- 更多网络例句与充电容量相关的网络例句 [注：此内容来源于网络，仅供参考]
-
Its capacity of charge-discharge was very high, and its stability of cycling scanning and charge-discharge was very choiceness.
高温下(55℃)，其首次充电容量为194mAh·g~(-1)，放电容量为174mAh·g~(-1)：经9次充放电循环后，其充电容量为193mAh·g~(-1)，放电容量为151mAh·g~(-1)。
-
Studied the inner resistance in different charge capacity and different charge magnification, researched the charge efficiency in different charge capacity, and measured the inner resistance at high rate.
通过对失效电池不同充电容量、充电倍率下交流内阻的研究和大电流脉冲下直流内阻的研究，确定了快速判定MH-Ni电池是否失效的相关方法，并通过测量电池的内压和不同充电容量下的充电效率讨论了其有效性
-
L Automatic stop function: Protection voltage, charge capacity and charge time of battery can be set.
l 自动停机功能：可设定电池组保护电压、充电容量、充电时长等参数，在下列条件任意一条满足时自动停止充电：电压到、容量到、时间到。
-
Through X-ray photoemission spectrum, the binding of 516.4 and 523.1 eV can he attributed to the V(superscript 4+ subscript 2p3/2) and V(superscript 4+ subscript 2p1/2),, which confirm the quadrivalent slate of V ion in Li0.8V0.8O2. With a current density of 7.4 mA/g, the charge capacity of Li0.86V0.8O2 is 163 mAh/g in the first cycle, and the first discharge capacity of the materials is 113 mAh/g. After 20th cycles, the discharge capacity is still 80 mAh/g, which show good electrochemicalstbility.
在电流密度为7.4mA/g的充放电中，Li0.86v0.8O2初始充电容量达到163mAh/g，首次放电容量也能达到113mAh/g，20次循环后放电容量仍然可以达到80mAh/g，表现出较好的循环性能。
-
Battery recalibration required to optimize charge capacity.
为使电池的充电容量最优化，需对其进行重新校准。
-
In this paper,the discharge capacity,stability voltage and the ratio of constant current charge capacity and battery discharge capacity of lithium ion battery were studied. For the lithium manganese lithium-ion batteries,the discharge capacity,mid-value voltage and stability voltage all increased with increasing charge cutoff voltage. As long as charge cutoff voltage was no less than 4.15 V,the battery discharge capacity loss would not exceed 6%. When charge cutoff voltage was 4.15V,the constant current charge capacity accounted for more than 85% of total charge capacity,a little change from 4.20 V.
主要研究了不同截止电压对锰酸锂离子电池的放电容量性能、工作电压和恒流/恒压充电容量等电池性能的影响，结果表明：对于锰酸锂材料锂离子电池，放电容量、中值电压和稳定电压都随着充电截止电压的升高而提高，电池的充电截止电压只要不低于4.15 V，电池放电容量损失就不会超过6%；当充电截止电压为4.15 V时，电池的恒流充电容量占总充电容量的85%以上，与4.20 V相比变化不大。
-
L Intelligent three-phase charge mode: We adopt constant current technology at the beginning of charge, which can made current invariable and avoid battery broken or accelerating battery aging. It can convert to constant- voltage and current-limiting charge when charge voltage achieves upper limit voltage, which can improve effectively the capacity conversion efficiency of battery. Trickle and floating charge make each single cell battery constant receive electricity and ensure battery capacity can be recall most, which solved the unbalanced phenomenon of single cell battery and avoid the danger of voltage change and the end of battery charge, extend battery life.
l 智能三阶段充电模式：充电初期采用恒流技术，使充电电流恒定，避免损坏电池，加速电池的老化；充电电压达到上限电压时自动转换为恒压限流充电，有效的提高了蓄电池的容量转换效率；涓流浮充使各单体电池均衡受电，保证电池容量得以最大限度恢复，有效解决单体电压不均衡现象，避免了市电电压的变化和蓄电池充电的末期造成的蓄电池过压充电的危险，大大延长了蓄电池的使用寿命。
-
Trickle and floating charge can make each single cell battery receiving electricity constant, ensure batteries capacity resuming maximum, settle the disproportion phenomenon of single cell battery, avoid the overvoltage charge danger of the power voltage change and the end of battery charge and extend the operational life of battery.
61548；完善的充电特性：采用恒流技术，充电初期电流恒定，使每节电池都能较快地充分地充满电，充电效率高，电池温升小；在充电电压达到上限电压时自动切换到恒压限流充电，有效的提高了蓄电池的容量转换效率；涓流浮充使各单体电池均衡受电，保证电池容量得以最大限度恢复，有效解决单体电压不均衡现象，避免了市电电压的变化和蓄电池充电的末期造成的蓄电池过压充电的危险，大大延长了蓄电池的使用寿命。
-
Micrometres of synthetic porous spherical particle shape and the LiMn2O4 preliminary electrochemical performance test results showed that in 25 degrees, porous balls and particles LiMn2O4 batteries in high-voltage areas (4V), the first charge and 112mAh/g 123mAh/g capacity respectively, 112mAh/g 123mAh/g and discharge capacity respectively.
对所合成的微米级多孔球状和粒子状的LiMn2O4进行初步电化学性能测试，测试结果表明，在25℃下，多孔球的和粒子的LiMn2O4电池在高电压区（4V），首次充电容量分别为123mAh/g和112mAh/g，放电容量分别为123mAh/g和112mAh/g。
-
19Mm.扫频结束后测蓄电池最终状态,观察电池外观变化 5 Note: The definitions of some nomenclatures of this specification (1) standard charge: 0.3C5A charge at 20℃±5℃ to the limit voltage, then change to charge with constant voltage till the current less than or equal to
备注：以上标准中的一些术语的定义：(1)标准充电：在环境温度 20℃±5℃的条件下，以 0.3C5A 充电，当电池端电压达到充电限制电压时，改为恒压充电，直到充电电流小于或等于 0.02C5A 后停止充电(2)剩余容量：电池经过特定的检测程序后的首次放电容量。
- 更多网络解释与充电容量相关的网络解释 [注：此内容来源于网络，仅供参考]
-
accumulator cell：蓄电池单元
accumulator capacity 蓄电池容量 | accumulator cell 蓄电池单元 | accumulator charge 蓄电池充电
-
ramp up：缓慢上升
●采用负电压(-deltaV),零电压(0deltaV),最大电压(Vmax),温度(Tmax),最大温升(Total deltaT),温升率(deltaT)等多种判断条件,在高度安全的条件下保证电池完全充饱●开始充电时采用电流缓慢上升(ramp up)的方法,增加电池容量和循环寿命
-
treat：对待
官方资料称8700G将会配备容量为1100毫安时的锂电池,在一般强度的使用(Use)上可以待机三天,加上支持USB直接充电,对待(Treat)事务繁忙的商务人士而言可以随时连接数据线为手机充电.
-
epicyclic gear：行星齿轮
发电用和驱动用两个马达中嵌入了采用动力分割结构的行星齿轮(Epicyclic Gear). 仅依靠马达的行驶距离较长,镍氢充电电池的容量也达到1.3kWh,是Insight的2倍以上. 由于动力源多、控制变量(Control Variable)大,软件开发成本也较高.
-
battery booster：充电调压器
battery backup module ==> 电池备用组件 | battery booster ==> 充电调压器 | battery capacity ==> 蓄电池容量
-
gas recombination by catalyser type：触媒气体复合式
initial capacity 初始容量 | gas recombination by catalyser type 触媒气体复合式 | initialcharge 初始充电
-
drive shaft tunnel：传动轴通道
配备容量为24kWh(可使用容量为22.4kWh)的锂离子充电电池,利用230V?16A的普通电源时,可在8小时内充满电. 续航距离为150km. 充电电池的重量为280kg,而且与发动机车型的燃料罐一样,配置在传动轴通道(Drive Shaft Tunnel)附近.