- 更多网络例句与分散体相关的网络例句 [注：此内容来源于网络，仅供参考]
-
The diferential thermal analysis test show that soy-isoflavone is dispered in pvpk30 in amorphism.
大豆异黄酮固体分散体的差示热扫描分析结果显示大豆异黄酮以无定型状态分散在pvpk30中。
-
KPF can be dispersed amorphously with the KPF/EC ratio 1∶2 and 1∶3. The release profiles of the drug can be fitted the Higuchi model. By increasing the amount and viscosity of EC, and increasing the particle size of the solid dispersions from 200 600 μm, the release rate can ...
体外释放度试验结果表明，药物体外释药行为均符合Higuchi 方程；缓释效果与EC 量和固体分散体的粒径有主要关系，药物释放速率随EC 用量和粘度增加而减小；固体分散体粒径越小药物体外释放速率越快；在pH 6 。8 介质中的体外释放速率高于在pH1 。2 介质。
-
In this paper, three kinds of hydroxyl component are prepared for two-component waterborne polyurethane paint, that is, acrylic dispersion, acrylic emulsion and silicone-modified acrylic emulsion. The influence of the composites of these dispersion and emulsions on polymerization process, viscosity, particle size and coagulum are investigated, infrared spectroscopy , inductance coupling plasma , transmission electron microscopy and thermogravimetric analysis are used to characterized their structure, composite, morphology and thermal stability, respectively.
本论文制备了三种用于水性双组分聚氨酯涂料的含羟基组分，即丙烯酸分散体、丙烯酸乳液和有机硅改性丙烯酸乳液，研究了这些分散体和乳液在制备过程中聚合物的羟值、酸值、玻璃化温度、乳化剂、反应温度等对聚合转化率、凝聚物含量、聚合物粘度和粒径的影响，用红外光谱、热重分析、透射电镜和感应偶合等离子技术表征了其结构、组成、形态和热稳定性。
-
Dispersoid.1. The author recommended the micro capsule technology for accomplishing an excellent dispersion of the pigment and a high stability of the blended dispersoid.
考察了颜料用于喷墨中的可能和问题，推荐微胶囊技术，以实现颜料分散体极好的分散性和分散稳定性，而且看出，微胶囊颜料分散体具有极好的抗水溶性有机溶剂的性能。
-
During the study of preparing soy-isoflavone solid dispersion tablet, disintegration time and dissolution rate of soy-isoflavone solid dispersion tablet was considered as inspection items, tempering uniformity design method was applied to optimize preparation prescription, partial least square method regression analysis was used to modeling for the data of uniformity design, the calculate results was consistent with the experiment validation results, and concluded that the optimizing prescription of soy-isoflavone solid dispersion tablet was Soy-isoflavone solid dispersion 0.18g, Amylum Pregelatinisatum 0.26g, CMSNa 0.03g, Gum Acacia 0.03g.
大豆异黄酮固体分散体片的制备研究中，由于大豆异黄酮固体分散体中的pvpk30含量较大，pvpk30本身的水溶性较好，不利于湿法制粒，且pvpk30是优良的干燥黏合剂，从而选择了全粉末直接压片法制备。
-
Howerer, solid dispersion is one of the technologies of increasing the bioavailability of indissolvable drug, which force drug being at high disperdion state, Generally, drug particle diameter in solid dispersions was 0.001～0.1um, mainly dispersed condition was molecularity, metastable amorphism and colloidal state.
而固体分散体是增加难溶性药物的生物利用度的常用方法之一，其主要是使难溶性药物在水溶性载体中处于高度分散状态，一般而言，药物在固体分散体中的粒径为0.001～0.1μm，分散状态以分子状态、亚稳定态及无定形态或胶体状态多见。
-
Two-component waterborne polyurethane paint composed of acrylic dispersion and hydrophilically-modified polyisocyanate has fast dry time, good adhesion, flexibility, impact resistance, but poor water and chemical-resistance. The dry time becomes shorter with the increase of glass transition temperature and the decrease of acid value; the gloss of the film decreases with the increases of hydroxyl value, acid value and Tg of emulsion polymer; higher Tg polymer leads to harder film.
将制得的丙烯酸分散体与亲水改性多异氰酸酯组分配制水性双组分聚氨酯涂料，发现漆膜表干和实干比较快，干燥时间随玻璃化温度升高而缩短，随酸值的增加而增加；附着力、柔韧性和冲击强度比较好；光泽随分散体羟值、酸值的增加和玻璃化温度升高而降低；硬度随玻璃化温度升高而升高；较高的酸值使涂料的耐化学品性和耐水性较差，羟值在100mgKOH/g时较好，而酸值应尽可能低。
-
The results of XRD and DSC showed that ginkgolides existed in solid dispersion at amorphous form or solvates form. The dissolution rate of ginkgolide B in solid dispersion was increased dramatically compared with raw material.
银杏内酯 B从PVP固体分散体中的溶出速率比原药粉末显著提高，且药物中银杏内酯A，B，C和白果内酯从固体分散体中的溶出相似性(f2值均大于 50)优于原药粉末。
-
VP-16 existed in the solid dispersion as amorphous forms or solvates based on the profiles of DSC and PXRD. The absorption of VP-16 was better in upper intestine, and the absorption of VP-16 solid dispersions in jejunum was improved remarkably.
VP-16在小肠上半段吸收较好，当载体对药物质量比≥3时，固体分散体在空肠段吸收有显著增加，且VP-16/S-40固体分散体的吸收比VP-16/F68固体分散体的吸收好。
-
Among aqueous polyurethane dispersion s, anionic polyurethane dispersions have been most frequently used in coating and adhesive industries.
在众多的水基聚氨酯分散体中，阴离子聚氨酯分散体在工业中得到广泛应用，特别是在涂料和黏合剂行业中。
- 更多网络解释与分散体相关的网络解释 [注：此内容来源于网络，仅供参考]
-
dispersoid：分散体
dispersive 分散的 | dispersoid 分散体 | dispirit 使沮丧
-
gas dispersoid：气态分散体
gas density balance 气体密度天平 | gas dispersoid 气态分散体 | gas dynamics 气体动力学
-
dispirit：使沮丧
dispersoid 分散体 | dispirit 使沮丧 | dispiritedly 气馁地
-
emulsibility：乳化性
(24)乳化性(Emulsibility) 油品和水形成乳化液的能力. (25)破乳化性(Demulsibility) 油品和水形成的乳化液分为两层的能力. (26)水混溶性(Water Miscibility) 油品和水形成溶液或稳定分散体的能力.
-
Flocculation：絮凝
(6)絮凝(Flocculation)在色漆或分散体中形成附聚体的现象. (7)胶化(Gelling)涂料从液态变为不能使用的固态或半固态的现象. (8)晶析(Partial crystallization)含有松香组分的醇溶性清漆或油基清漆,在储存过程中松香等局部结晶析出的现象.
-
grind：研磨
(11)研磨(grind) 在涂料生产中是指将拌合浆进一步解聚,分散成合于需要的分散体的工艺过程.形成的产物通称研磨(漆)浆. (12)调漆(Paint correction) 在涂料生产中是指对研磨漆浆进行稳定化的工艺过程. 包括调整颜色、补齐用料,
-
weight percent：重量百分比或重量
dispersion 分散液(分散体) | 36. weight percent 重量百分比或重量% | percent by weight 重量百分比或重量%
-
Printing Inks：印刷油墨
根据本发明的有机颜料分散剂能够将各种有机颜料稳定地分散于用于涂料(paints)的分散介质、印刷油墨(printing inks)和用于滤色器的涂料流体中. 根据本发明的易于分散的颜料组合物和分散体作为颜料可用于滤色器的涂料流体,
-
ionomer：离聚物
本工作合成了水性丙烯酸聚氨酯分散体,利用二羟甲基丙酸作为亲水基团[2-3],制备离聚物(ionomer)分散体. 测试了固化膜的性能,并讨论了软段分子量,异氰酸酯类型,亲水基团含量,以及中和程度对性能的影响.
-
dispersions：分散体
dispersionresin 分散树脂 | dispersions 分散体 | dispersionspinning 分散纺