- 更多网络例句与使均匀相关的网络例句 [注：此内容来源于网络，仅供参考]
-
When used carburization and tempering, filling baskets should be designed according to different parts of horizontal
当用于渗碳及回火时，装料筐设计应根据不同工件设计横向和纵向气道，使碳势气氛和热风能均匀通过工件每一点，使工件渗碳层或回火均匀。
-
The company uses the advanced output controllable technology, with the face milling material set the suitable miller, change the traditional surface contact into line contact, make the output granularity evener, high product, widely used in chemical industry, metallurgy, glassed industry, and the high rquirement of the evenness for milling after milling, sand making of building sand in recent years.
公司采用先进的可控进出料技术，结合实际的研磨物料应配用合适的研磨体，以传统的面接触改为线接触，使出料粒度更为均匀，产量更高，广泛使用于耐材、化工、冶金、玻璃等行业对磨后成品均匀度要求比较高的研磨作业，近年来还用于建筑用砂的制砂行业等。
-
In the homogeneous model, the function of tendons is assumed to be uniform in some approximated way in order to form an equivalent homogeneous material within concrete. The formulation of the homogeneous model is same with that of general FEM for common continuum, let alone the elastic matrix being resultant of that of tendon and concrete. The computation is simple, but the approximate assumption makes this method cannot be generalized, because it only represents the constitution and function of tendons in such a rough way, that the numerical results are inaccurate. In the combined model, the function of tendon is considered by the stiffness matrix with rod element, then add it into the stiffness matrix of concrete by a rational way.
均匀类单元是设想将钢筋均匀弥散于整个单元中，使其成为一种连续均匀材料单元，这种单元的与一般有限元的单元刚度矩阵推导过程一样，只不过其弹性矩阵由混凝土和钢筋两部迭加而成的，此类单元刚阵计算简明而又不会扩大计算规模，但均匀弥散只是为计算简单而作一种假想，不贴近单元构造实际，也不符合实际作用效果。
-
The deformation mechanism is mainly the single-slip and cross-ship, the fracture mechanism is mainly the congregation of transgranular micro-hole, and large uniform deformation occurred before tough fracture, and therefore, the ability of plastic deformation and the mechanical properties of the material were remarkably improved. These fully indicate that the new melt-treatment developed in this work is an effective and advanced technique, and further testify that the improvement of metallurgical quality of the material is the key to enhance its mechanical properties, especially its plastic deformation performance. The results of tensile and compression tests at elevated temperature also indicate that the suitable hot-working temperature range is 400～450℃. 4. A steady-state plastic flow exists during the plastic deformation of the aluminum sheet used for pressure can at elevated temperature. A hyperbolic sine relationship can be satisfied between the steady-state flow stress and strain rate by introducing an Arrhenius term which involves some thermal activation parameters, i.
压力罐用铝材中的主要冶金缺陷为Al〓O〓夹杂物、气孔及富Fe杂质相；高效熔体处理显著改善了材料的冶金缺陷的存在形态，使含杂量明显减少、夹杂物尺寸变细小且分布均匀，富Fe杂质相变为细小、分布均匀的团球状或短棒状的复杂化合物，同时也明显细化了结晶组织；此外，由于高效熔体处理有效地减少了材料中裂纹萌生源数量，因而改变了材料的塑性变形微观过程及断裂方式，主要以单滑移和交滑移进行塑性变形，断裂方式为穿晶微孔聚集型，韧性断裂前产生了大量的均匀变形，不易出现变形失稳，从而显著提高了罐用铝材的塑变能力和力学性能。
-
Because of randomness of presetting the address matrix between the input and hidden layers, SDM produces unfavorable consequences for classification when handling unevenly distributed patterns. And its learning mode of outer product results in poor nonlinear mapping ability.
然而由于地址矩阵的均匀预置方式，使其在处理现实的非均匀分布时效果不佳；并且它的外积法学习方式使其表达非线性映射的能力不强。
-
Through the experiments on hydration of AH in the following sulphate（Li_2SO_4、MgSO_4 、 Al_2(SO_4)_3 、MnSO_4 、CuSO_4 、CoSO4 、CdSO_4 、ZnSO_4 、NiSO_4 、FeSO_4）, dissoluble sulfate hydrate origining from hydration process of AH affects it's hydrous rate, hydrous rate of AH does not connect with Z/R of cation in stimulation, theory that Z/R affect hydrous rate of AH does not exist. Third, hydration of AH in dissoluble sulfate complies with dissolve-nucleate -grow theory, concentration of Ca~2+ from dissolving of CaSO_4 is higher than one of CaSO_4·2H_2O, calcium sulphate dihydrite gets a motivity of crystallization. dissoluble sulfate takes the following function: double-salt or dissoluble sulfate hydrate from hydration of AH in it becomes heterogeneous particle and a kind of nucleation catalyzer, and reduces surface barrier when DH becomes crystal because the crystal of DH precedently appears in uneven place. Results indicate hydration of AH does not conform with double-salt theory, but it conform with this mechanism: dissolve-nucleate-grow, formation of DH is an uneven nucleation and crystalizaion process.
通过对CaSO_4在Na_2SO_4 、K_2SO_4 、Rb_2SO_4 、Cs_2SO_4 、(NH_4)_2SO_4溶液中水化过程，以及CaSO_4·2H_2O、CaSO_4与以上硫酸盐反应速度、产物的研究，说明复盐理论不正确；CaSO_4在（Li_2SO_4、MgSO_4 、 Al_2(SO_4)_3 、MnSO_4 、CuSO_4 、CoSO_4 、CdSO_4 、ZnSO_4 、NiSO_4 、FeSO_4）溶液中水化，水化过程中硫酸盐水合物的析晶影响着无水硫酸钙水化，与激发剂阳离子Z/R值大小无关，阳离子的Z/R参数影响水化率的规律并不存在； 3、无水硫酸钙在可溶性硫酸盐中的水化按照溶解-成核-生长理论进行，CaSO_4达到溶解平衡时Ca~2+的浓度大于CaSO_4·2H_2O溶解平衡的Ca~2+的浓度，CaSO_4·2H_2O获得结晶的驱动力，可溶性硫酸盐起到形成晶核的作用：水化过程与CaSO_4生成复盐或析出水合物所形成的细小物相，作为异质微粒使母相中存在不均匀性，这些不均匀性有效地降低成核时的表面能位垒，使CaSO_4·2H_2O晶核优先地在这些具不均匀性的地方形成，因此这些物质起成核催化剂作用。
-
Grout must be supplemented in time to ensure the gap between soil and pipe to be stuffed.
注浆工艺的合理性对管道顶进施工的顺利实施有重要的意义，并就注浆工艺的改进提出了以下要点：及时补充压浆，力求使地层与管道结构间的缝隙始终由浆液密实充填；及时调整注浆压力，力求使其与管段所在位置的水土压力值相等；注浆孔在管段横剖面上均匀布设，以使注浆压力沿管道周边均匀分布；对位于顶进管道前端的数节管段，宜每节都设注浆孔，使可及时注浆和补浆。
-
X-ray thin film method and its derivative techniques have lots of superiorities: larger irradiated surface area, higher diffracted intensities, better monochromic and parallel X-ray beam, higher resolution, and easier operation procedure.
In或Al含量的增加，将使立方相InGaN(002)和{113}衍射峰宽化，使六角相InGaN和AlGaN、立方相InGaN外延层垂直方向和水平方向的均匀应变增加，固溶体晶粒尺寸细化，非均匀应变增加。
-
The paper make an intensive study of the key link in spinning mill ── the quality test and production control using capacity evenness tester which is presented by USTER TESTER, covering the analysis of relevant test results and practical application for the evenness test,the spectrogram types,the calculation of the weave length showed on a spectrogram and caused by mechanical faults,the determination and control of the evenness indexes,as well as the requirement and the plan for spinning quality control.
摘 要：探讨了纺纱质量测控的中心环节──使用以USTER TESTER为代表的电容式条干均匀度仪器测定条干均匀度时的结果分析及实际应用。其中涉及电容式条干均匀度仪的测试结果分析及应用、波谱图的分析及应用、设备的机械问题在波谱图上所造成的不匀波长的计算、纺纱条干均匀度指标及控制、纺纱质量控制方案及要求等几个方面的内容。
-
In spite of "endless talk of difference," American society is an amazing machine for homogenizing people.
竟管区别。。endless 谈话，。。美国社会是一个令人惊讶的机器为使均匀的人民。
- 更多网络解释与使均匀相关的网络解释 [注：此内容来源于网络，仅供参考]
-
homogenize: to blend into a uniform mixture：使均匀
hive: a place swarming with activity 闹市 | homogenize: to blend into a uniform mixture使均匀 | ichthyologist: 鱼类学者,研究者
-
streaky crumb：气孔不均匀的面包瓤
streaky bread 松软不匀的面包(面包瓤微孔不均匀) | streaky crumb 气孔不均匀的面包瓤 | stream 水流;使流出
-
equalisation：使均等/同等化
equably /均等地/均一地/均匀地/ | equalisation /使均等/同等化/ | equalise /使相等/使平等/使均一/
-
homily：说教,训诫
homely家常的,朴素的a | homily说教,训诫n | homogenize使均匀v
-
homogenesis：纯一发生 (名)
homogeneous 同种的, 均质的, 同质的 (形) | homogenesis 纯一发生 (名) | homogenize 使均匀 (动)
-
homogenization temperature：均化温度
homogenization of thrombus 血栓同质化 | homogenization temperature 均化温度 | homogenize 均化,匀化,使均匀=>均質
-
homogenize：使均匀
homily说教,训诫n | homogenize使均匀v | homogeneous同类的
-
plasmatic stain ;plasmic stain：胞质染剂:使组织完全均匀着色的染剂
neutral stain 中性染剂:酸性染剂和碱性染剂的复合物,用来染嗜中性组织 | nuclear stain 核染剂:对细胞核有亲和力的染剂 | plasmatic stain ;plasmic stain 胞质染剂:使组织完全均匀着色的染剂
-
uniformize：使均匀化,均质化
uniformizaiton均匀化 | uniformize使均匀化,均质化 | non-uniform scale 不均匀刻度
-
uniformize：使均匀;均质化
uniformization 均匀化 | uniformize 使均匀;均质化 | unilayer 单(分子)层