内口板

基本解释 (translations)

endostoma

与内口板相关的网络例句 [注：此内容来源于网络，仅供参考]

Based on this development trend, this dissertation concerns the agricultural busywork of based on GPS and other advanced technologies...

作者研制的"基于GPS的农用车辆导航轨迹显示信息系统"的功能实现过程为：卫星信号经GPS-OEM板接收后，由板内高速信号处理部件进行计算分析后给出精确的经纬度、时间等信息，这些信息经过GPS-OEM板的输出端口传送给单片机，单片机接收到GPS-OEM板传来的信息时，产生串口中断，对收到的经纬度和时间等信息进行处理，校对数据内容，转换数据格式，存储数据，同时对经纬度数据进行坐标转换，使之与预定路径图形进行位置匹配，将车辆位置以点的形式实时显示在液晶显示屏上。

The mouth openings of 58 cases were over 37 mm, only 4 cases less than 37 mm in 3 months postoperatively. Conclusion: The miniplate internal rigid fixation has the advantages over conventional intermaxillary fixation and wire fixation

下颌骨骨折的小型钛板坚固内固定效果可靠，避免了颌间结扎；对颞下颌关节功能影响小；口内手术入路避免了面部皮肤瘢痕；较传统的下颌骨骨折颌间结扎固定及钢丝拴扎固定有明显的优点。

Methods: We exposured the location of the fractures (except mandibular ramus and condylar fracture) through intraoral incision approach, then using titanium neil to reposition the fractures as an anchorage. After restitution the occluding relation, we used minitype titanium board for rigid internal fixation without intermaxillary wiring.

18例患者均采用口内入路暴露下颌骨骨折部位，用钛钉作支抗复位下颌骨骨折，恢复其咬合关系后，用小型钛板作坚固内固定，术后不行颌间结扎。

The straightening and outlook of the penis were satisfied, the meatus located at normal position after operation.

游离包皮内板一期尿道成形术后阴茎伸直及外观满意，尿道口位置正常。

Part two: Urethroplasty by using skin oversleeve with vesicomucosa to treat hypospadias.

为解决单独使用膀胱粘膜尿道成形术后并发症较多的问题，我们设计了皮肤袖套式膀胱粘膜尿道成形术治疗重型尿道下裂及部分首次手术失败的尿道下裂患儿，即用游离包皮内板或游离阴囊中隔皮片在尿道外口处做成一短段尿道，然后用游离膀胱粘膜形成全段人工尿道并从包皮内板或游离阴囊中隔皮片做成的尿道内穿出。

Objective To observe the treatment effect of using screwed miniplates through an intraoral and transoral approach for patients with angle and ramus fractures.

目的：观察口内切开和经颊小切口穿刺手术入路处理下颌骨角部和升支部骨折，并用小钦板坚固内固定的疗效。

objective the purpose of this study was to summarize our experience of the application of internal rigid fixation with miniplate to treatment of mandibular fractures.methods a retrospective analyisis of clinical data of 67 cases,who had experienced the anatomic reduction and rigid fixation by using miniplate.with the help of maxillomandibular distraction pre operation and post operation and temporary maxillomandibular fixation during operation,the fracture bones were smoothly reduced and fixed.results clinical and radiographic examination showed that all cases gained good clinical results and precise anatomic alignment of fracture postoperatively without infection,malocclusion,bone malunion or other complications.conclusion mocortical miniplate fixation of the mandible is a reliable and effective techinique providing rigid fixation and an ideal modality for the treatment of mandibular fractures.combined with maxillomandibular fixation.

对67例下颌骨骨折患者的临床资料进行回顾总结，所有患者应用小型接骨板行坚固内固定治疗。其中7例颏部骨折，12例颏旁骨折，16例颏孔区骨折，9例体部多发性骨折，5例体部粉碎性骨折；18例合并其他部位骨折。所有患者术前经临床检查和影像学检查明确骨折的位置和骨折线的数目后，分段牙弓夹板结扎、颌间弹性牵引，使移位的骨折段逐渐复位；术中经口内切开复位、细钢丝颌间结扎、小型接骨板坚固内固定；术后行临床检查和影像学复查，必要时颌间弹性牵引7～10 d。结果所有患者手术切口ⅰ期愈合，治疗效果满意；临床检查所有患者牙合关系良好、面部对称；影像学复查证实骨折线对位良好。结论经口内切开小型接骨板坚固内固定辅以颌间固定治疗下颌骨骨折效果可靠，术后并发症少，是一种理想的手术方法。

Methods: Treated 68 patients with mandibular fracture by intraoral incision miniplate rigid internal fixation technique.

68例患者下颌角骨折行口内切开复位微型钛板内固定。

The research shows that, when fluidized gas is used only, it had little effect on the quantity of returning solids, and that the effect of loosed gas is significant. Horizontal opening has distinct effect on the circulating rate only when the loosed gas is larger; the appropriate horizontal opening is corresponding to the gases quantity. The combining of the arced gas distributor and the gases regulating could eliminate the fluidized dead zone in the U-valve effectively.

结果表明，单一流化风对循环量的影响较小，而松动风对循环量的调节幅度比较大；水平孔口开度只有在松动风量较大时对循环量的影响比较明显，而且合适的水平孔口开度与输送风量的大小相对应；利用圆弧形布风板和气量调节相结合可以很好地消除阀体内的流化&死区&。

Store opening and closing documents on transportation should be at the closing device, and also should do the following: a valve flap should be fixed in the open position b path ends with a foam board to plug in port, the port to be plugged with a boring cover, to dust, rust, clean and maintain the channel end of the formation; c cylinder parts to the appropriate protective packaging, shock and anti-collision; d valve should be placed on a smooth, pneumatic drive upwards, not with each other by the crowd.

存放月运输时启闭件应处于关闭装置，同时应做好以下工作： a 阀瓣应固定于开启位置 b 通径两端内口用泡沫板堵塞，端口须用闷盖塞紧，予以防尘、防锈，保持通道清洁和端面的平整； c 汽缸部位进行适当的包装防护、防震和防碰； d 阀门放置时应平稳，气动驱动装置朝上，不得相互受挤。

与内口板相关的网络解释 [注：此内容来源于网络，仅供参考]

Bottom：底板

而且模具上板形出错模具就有可能报废 板形有:楦头板(LAST)、皮料板(TOP NET)、内仁板(TOP)也叫口板、上外板(TOP OUT)、底板(BOTTOM)、最外板、内侧板(LATERAL)、外侧板(ME1.板形:这是鞋模中最最重要的.

columella：壳轴

(apex),是壳最先形成的部分,由壳顶围绕中心壳轴(columella)连续放多海产螺由壳口外翻,形成外唇(out lip)与内唇(inner lip). 壳表面如海牛(Doris)等. 壳的多样性不胜枚举. 螺(Natica)、蝾螺(Turbo)是石灰质的,这是由于角质板上大量沉积的碳身体前进.

cyst：包囊

血管内压增加,肠蠕动 虫卵随坏死组织落入肠腔 随粪排出.十二指肠钩口线虫(Ancylostoma duodenale)简称十二指肠钩虫;美洲板口线虫(Necator americanus)简称美洲钩虫.● 包囊(cyst)或卵囊(oocyst):原虫生活史中静止不动,

pharynx：咽部

在口前腔之后由消化道再向内些,约在内腹板(endosternite)上方位置,一般区别为咽部(pharynx)这里有个梨形的腔室经由肌肉反覆收缩舒张运动,产生泵(发音同"蹦")压,主动把食物糜吸入肠道(原理就像过去乡村汲水唧筒一样利用负压,

prom：可编程序的只读存储器

XS1-G4 可从联合测试工作组(JTAG)、1个SD/MMC卡或板上串行外围设备接口(SPI)启动的可编程序的只读存储器(PROM)上启动. 除了内置多媒体I/O,设计者还可以使用板上开关、状态发光二极管(LED)以及IDC扩展端口.

spirometer：肺量计

而肺量计检查是利用肺量计(spirometer)测量通气时肺的容积和都必须能量测容积(volume)、流量(mass flow)和时间(time )等无法侦测的参数,如肺内死腔(dead space )体积,但是这种仪器所管流中,通常以孔口板(Orifice)来限制流体流动,

stone canal：石管

环管于一间步带处向反口面伸出一石管(stone canal)(位于轴器内),管壁内有石灰质环,故较硬,管末端连于筛板,与外界相通. 筛板为一圆形小骨板,其上有许多辐射排列的小沟纹,沟底有许多小孔(约200个). 环管上间步带处各具一对帖德曼氏体(Tiedmann's body,

endostoma：内口板

endosteum /骨内膜/ | endostoma /内口板/ | endostome /内珠孔/

gonotome：生殖节

生殖腺是由体节与侧板相接处的体腔壁突起形成的,此处也称为生殖节(gonotome). 4.内胚层:形成原肠及其衍生物. 在身体前端(与原口相对的一端)原肠向外突出,与外胚层的内陷相遇穿孔形成口,即后口,或次口(deuterostome).

porose area：孔区

雌蜱的假头基背面有1对孔区(porose area),在产卵时 其分泌物附在卵表面起抑制氧化作用. 口下板的逆齿较发达. 须肢第1节非常短;第2、3节较长,形状各异;末节短小,嵌生于第3节腹面亚前端的小凹陷内,其顶端有感觉毛. 各节活动均不灵活.