnail spare, go with strong bow wave and mirshoot flow, it can intensify the process of mass transfer, so reaction rate with ultrasonic wave have higher than without ultrasonic wave.
固态膜形成后,在超声波作用下空化泡崩溃,在极短时间内和极小空间中产生几千K的高温,伴生强烈的冲击波和微射流,强化传质过程,因此在超声波作用下磷矿的分解率比无超声作用时的分解率高。
-
Combination reaction of the sodium aluminate solution produced by upstream desiliconization process, and aluminium hydroxide with certain quality index is produced, at the same time qualified mother solution is supplied in the ACCDP.
末槽分解率是反映碳分过程工况的重要工艺指标,但是分解率不能在线检测,只能通过离线化验,形成大滞后、非线性特性,严重影响碳分过程的优化运行。
-
The precipitation ratio of sodium aluminate liquors with the addition of cationic PAM is always lower than that of the blank in the early stage, and it is opposite in the late stage yet.
在种分附聚过程的前期,添加阳离子聚丙烯酰胺的铝酸钠溶液的分解率一直低于空白,而在后期,其分解率一直高于空白。
- 更多网络解释与分解率相关的网络解释 [注:此内容来源于网络,仅供参考]
-
bathtub curve:浴盆曲线
Effective方法是直接对浴盆曲线(bathtub curve)进行分析,将Tj分解为Dj和Rj. 这种方法与误码率测试仪(BERT)的方法相同. 在使用NQ-Scale方法得到不同BER下的Tj后,由于Tj = Dj + α×Rj,在不同BER下的系数α是已知,可以推算出不同BER下的Dj和Rj.
-
biodegradable:生物分解
陈瑞莲说,根据全球最大化工集团德国巴斯夫(BASF),再循环塑胶的成本比制造新塑胶更高,所以可生物分解(biodegradable)塑胶渐引起注意. 陈瑞莲指出,更有趣的是,由于较快的回酬率,在热带国家的淀粉来源,木薯往往比西谷椰子(sago palm)更受欢迎.
-
cellulase:纤维素分解酶
进行预处理时,通过使纤维素等生物质成分的组织结构发生纳米级变化,改进了与纤维素分解酶(Cellulase)之间的接触方式,提高了酶的分解率. 为了提高大幅影响工艺整体经济性的酶分解工序的成本效益,在设备内生产了基于线状菌的淀粉酶.
-
decomposition:分解作用
生态系统的分解(或称分解作用)(decomposition)是指死葡萄糖,进而成为矿物成分,称为异化;淋溶则是可溶性物质被水淋洗出来,是一种纯物理过程. 分解过程中,这三个过程是交叉进行、相互影响的. 生物地球化学循环可以用库和流通率两个概念加以描述.
-
dj:确定性抖动
将抖动分解为:总抖动 (TJ)、随机抖动 (RJ)、确定性抖动 (DJ)、周期性抖动 (PJ)、资料相关抖动 (DDJ)、信号周期失真 (DCD),以及由内部信号干扰 (ISI) 所产生的抖动次率抖动 (SRJ) 的隔离和分析,亦即位元率为完整次率的周期抖动.
-
external work:外功
能量代谢(Energy Metabolism) (一)代谢率(Metabolic Rate) 食物在体内完全氧化分解释放的能量与其在体外燃烧时所释放的能量是相等的, 它们在 体内氧化分解所释放的能量主要用于维持机体功能如消化和代谢食物, 维持体温以及机体活动,这些能量表现为外功(external work) ,热(heat)
-
FAA:游离氨基酸
蛋白质分解率最佳,含水分36%,ph5.4,含呈味核酸5'-imp5.4%,5'-gmp5.1%(以前该公司的标准酵母精不含5'-imp与5'-gmp),游离氨基酸(faa)与肽态氨基酸(paa)含量总和达72%(标准酵母精总氨基酸仅35%~50%).
-
irresolvable:不能分解
irresistible incident 不可抗拒的事件 | irresolvable 不能分解 | irrespective of percentage 无免赔率
-
decomposed granite:分解花岡石
減率 Declining rate | 分解花岡石 Decomposed granite | 廢水分解 Decomposition,wastewater
-
demulsibility:反乳化率
demulsibility 乳化分解性 | demulsibility 反乳化率 | demulsibilitydemulsifier 反乳化性