共模电压

词组短语

common-mode voltage

与共模电压相关的网络例句 [注：此内容来源于网络，仅供参考]

Also in this paper, the magnitude of the common-mode voltage of the system is analyzed and the method of choosing reasonable zero-vectors to restrain the common-mode voltage is presented.

详细分析了基于该控制策略的电机共模电压大小，提出了合理选用零矢量以降低电机共模电压幅值的方法。

The results show that multilevel carrier arithmetic can efficiently reduce common-mode voltage,harmonic and the changing rate of output voltage.

仿真结果表明，多载波控制算法能够有效降低共模电压、谐波含量以及输出电压的变化率。

A channel-to-channel voltage rating and a common-mode voltage rating of at least 500V is desirable.

通道－通道电压额定值和共模电压额定值至少为500 V才是合理的。

A novel inverter output passive filter, which can not only reduce differential-mode dv/dt but also suppress common-mode voltage, is proposed.

提出了一种新颖的可以同时降低差模dv/dt和共模电压的逆变器输出无源滤波器。

The common-mode voltage range limits the allowable voltage swing on each input with respect to the measurement system ground.

共模电压抑制了每个相对测量系统地线输入端电压的允许波动范围。

Then,the paper analyzes common-mode voltage and output voltage range of operational amplifier influenced by temperature and process problems that may appea.

基于混沌、均匀分布的真随机数发生器的工作电路和精度要求较高的电压参考电路的温度漂移进行分析，给出了仿真得到的温度曲线；分析了工艺中可能存在的问题和温度的影响与运放的共模电压和输出电压幅度，以及与混沌公式直接相关的开关电容等，根据最坏分析得到混沌公式，给出了仿真测试结果。

Parameter Supply Voltages Positive Supply Voltage Negative Supply Voltage Logic Supply Voltage Ground Voltage Differential Input Voltages Input Common-Mode Voltage Differential Input Voltage Input Voltage, Latch Controls Output Output Current Temperature Operating Temperature, Ambient Operating Temperature, Junction Storage Temperature Range

参数电源电压正电源电压负电源电压逻辑电源电压接地电压差分输入电压的输入共模电压差动输入电压输入电压，输出电流输出锁存器控制温度工作温度，环境温度，联合贮藏温度范围

However, this modulation mode would not prevent the injection of DC current into the grid.

在双极性脉宽调制方式下，全桥逆变器的共模电压恒定，不产生共模电流。

For improve altogether mould inhibit than,in before the high altogether mould inhibit output altogether mould voltage feedback to shouldering by ends public of power also among the amplifiers than instrument in grade, make it put power voltage until mould input voltage float , setover voltage follow mould inputs the voltage into together very much each altogether not to transport, thus improved together mould inhibit to.

为提高共模抑制比，在前级高共模抑制比仪器放大器中还将输出共模电压反馈到正负电源的公共端，使运放电源电压随共模输入电压浮动，各极偏置电压都跟踪共模输入电压，从而提高了共模抑制比。

Here, the shunt DEVICE 's function is to protect the PORT from differential surges, a differential surge will be balanced between conductors by the shunting DEVICE , converted to common mode. The isolation provides protection from the common mode transient remaining.

图中，分流器的功能是保护接口的浪涌差，即分流器件使得浪涌差转换成共模电压而维持导线间的平衡；而隔离则持续提供共模transient保护。

与共模电压相关的网络解释 [注：此内容来源于网络，仅供参考]

bias current：偏置电流

会因为使用单位增益的差动放大器做为输出级而导致输入共模电压范围受到大幅限制,如何解决?[答:ADI专家] 简单地说,输入端的误差源会考虑失调电压(offset voltage)和偏置电流(bias current). 他们对输出电压的影响都是要乘以增益的.

brownout：电压不足

本文将介绍在短暂的电压不足(brownout)期间,电信设备如何继续保持正常的工作. 首先,设计工程师必须了解电信设备专用电源的一些细节. 对电信设备馈电电源的共模电压为 –48V,尽管实际上的电压范围可能是 –42.5 至 –56V、 –40 至 –60V,

common network：公共网络

common mode voltage | 共模电压 | common network | 公共网络 | common normal line | 公法线

common mode rejection ratio：共模拒拆比

common-mode rejection 共模拒拆 | common-mode rejection ratio 共模拒拆比 | common-mode rejection voltage 共模拒拆电压

common mode rejection ratio：共态抑制比

common mode noise 共模噪音 | common mode rejection ratio 共态抑制比 | common mode voltage 共模电压

common-mode voltage amplification：共态电压放大

common-mode voltage 共模电压 | common-mode voltage amplification 共态电压放大 | communality 公比

Vcm common-mode Voltage：(共模电压)

Voltage swing 电压摆动,电压摆幅 | Vcm common-mode Voltage(共模电压) | noninverting terminal 非反向端

input common-mode voltage swing：共模输入电压幅度

input common-mode rejection ratio 输入共模抑制比 | input common-mode voltage swing 共模输入电压幅度 | input converter 输入转换器

overcurrent：过流

例如,几乎任何低压轨到轨输入运算放大器都能检测出升压,这说明了有过流(overcurrent)流过了连接负载与地的电阻. 为了在高侧完成相同的操作,人们一般选择能承受较高共模电压的差分放大器. 这种方法限制了输入放大器的选择范围,

undervoltage：欠压

使得共模电压在动态范围上的问题电源管理 具有抛负载(Load-Dump)保护的高输出电压低压降稳压器上电复位及欠压(undervoltage)复位直接连接至汽车电池,