英语人>词典>汉英 : 再装 的英文翻译,例句
再装 的英文翻译、例句

再装

基本解释 (translations)
reload  ·  reloaded  ·  reloads

更多网络例句与再装相关的网络例句 [注:此内容来源于网络,仅供参考]

I had found a perspective glass or two in one of theseamen's chests, which I saved out of our ship, but I had it notabout me; and this was so remote that I could not tell what to makeof it, though I looked at it till my eyes were not able to hold tolook any longer; whether it was a boat or not I do not know, but asI descended from the hill I could see no more of it, so I gave itover; only I resolved to go no more out without a perspective glassin my pocket.

因此,我毫不怀疑,那些旧帆布早已烂掉了。事实上,大部分也确实烂掉了。可是,从这些烂帆布中间,我还是找到了两块帆布,看上去还不错,于是就动手用来做船帆。因为没有针,缝制起来就十分费力费时。花了不少力气,才勉强做成一块三角形的东西,样子丑陋不堪。那船帆的样子像我们英国的三角帆;用的时候,帆杆底下装一根横木,船篷上再装一根横木,就像我们大船的救生艇上装的帆一样。

The gunman removed a box of bullets from his coat pocket and placed it on a table. Then he began loading, ejecting and reloading.

枪手从大衣口袋里掏出一盒子弹,放在桌子上,然后开始装弹,卸弹,再装弹。

Instaled at the end of the motor.If you want to use the manual control adjustment, you can instal it again.

装于电机尾部的手轮在使用电动调距时必须取下,在需要使用手动调距时再装上。

Failure phenomenon: Friends earlier removed to clean the motherboard, and then forgot when装上去switch and reset button that is exclusive pin plug of how he used the key copper pin in the row, then sweeping, saw sparks flash, there is no movement on the Main Board of the.

故障现象:好友前段时间将主板拆下来清扫,等再装上去的时候忘了开关和复位键那排插针是怎么插的了,他就用铜钥匙在那排插针上扫了一下,只见火花一闪,主板就再没有动静了。

Chief tallyman, please start loading from back to front and you must finish loading in hold first, then on deck, ok?

理货组长,装船请从后面向前面装,你们必须装完舱里再装甲板的,好吗?

Dissembly the handwheel at the end of the motor, when you adjust on auto mode. Assemly the hand wheel when you need to use manual adjustment mode.

装于电机尾部的手轮在使用电动调距时必须取下,在需要使用手动调距时再装上。

Armatures originally produced with a solid fill epoxy coating that have not been resoldered or reshafted do not need revarnishing.

原来生产的有环氧层的电枢没有重新锡焊和再装轴的不必再浸漆。

And then loaded wrench head 74 and handle 47, mounted on the washer 75, with nut 52 solid tight.

10再装上扳手头74及手柄47,装上垫圈75,用螺母52固紧。

Mounted coupling: first in the motor shaft mounted on the head ring, mounted on coupling half, and then in the shaft coupling client and loaded block chute and Plum wrench tightening bolts (lifting shaft 3 ~ 5 mm and to provide mechanical seal prestressed); and then loaded up the other half on the coupling screw Hexagon screw must be tightened.

装联轴器:先在电机轴头上装上挡圈,装上一半联轴器,再在泵轴端和联轴器槽内装上挡块并用梅花扳手拧紧螺栓(吊起泵轴3~5毫米并提供机械密封预应力);再装上另一半联轴器拧上内六角螺钉必须拧紧。

Mounted coupling: first in the motor shaft fitted with ring head, fitted with coupling half, and then end in the shaft and the coupling block bed fitted with Plum wrench tightening bolts (lifting shaft 3 ~ 5 mm and pre-stressed mechanical seal); and then loaded onto the other half of the coupling screw Hexagon screw must be tightened.

装联轴器:先在电机轴头上装上挡圈,装上一半联轴器,再在泵轴端和联轴器槽内装上挡块并用梅花扳手拧紧螺栓(吊起泵轴3~5毫米并提供机械密封预应力);再装上另一半联轴器拧上内六角螺钉必须拧紧。

更多网络解释与再装相关的网络解释 [注:此内容来源于网络,仅供参考]

Reload Microcode:再装微码

&Refresh=刷新(&R) | &Reload Microcode=再装微码(&R) | &Report on database resources=从数据库提取资源(&R)

refillable container:可再装容器

referred to ...;提及;; | refillable container;可再装容器;; | refinancing;重新筹集资金;再筹划资金;;

refilling:再装油

refill 再装品;替换物;再装满;回填 | refilling 再装油 | refine 炼制

reloading point:再装站

reloading 换装 | reloading point 再装站 | remaining charge 残药

reloading operation:再次加载操作; 再装油作业

reloader 复载机 | reloading operation 再次加载操作; 再装油作业 | reloading 再装

No Reloading:不用再装弹药

Your Car Is: Indestructible 汽车不可破坏 | No Reloading 不用再装弹药 | vcs更新说明:

resaddle:再装子

res 物品 | resaddle 再装子 | resail 再航行

recharging:再装料

rechargeable 可再充电的 | recharging 再装料 | recip compressor 往复式压缩机

refilled liquefied petroleum gas cylinder:再装注石油气瓶

refill 重新注入;补充 | refilled liquefied petroleum gas cylinder 再装注石油气瓶 | reflection 反射

We'll install the wiretaps tomorrow:我们明天再装窃听器

-Anything else, Dr. B? -No thanks, Dan.|还有别的什么吗,医生? 没有了,谢谢,丹 | We'll install the wiretaps tomorrow.|我们明天再装窃听器 | Wiretaps?|窃听器?